journal article·2014-04Open access

Variation-based design of an AM demodulator in a printed complementary organic technology

S. Abdinia, F. Torricelli, G. Maiellaro, R. Coppard, A. Daami, S. Jacob, L. Mariucci, G. Palmisano, E. Ragonese, F. Tramontana, A.H.M. van Roermund, E. Cantatore

Organic Electronics· Volume 15· Issue 4

Abstract

In this work, the design of a high-frequency AM demodulator in a printed complementary organic technology is presented. The behaviour and the variability of printed circuits are predicted by means of accurate transistor modelling, statistical characterization, and Monte Carlo simulations. The effectiveness of the design approach is readily verified by comparing measurements and simulations of simple digital blocks as well as two differential amplifiers. These amplifiers can be used as continuous-time comparators in the demodulator. In addition, the possibility of high-frequency rectification using the printed organic TFTs is shown by providing the experimental results of an envelope detector measured under different load and input conditions. All the measurements are performed in air. Finally, the simulation of a complete AM demodulator system including the measured blocks is demonstrated. © 2014 Elsevier B.V. All rights reserved.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Conducting polymers and applications · Advanced Sensor and Energy Harvesting Materials · Organic Electronics and Photovoltaics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. A 13.56MHz RFID system based on organic transponders10.1109/JSSC.2006.886556 ↗
2. Organic RFID transponder chip with data rate compatible with electronic product coding10.1016/j.orgel.2010.04.013 ↗
3. Stretchable organic integrated circuits for large-area electronic skin surfaces10.1557/mrs.2012.42 ↗
4. A flexible lightweight Braille sheet display with plastic actuators driven by an organic field-effect transistor active matrix
5. Analog techniques for reliable organic circuit design on foil applied to an 18dB single-stage differential amplifier10.1016/j.orgel.2010.05.006 ↗
6. Influence of transistor parameters on the noise margin of organic digital circuits10.1109/TED.2006.870876 ↗
7. Unipolar organic transistor circuits made robust by dual-gate technology10.1109/JSSC.2011.2116490 ↗
8. A stretchable EMI measurement sheet with 8×8 coil array, 2V organic CMOS decoder, and 70dBm EMI detection circuits in 0.18m CMOS
9. Organic CMOS circuits for RFID applications
10. Fully printed integrated circuits from solution processable polymers10.1063/1.1767291 ↗
11. Printed organic transistors: toward ambient electronics
12. Printable electronics for polymer RFID applications
13. Fully printed organic CMOS technology on plastic substrates for digital and analog applications
14. High-gain fully-printed organic complementary circuits on flexible plastic foils10.1109/TED.2011.2162071 ↗
15. Pentacene-based radio-frequency identification circuitry10.1063/1.1579554 ↗
16. 50MHz rectifier based on an organic diode10.1038/nmat1434 ↗
17. An integrated double half-wave organic Schottky diode rectifier on foil operating at 13.56MHz10.1063/1.2978348 ↗
18. F. Torricelli, E. Cantatore, A. Valleta, S. Jacob, M. Benwadih, M. Coppard, G. Fortunato, M. Rapisadra, L. Mariucci, Physically-based compact model of staggered p- and n-type organic thin-film transistors, in: Proc. of Int. Thin-Film Transistor Conf. 2012, pp. 116.
19. A charge control analytical model for organic thin film transistors10.1063/1.2898400 ↗
20. A charge-based OTFT model for circuit simulation10.1109/TED.2008.2007717 ↗
21. Charge transport in organic transistors accounting for a wide distribution of carrier energies—Part II: TFT modeling10.1109/TED.2012.2184764 ↗
22. Organic thin-film transistors: Part I-compact DC modeling10.1109/TED.2009.2033308 ↗
23. Analysis of contact effects in fully printed p-channel organic thin film transistors10.1016/j.orgel.2012.06.003 ↗
24. Current spreading effects in fully printed p-channel organic thin film transistors with Schottky source-drain contacts10.1016/j.orgel.2012.10.002 ↗
25. Contact effects in high performance fully printed p-channel organic thin film transistors10.1063/1.3669701 ↗
26. S. Jacob, M. Benwadih, J. Bablet, I. Chartier, R. Gwoziecki, S. Abdinia, E. Cantatore, L. Maddiona, F. Tramontana, G. Maiellaro, L. Mariucci, G. Palmisano, R. Coppard, High performance printed n and p-type OTFTs for complementary circuits on plastic substrate, in: Proc. of the European solid-state device research conference 2012, pp. 173–176.10.1109/ESSDERC.2012.6343361 ↗
27. S. Abdinia, M. Benwadih, E. Cantatore, I. Chartier, S. Jacob, L. Maddiona, G. Maiellaro, L. Mariucci, G. Palmisano, M. Rapisarda, F. Tramontana, A.H.M. van Roermund, Design of analog and digital building blocks in a fully printed complementary organic technology, in: Proc. of the European Solid-State Circuits Conf. 2012, pp. 145–148.10.1109/ESSCIRC.2012.6341310 ↗
28. High-gain operational transconductance amplifiers in a printed complementary organic TFT technology on flexible foil
29. Bidirectional communication in an HF hybrid organic/solution-processed metal-oxide RFID tag