Burn Rate of Calcium Sulfate Dihydrate–Aluminum Thermites

The energetics of cast calcium sulfate dihydrate–aluminum thermites were investigated. The casts were prepared from water slurries with a solids content below 65 wt %. The base case thermite comprised 60 wt % calcium sulfate dihydrate as the oxidizer with 40 wt % aluminum as fuel. The heat of hydration of the base case was 83 ± 4 kJ·kg–1 (dihydrate basis) and the initial setting time was about 100 min. The compressive strength reached 2.9 ± 0.2 MPa after 3 days of drying in ambient air. The open air burn rate was 12.0 ± 1.6 mm· s–1 and a maximum surface temperature of 1370 ± 64 °C was recorded with a pyrometer. Bomb calorimetry indicated an energy output of 8.0 ± 1.1 MJ·kg–1, slightly lower than predicted by the Ekvi thermodynamic simulation. Substitution of 10 wt % of the oxidant with copper sulfate pentahydrate significantly decreased the initial setting time of the casts to less than 30 min but a secondary aluminum oxidation reaction commenced after 2 h. The density of the castings was varied by either adding hollow sodium borosilicate microspheres or by adding excess water during the casting process. The addition of the hollow glass microspheres caused a decrease in the burning rate. Dehydration of the casts by thermal treatments at either 155 or 200 °C led to significant increases in the burning rate.