Speciation and Proton Conductivity of Phosphoric Acid Confined in Mesoporous Silica

Phosphoric acid (PA) confined in a commercial mesoporous silica (CARIACT G) with porous size in the range of 3 to 10 nm was studied in relation to its coordination with the silanol groups on the silica surface as a function of temperature, up to 180 °C, using 31P and 29Si MAS NMR spectroscopy. As the temperature increases, the coordination of Si and P in the mesopores depends on the pore size, that is, on the area/volume ratio of the silica matrix. In the mesoporous silica with the higher pore size (10 nm), a considerable fraction of PA is nonbonded to the silanol groups on the surface, and it seems to be responsible for its higher conductivity at temperatures above 120 °C as compared to the samples with a smaller pore size. The electrical conductivity of the functionalized mesoporous silica was higher than that reported for other silico-phosphoric composites synthesized by sol–gel methods using soft templates, which require high-temperature calcination and high-cost reagents and are close to that of the best PA-doped polybenzimidazole membranes used in high-temperature proton exchange membrane fuel cells (HT-PEMFCs). The rate of PA release from the mesoporous silica matrix when the system is exposed to water has been measured, and it was found to be strongly dependent on the pore size. The low cost and simplicity of the PA-functionalized mesoporous silica preparation method makes this material a promising candidate to be used as an electrolyte in HT-PEMFCs.