Ultrabright Pdots with a Large Absorbance Cross Section and High Quantum Yield

Semiconducting polymer dots (Pdots) are increasingly used in biomedical applications due to their extreme single-particle brightness, which results from their large absorption cross section (σ). However, the quantum yield (Φ) of Pdots is typically below 40% due to aggregation-induced self-quenching. One approach to reducing self-quenching is to use FRET between the donor (D) and acceptor (A) groups within a Pdot; however, Φ values of FRET-based Pdots remain low. Here, we demonstrate an approach to achieve ultrabright FRET-based Pdots with simultaneously high σ and Φ. The importance of self-quenching was revealed in a non-FRET Pdot: adding 30 mol % of a nonabsorbing polyphenyl to a poly(9,9-dioctylfluorene) (PFO) Pdot increased Φ from 13.4 to 71.2%, yielding an ultrabright blue-emitting Pdot. We optimized the brightness of FRET-based Pdots by exploring different D/A combinations and ratios with PFO and poly[(9,9-dioctylfluorenyl-2,7-diyl)-co-(1,4-phenylene)] (PFP) as donor polymers and poly[(9,9-dioctyl-2,7-divinylenefluorenylene)-alt-co-(1,4-phenylene)] (PFPV) and poly[(9,9-dioctylfluorenyl-2,7-diyl)-alt-co-(1,4-benzo-{2,1′,3}-thiadiazole)] (PFBT) as acceptor polymers, with a fixed concentration of poly(styrene-co-maleic anhydride) as surfactant polymer. Ultrabright blue-emitting Pdots possessing high Φ (73.1%) and σ (σR = σabs/σall, 97.5%) were achieved using PFP/PFPV Pdots at a low acceptor content (A/[D + A], 2.5 mol %). PFP/PFPV Pdots were 1.8 times as bright as PFO/PFPV Pdots due to greater coverage of acceptor absorbance by donor emission─a factor often overlooked in D/A pair selection. Ultrabright green-emitting PFO Pdots (Φ = 76.0%, σR = 92.5%) were obtained by selecting an acceptor (PFBT) with greater spectral overlap with PFO. Ultrabright red-emitting Pdots (Φ = 64.2%, σR = 91.0%) were achieved by blending PFO, PFBT, and PFTBT to create a cascade FRET Pdot at a D:A1:A2 molar ratio of 61:5:1. These blue, green, and red Pdots are among the brightest Pdots reported. This approach of using a small, optimized amount of FRET acceptor polymer with a large donor–acceptor spectral overlap can be generalized to produce ultrabright Pdots with emissions that span the visible spectrum.