journal article·2022-06

Plasma-activated GaAs/Si wafer bonding with high mechanical strength and electrical conductivity

Yongqiang Zhao, Wen Liu, Yidi Bao, Fuhua Yang, Xiaodong Wang

Publisher page

Abstract

Bonded GaAs/Si heterojunctions with high mechanical strength and electrical conductivity are important for low-cost photovoltaics and silicon-based photonics. In this work, we successfully achieved wafer-based (2 in.) GaAs/Si direct bonding structures with high strength by using the plasma-activated bonding (PAB) method. The bonding strength can be close to that of the GaAs/Si samples bonded by the surface-activated bonding method. It is found that the surface roughness and height of GaAs wafers have a greater influence on the bonding strength than Si wafers. More importantly, an ohmic n-GaAs/n-Si interface even with a low doping concentration of wafers was realized. Investigations reveal that the Ar plasma-induced damage in GaAs could be controlled at a significantly low level by using the PAB method. An thin amorphous layer existed between GaAs/Si interface, and no obvious cracks or voids were observed. Our results may provide a promising way to fabricate GaAs/Si heterojunctions for optoelectronic devices.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: 3D IC and TSV technologies · Electrostatic Discharge in Electronics · Integrated Circuits and Semiconductor Failure Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (23)

Show source-provided references
1. Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26%10.1038/nenergy.2017.32 ↗
2. Detailed balance limit of efficiency of p-n junction solar cells10.1063/1.1736034 ↗
3. Silicon wafer-based tandem cells: The ultimate photovoltaic solution?
4. Current-matched triple-junction solar cell reaching 41.1% conversion efficiency under concentrated sunlight10.1063/1.3148341 ↗
5. Six-junction III–V solar cells with 47.1% conversion efficiency under 143 Suns concentration10.1038/s41560-020-0598-5 ↗
6. Design of AlxGa1xAs/GaAs/InyGa1yAs triple junction solar cells with anti-reflective coating10.1016/j.mssp.2015.01.020 ↗
7. 14.5% conversion efficiency GaAs solar cell fabricated on Si substrates10.1063/1.97245 ↗
8. Gallium arsenide and other compound semiconductors on silicon10.1063/1.346284 ↗
9. Electrical properties of wafer-bonded GaAs/Si heterojunctions10.1063/1.122454 ↗
10. III-V/Si hybrid photonic devices by direct fusion bonding10.1038/srep00349 ↗
11. Wafer direct bonding of compound semiconductors and silicon at room temperature by the surface activated bonding method10.1016/S0169-4332(97)80187-0 ↗
12. Direct wafer bonding methods: A practical process selection guide10.1149/09804.0033ecst ↗
13. Fast atom beam activated wafer bonds between n-Si and n-GaAs with low resistance10.1149/2.031309jss ↗
14. Two-terminal direct wafer-bonded GaInP/AlGaAs//Si triple-junction solar cell with AM1. 5g efficiency of 34.1%10.1002/solr.202000210 ↗
15. Intrinsic microstructure of Si/GaAs heterointerfaces fabricated by surface-activated bonding at room temperature10.7567/JJAP.57.02BA01 ↗
16. Gaas solar cell on si substrate with good ohmic GaAs/Si interface by direct wafer bonding10.1016/j.solmat.2015.06.021 ↗
17. III–V-on-silicon solar cells reaching 33% photoconversion efficiency in two-terminal configuration10.1038/s41560-018-0125-0 ↗
18. Study of the properties of SiOx layers prepared by different techniques for rear side passivation in TOPCon solar cells
19. Direct wafer bonding of GaAs/Si by hydrophobic plasma-activated bonding
20. The effect of surface roughness on direct wafer bonding10.1063/1.369377 ↗
21. Investigation on the interface resistance of Si/GaAs heterojunctions fabricated by surface-activated bonding10.7567/JJAP.54.030211 ↗
22. Bonding of silicon wafers for silicon-on-insulator10.1063/1.342443 ↗
23. Semiconductor wafer bonding: recent developments10.1016/0254-0584(94)90080-9 ↗