journal article·2021-01

Effect of phase structures and substrate temperatures on NTC characteristics of Cu-modified Ba–Bi–O-based perovskite-type thermistor thin films

Jing-Jing Qu, Sheng Li, Fei Liu, Xiao Liu, Ze-Xing Chen, Chang-Lai Yuan, Xin-Yu Liu, Yun-Yun Zhao, De-Jian Zhou

Publisher page

Abstract

Abstract Based on the formula of BaBi0·92Cu0·08O3, Cu-modified Ba–Bi–O-based perovskite-like negative temperature coefficient (NTC) thermistor thin films were successfully prepared by radio frequency (RF) magnetron sputtering method with the various deposition temperatures (25 °C, 100 °C, 200 °C and 250 °C). The effects of the substrate temperatures on the phase structures and electrical properties were respectively characterized and investigated by X-ray diffraction (XRD), resistance-temperature measurement, and complex impedance analysis for the Ba–Bi–O-based thin films. Additionally, the cross-sectional microstructures and grain morphologies of the BaBi0·92Cu0·08O3 thin films were analyzed by scanning electron microscope (SEM) and atomic force microscope (AFM). The XRD patterns results showed that the perovskite monoclinic structure with a small amount of BaBiO2.5 s phase could be obtained for the BaBiO3 thin film deposited at 200 °C, and also, the main crystalline phase was transferred from BaBiO2.82 to BaBiO2.5 when the BaBi0·92Cu0·08O3 thin films were deposited at 200 °C and 250 °C, respectively. Temperature dependent complex impedance spectroscopy was carried out to make clear the resistance contribution of grain (Rg), grain boundary (Rgb) and contact (Rs) response for the conduction mechanisms in the Ba–Bi–O-based thin film deposited at a given substrate temperature. Compared with the electrical properties of the BaBiO3 thin film deposited at 200 °C [such as the room-temperature resistivity (ρ25 ~ 1548 Ω cm) and the thermistor constant (B25/85–3245 K)], the better NTC characteristics of a lower ρ25 value of about 956 Ω cm and a higher B value of approximately 3480 K were found in the BaBi0·92Cu0·08O3 thin film deposited at a same temperature (200 °C). It is believed that the phase structures and electrical properties of the BaBiO3 perovskite-type NTC thermistor thin films could be adjusted and optimized by a trace amounts of Cu-ions substitutions and depositing at an appropriate substrate temperature, which also showed that such as these novel BaBiO3-based thin films are feasible with the extensive of actual applications for the NTC thermistors.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Electrical and Thermal Properties of Materials · Ferroelectric and Piezoelectric Materials · Dielectric properties of ceramics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (45)

Show source-provided references
1. Microstructure evolution and electrical property improvement of Mn-based thin film thermistors with the sandwich structure10.1007/s10854-015-3218-6 ↗
2. Effect of oxygen partial pressure and temperature on NTC characteristics of Mn1.56Co0.96Ni0.48O4 thin films grown on SrTiO3 (100) by laser MBE10.1016/j.jallcom.2014.05.089 ↗
3. Electrical properties and temperature sensitivity of Li/Fe-modifified NiO-based ceramics as NTC thermistors10.1007/s10854-016-5335-2 ↗
4. Growth mode and properties of Mn-Co-Ni-O NTC thermistor thin films deposited on MgO (100) substrate by laser MBE10.1142/S0217984914502352 ↗
5. Epitaxial growth of Mn-Co-Ni-O thin films and thickness effects on the electrical properties10.1016/j.matlet.2014.05.091 ↗
6. Structural and electrical properties of Mn1.56Co0.96Ni0.48O4 NTC thermistor films10.1016/j.mseb.2014.02.011 ↗
7. Spinel forming ceramics of the system FexNiyMn3-x-yO4 for high temperature NTC thermistor applications10.1016/S0955-2219(00)00140-0 ↗
8. Fabrication and electrical properties of Mn-Ni-Co-Cu-Si oxides negative temperature coefficient thermistors10.1111/j.1551-2916.2004.00170.x ↗
9. Microstructure and electrical properties of Ni1.0Mn2−xZrxO4 (0 ≤ x ≤ 1.0) negative temperature coefficient thermistors10.1016/S0921-5107(03)00257-5 ↗
10. Effects of Cu and Zn co-doping on the electrical properties of Ni0.5Mn2.5O4 NTC ceramics10.1016/j.jeurceramsoc.2007.06.007 ↗
11. Effect of Zn substitution on the phase, microstructure and electrical properties of Ni0.6Cu0.5ZnxMn1.9−xO4 (0 ≤ x ≤ 1) NTC ceramics10.1016/j.mseb.2014.06.011 ↗
12. Effect of Mg substitution on microstructure and electrical properties of Mn1.25Ni0.75Co1.0−xMgxO4 (0 ≤ x ≤ 1) NTC ceramics10.1007/s10854-011-0505-8 ↗
13. Preparation and electrical properties of perovskite ceramics in the system BaBi1–xSbxO3 (0 ≤ x ≤ 0.5)10.1016/j.jallcom.2011.02.050 ↗
14. Mixed-valent Ba2Bi3+Bi5+O6: structure and properties vs temperature10.1107/S0567740879002417 ↗
15. High-temperature superconductivity in the BaPb1-xBixO3 systems10.1016/0038-1098(75)90327-0 ↗
16. Fabrication and properties of Mn1.56Co0.96Ni0.48O4 free-standing ultrathin chips10.1016/j.ceramint.2014.01.049 ↗
17. Annealing effect on the structural, electrical and 1/f noise properties of Mn-Co-Ni-O thin films10.1007/s10854-014-1829-y ↗
18. BrendanTwamley, (NBu4)Ni(mnt)2: a novel bistable high temperature spin-Peierls-like system10.1016/j.poly.2005.03.088 ↗
19. Electrical conduction in metal oxides, Applications and Materials
20. Influence of copper substitution on structural, electrical and dielectric properties of Ni(1−x)CuxMn2O4 (0 ≤ x ≤ 1) ceramics10.1016/j.jallcom.2010.07.143 ↗
21. Impedance analysis of MnCoCuO NTC ceramic10.1016/j.materresbull.2005.04.001 ↗
22. Effects of RF magnetron sputtering power density on NTC characteristics of Mn-Co-Ni thin films10.1007/s10854-012-0906-3 ↗
23. Partial suppression of structural distortion in epitaxially grown BaBiO3 thin films10.1103/PhysRevB.78.132507 ↗
24. Improvement of electrical properties of single-phase film thermistors by a Ni0.75Mn2.25O4/LaMnO3 bilayer structure10.1007/s10854-016-5994-z ↗
25. BaBiO2.5, a new bismuth oxide with a layered structure10.1016/0022-4596(91)90353-J ↗
26. New dielectric material systems of SrxNd2(1-x)/3TiO3 perovskites-like at microwave frequencies10.1016/j.matchemphys.2016.02.017 ↗
27. Effect of NdAlO3 on microstructure, dielectric properties and temperature-stable mechanism of (Sr, Ca, Nd)TiO3 ceramics at microwave frequency10.1007/s10854-016-5228-4 ↗
28. Bond-valence parameters for solids10.1107/S0108768190011041 ↗
29. Effect of bond valence on microwave dielectric properties of (1-x)CaTiO3-x(Li0.5La0.5)TiO3 ceramics10.1016/j.materresbull.2012.05.024 ↗
30. Effffect of structures and substrate temperatures on BaZn0.06Bi0.94O3-δ perovskite-based NTC thermistor thin films10.1016/j.mssp.2018.11.034 ↗
31. Preparation and electrical properties of Ni0.6Mn2.4-xTixO4 NTC Ceramics10.1016/j.jallcom.2015.08.077 ↗
32. Small polaron hopping in spinel manganates10.1103/PhysRevB.72.115101 ↗
33. Effect of Cu and Fe addition on electrical properties of Ni-Mn-Co-O NTC thermistor compositions10.1016/j.ceramint.2012.05.025 ↗
34. Electrical properties of lead-free thick film NTC thermistors based on perovskite-type BaCoIIxCoIII2xBi1−3xO310.1016/j.matlet.2010.12.013 ↗
35. Development and electrical properties of wurtzite (Al,Ti)N materials for thin film thermistors10.2109/jcersj2.15316 ↗
36. Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenides10.1107/S0567739476001551 ↗
37. Effect of Ti ion doping on martensitic transition of La0.5Sr0.5Mn1−xTixO310.1016/j.jallcom.2013.11.030 ↗
38. Studies on the properties of Ni0.6Cu0.4Mn2O4 NTC ceramic due to Fe doping10.1016/j.ceramint.2012.03.024 ↗
39. Preparation routes and electrical properties for Ni0.6Mn2.4O4 NTC ceramics10.1007/s10854-015-3350-3 ↗
40. Voltage-dependent resistance of undoped rutile, TiO2, ceramics10.1063/1.4848098 ↗
41. Improvement of structural and electrical properties of Mn-based thin film thermistors by abilayer structure10.1016/j.matlet.2014.04.136 ↗
42. Impedance spectroscopy of Lanthanum modified Pb(Zr,Ti)O3 ceramics
43. Preparation of Ni0.9Mn2.1–xMgxO4 (0 ≤ x ≤ 0.3) negative temperature coefficient ceramic materials by a rheological phase reaction method10.1016/j.matlet.2013.09.003 ↗
44. Resistive switching in a negative temperature coefficient metal oxide memristive one-port10.1007/s00339-012-7388-2 ↗
45. Investigation of the thermal diffusivity of thick film NTC layers obtained with the photoacoustic method10.1051/jp4:2005125101 ↗