journal article·2019-09

Synthesis of quantum dot porous silicon as extended gate field effect transistor (EGFET) for a pH sensor application

Lary H. Slewa, Tariq A. Abbas, Naser M. Ahmed

Publisher page

Abstract

Abstract Porous silicon quantum dot (PSi-QD) was prepared from p-type silicon (100) using the electrochemical etching technique. The prepared PSi-QD was then applied as an extended gate field effect transistor (EGFET) in the synthesis of a PSi-QD based pH sensor. The morphology, structural properties, and pores of the prepared PSi-QD layer were characterized using field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), and Fourier transform infrared spectroscopy (FTIR). The average pore size of the PSi-QD was 5.8 nm with an average pore depth of 3.43 μm. The sensitivity, linearity, and hysteresis measurements of the sensor were determined for different pH buffer solutions. The sensor displayed a voltage sensitivity of 108.3 mV/pH with linearity of 98.97% for the linear regime, while the current sensitivity for the saturated regime was 2.65 μA1/2/pH with linearity of 99.81%. The net hysteresis value of the sensor was approximately 14 mV. The repeatability deviation at pH7 was 0.86%. The stability and reliability of the sensor in terms of coefficient of variation (C.V.) were 0.76%, 0.93%, and 0.98% for pH4, pH7, and pH10, respectively. Based on its high sensitivity, good linearity and low hysteresis as well as its good repeatability, stability and reliability, the PSi-QD EGFET based pH sensor is considered a viable device for the detection of hydrogen ions.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Nanowire Synthesis and Applications · Analytical Chemistry and Sensors · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (22)

Show source-provided references
1. Sensing performance of EGFET pH sensors with CuO nanowires fabricated on glass substrate10.1016/S1452-3981(23)19600-3 ↗
2. Sensitivity of CuS membrane pH sensor with and without MOSFET10.1007/s11837-016-2165-x ↗
3. V2O5/WO3 mixed oxide films as pH-EGFET sensor: sequential re-usage and fabrication volume analysis10.1149/2.007203jss ↗
4. Influences of substrate type on the pH sensitivity of CuS thin films EGFET prepared by spray pyrolysis deposition10.1016/j.mssp.2017.02.032 ↗
5. High sensitivity pH sensor based on porous silicon (PSi) extended gate field-effect transistor10.3390/s16060839 ↗
6. Characteristics of extended-gate field-effect transistor (EGFET) based on porous n-type (111) silicon for use in pH sensors10.1007/s11664-017-5604-8 ↗
7. 2016
8. 2014
9. Semiconductor quantum dots in chemical sensors and biosensors10.3390/s90907266 ↗
10. Silicon nanowires as pH sensor10.1143/JJAP.44.2626 ↗
11. Nernst limit in dual-gated Si-nanowire FET sensors10.1021/nl100892y ↗
12. Colloidal silicon quantum dots: synthesis and luminescence tuning from the near-UV to the near-IR range10.1088/1468-6996/15/1/014207 ↗
13. Characterization of silicon nanoparticles prepared from porous silicon10.1021/cm950608k ↗
14. Analysis of temporal evolution of quantum dot surface chemistry by surface-enhanced Raman scattering10.1038/srep29508 ↗
15. Studies on silicon quantum dots prepared at different working pressure10.1016/j.rinp.2017.03.002 ↗
16. Simulation and fabrication of extended gate ion sensitive field effect transistor for biosensor application
17. Study on extended gate field effect transistor with tin oxide sensing membrane10.1016/S0254-0584(99)00184-4 ↗
18. Highly sensitive palladium oxide thin film extended gate FETs as pH sensor10.1016/j.snb.2014.08.057 ↗
19. Multilayer ZnO/Pd/ZnO structure as sensing membrane for extended-gate field-effect transistor (EGFET) with high pH sensitivity10.1007/s11664-017-5580-z ↗
20. Porous silicon based potentiometric triglyceride biosensor10.1016/S0956-5663(01)00129-4 ↗
21. ISFET pH sensitivity: counter-Ions play a key role10.1038/srep41305 ↗
22. Influence of CuS membrane annealing time on the sensitivity of EGFET pH sensor10.1016/j.mssp.2017.07.001 ↗