Influence of CuS membrane annealing time on the sensitivity of EGFET pH sensor
Source abstract
Abstract
Abstract In this study, CuS membranes were deposited on glass substrates using spray pyrolysis, and then annealed at 150 °C for durations of 5, 15 and 30 min. The precursor materials for the synthesis of the CuS membranes include copper chloride and sodium thiosulfate dissolved in deionized water. 0.4 M concentration of the mixed solution was subsequently sprayed on the glass substrates at 200 °C. Afterwards, the as-deposit membranes were implemented as extended gate field effect transistors (EGFET) for pH sensors. The structure, morphology, resistance, sensitivity and linearity of the membranes were determined. The structural characteristics showed that the maximum average grain size of the CuS membrane was 24.2 nm after 30 min of annealing. The sensitivity of the membranes was measured in buffer solutions of pH 2, 4, 6, 8, 10 and 12. The sensitivity increased with annealing time until maximum values of 31.5 µA/pH and 27.8 mV/pH were attained at 30 min, with minimum resistance of 400 Ω and minimum hysteresis of 11.4 mV. Thus, the ideal annealing time for optimum sensitivity, resistance and hysteresis is 30 min.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Analytical Chemistry and Sensors · Gas Sensing Nanomaterials and Sensors · Electrochemical sensors and biosensors
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. Comparative sensibility study of WO3 ph sensor using EGFET and ciclic voltammetry10.1590/1516-1439.252513 ↗
2. Development of an ion-sensitive solid-state device for neurophysiological measurements10.1109/TBME.1970.4502688 ↗
3. A generalized theory of an electrolyte-insulator-semiconductor field-effect transistor10.1109/T-ED.1986.22429 ↗
4. Sensitivity and hysteresis properties of a-WO3, Ta2O5, and a-Si:H gate ion-sensitive field-effect transistors10.1117/1.1482099 ↗
5. The extended gate chemically sensitive field effect transistor as multi-species microprobe10.1016/0250-6874(83)85035-5 ↗
6. High sensitive nanocrystal titanium nitride EG-FET pH sensor10.4028/www.scientific.net/AMR.802.232 ↗
7. The structure of the silica/electrolyte interface10.1016/0021-9797(76)90003-5 ↗
8. Electrical double layer interactions between dissimilar oxide surfaces with charge regulation and Stern-Grahame layers10.1016/j.jcis.2005.09.003 ↗
9. Annealing effects on resistivity properties of vacuum evaporated Cu2S thin films
10. Aptamer-modified CuS nanocrystals/graphene oxide composites for controlled release of glucosamine and chemo-photothermal therapy of tumor cells10.1016/j.matlet.2017.02.119 ↗
11. CuS nanocrystal@microgel nanocomposites for light-regulated release of dual-drugs and chemo-photothermal synergistic therapy in vitro10.1039/C5RA25870G ↗
12. Comparative studies of spray pyrolysis deposited copper sulfide nanostructural thin films on glass and FTO coated glass10.1007/s12034-012-0363-x ↗
13. Spray pyrolysis deposition of CuS thin films10.1016/S0167-577X(97)00015-3 ↗
14. CuS thin films obtained by spray pyrolysis
15. The growth of CuS thin films by spray pyrolysis
16. Fayroz A. Sabah, Naser M. Ahmed, Z. Hassan, Hiba S. Rasheed, Shrook A. Azzez, Nabeel Z. Al-Hazim, CuS p- type thin film characterization deposited on Ti, ITO and glass substrates using spray pyrolysis deposition (SPD) for light emitting diode (LED) application, in: AIP Conference Proceedings, vol. 1733, p. 020021. 〈http://dx.doi.org/10.1063/1.4948839〉.10.1063/1.4948839 ↗
17. Spray pyrolysis equipment for various applications
18. Effect of light on the sensitivity of CuS thin film EGFET implemented as pH sensor10.20964/2016.06.51 ↗
19. Sensitivity of CuS membrane pH sensor with and without MOSFET
20. Study effects of thin film thickness on the behavior of CuS EGFET implemented as pH sensor
21. Influences of substrate type on the pH sensitivity of CuS thin films EGFET prepared by spray pyrolysis deposition10.1016/j.mssp.2017.02.032 ↗
22. Pin-Chuan Yao, Ming-Chih Lee, Jung-Lung Chiang, Annealing effect of sol-gel TiO2 thin film on pH-EGFET sensor, in: IEEE International Symposium on Computer, Consumer and Control, 2014, pp. 577–580.10.1109/IS3C.2014.157 ↗
23. M.A. Zulkefle, R.A. Rahman, K.A. Yusoff, W.F.H. Abdullah, M. Rusop, S.H. Herman, Annealing time dependence of the physical, electrical and pH response characteristics of spin coated TiO2 thin film, in: IOP Conference Series: Materials Science and Engineering, 99, p. 012021.10.1088/1757-899X/99/1/012021 ↗
24. pH sensing reliability of flexible ITO/PET electrodes on EGFETs prepared by a roll-to-roll process10.1016/j.microrel.2011.10.026 ↗
25. The pH response and sensing mechanism of n-type ZnO/electrolyte interfaces10.3390/s90907445 ↗
26. High sensitivity ph sensor based on porous silicon (PSi) extended gate field-effect transistor10.3390/s16060839 ↗
27. Site-binding model of the electrical double layer at the oxide/water interface10.1039/f19747001807 ↗
28. V2O5/WO3 mixed oxide filmes as pH-EGFET sensor: sequential re-usage and fabrication volume analysis10.1149/2.007203jss ↗
29. pH-sensing characteristics of hydrothermal Al-doped ZnO nanostructures, Hindawi publishing corporation10.1155/2013/152079 ↗
30. Optical and impedance characteristics of EGFET based on SnO2/ITO sensing gate
31. Sensing performance of EGFET pH sensors with CuO nanowires fabricated on glass substrate10.1016/S1452-3981(23)19600-3 ↗
32. Sensing performance of EGFET pH sensors with CZTSe nanoparticles fabricated on glass substrates10.1016/S1452-3981(23)14437-3 ↗
33. Investigation of InN nanorod-based EGFET pH sensors fabricated on quartz substrate
34. Study on the temperature effect, hysteresis and drift of pH-ISFET devices based on amorphous tungsten oxide10.1016/S0925-4005(01)00657-8 ↗
35. Interdigitated extended gate field effect transistor without reference electrode
36. Sensitivity of pH sensors with TiO2 nanowires10.1149/2.0091410ssl ↗
37. Synthesis and characterization of vanadium oxide/hexadecylamine membrane and its application as pH-EGFET sensor10.1007/s10971-009-2062-7 ↗
38. A novel pH sensor of extended-gate field effect transistors with laser-irradiated carbon-nanotube network10.1109/LED.2012.2213794 ↗