journal article·2019-09

Effect of annealing parameters on optoelectronic properties of highly ordered ZnO thin films

Gaurav Malik, Satyendra Mourya, Jyoti Jaiswal, Ramesh Chandra

Publisher page

Abstract

Abstract In the present work, tuning in optoelectronic properties of sputter deposited zinc oxide (ZnO) thin films on ITO coated glass substrate have been investigated as a function of annealing parameters. Although, the annealing treatment is needed to tune the optoelectronic properties of ZnO layer but it can also modify the electrical properties {a drastic change in sheet resistance (13 Ω/sq. to 23 ohm/sq.) was observed at an annealing temperature of 200 °C} of underlying ITO substrate, which restricted maximum annealing temperature to 200 °C for ZnO at ITO. Vertically standing array of ZnO nano-pipes having single crystal orientation (002) with hexagonal structure, large crystallite size (∼24 nm), lowest lattice strain (0.621%), highest surface roughness (∼16 nm), and lowest Rsh (12.3 KΩ/sq.) were obtained for sample annealed at 200 °C for 60 min. The XPS study also revealed that the sample annealed at 200 °C for 60 min contains lowest oxygen related vacancy (23.7), which favors the facile electrons transport when ZnO is used as an electron transport layer (ETL). SE and UV–Vis results revealed best optical parameters i.e., highest transmittance (T∼ 89%), refractive index (n = 1.98 at 480 nm), and band gap (Eg = 3.30 eV), for the sample annealed at 200 °C for 60 min. These results indicated that ZnO nano-pipes based ETL may be a promising candidate for low temperature, high mobility, and cost-effective optoelectronic devices.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: ZnO doping and properties · Ga2O3 and related materials · Gas Sensing Nanomaterials and Sensors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (69)

Show source-provided references
1. Enhanced power-conversion efficiency in polymer solar cells using an inverted device structure10.1038/nphoton.2012.190 ↗
2. Efficient bulk heterojunction polymer solar cells using PEDOT/PSS doped with solution-processed MoO3 as anode buffer layer10.1016/j.solmat.2012.03.027 ↗
3. Improving the TiO2 electron transport layer in perovskite solar cells using acetylacetonate-based additives10.1039/C4TA06394E ↗
4. Metal oxides for interface engineering in polymer solar cells10.1039/c2jm33838f ↗
5. Nanostructured TiO2/CH3NH3PbI3heterojunction solar cells employing spiro-OMeTAD/Co-complex as hole-transporting material10.1039/c3ta12681a ↗
6. Ultra-thin ZnO film as an electron transport layer for realizing the high efficiency of organic solar cells10.1039/C6RA27543E ↗
7. Electrodeposition of SnO2 on FTO and its application in planar heterojunction perovskite solar cells as an electron transport layer10.1186/s11671-017-2247-x ↗
8. Surface modification of a ZnO electron-collecting layer using atomic layer deposition to fabricate high-performing inverted organic photovoltaics10.1021/am402403x ↗
9. Inverted organic photovoltaic devices with high efficiency and stability based on metal oxide charge extraction layers10.1039/C0JM03048A ↗
10. Development of efficient and stable inverted bulk heterojunction (BHJ) solar cells using different metal oxide interfaces10.3390/ma6125796 ↗
11. Air-stable inverted flexible polymer solar cells using zinc oxide nanoparticles as an electron selective layer10.1063/1.2945281 ↗
12. Efficient inverted bulk-heterojunction solar cells from low-temperature processing of amorphous ZnO buffer layers10.1039/C4TA02276A ↗
13. Fabrication of the ZnO thinfilms using wet-chemical etching processes on application for organic light emitting diode (OLED) devices10.1016/j.surfcoat.2008.06.064 ↗
14. Enhancement of hole-injection and power efficiency of organic light emitting devices using an ultra-thin ZnO buffer layer10.1016/j.jallcom.2008.12.122 ↗
15. Violet electroluminescence from poly(N-vinylcarbazole)/ZnO-nanorod composite polymer light-emitting devices10.1016/j.synthmet.2010.12.027 ↗
16. Influence of annealing treatments on solution-processed ZnO film deposited on ITO substrate as electron transport layer for inverted polymer solar cells10.1016/j.solmat.2015.05.038 ↗
17. Effect of sol-gel derived ZnO annealing rate on light-trapping in inverted polymer solar cells10.1016/j.matlet.2013.06.063 ↗
18. Inverted low band gap polymer solar cells integrated with a low-temperature-annealed sol-gel-derived ZnO: active layer thickness effect on the recombination process10.1016/j.spmi.2013.05.032 ↗
19. A modified sequential method used to prepare high quality perovskite on ZnO nanorods10.1016/j.cplett.2015.09.044 ↗
20. Effects of seed layer on growth of ZnO nanorod and performance of perovskite solar cell10.1021/acs.jpcc.5b03276 ↗
21. Indium phosphide based solar cell using ultra-thin ZnO as an electron selective layer10.1088/1361-6463/aad7e3 ↗
22. Simultaneous improvements in power conversion efficiency and operational stability of polymer solar cells by interfacial engineering10.1039/c3cp53352b ↗
23. Optimization of processing parameters on the controlled growth of ZnO nanorod arrays for the performance improvement of solid-state dye-sensitized solar cells10.1016/j.jssc.2011.01.021 ↗
24. Room temperature ultraviolet laser emission from ZnO nanocrystal thin films grown by laser MBE10.1016/S0921-5107(98)00120-2 ↗
25. Enhanced optical absorption of Ti thin film: coupled effect of deposition and postdeposition temperatures10.1007/s11837-017-2546-9 ↗
26. Study on the electrical and optical properties of Ag/Al-doped ZnO coatings deposited by electron beam evaporation10.1016/j.apsusc.2006.10.061 ↗
27. Highly conducting and optically transparent Si-doped ZnO thinfilms prepared by spray pyrolysis10.1039/c3tc31129e ↗
28. Enhanced optical absorbance of hydrophobic Ti thin film: role of surface roughness10.5185/amlett.2016.6056 ↗
29. Sol–gel-deposited ZnO thin films: a review10.1016/j.mseb.2010.07.001 ↗
30. Influence of Mn doping on structural and optical properties of ZnO nano thin films synthesized by sol–gel technique10.1007/s00339-012-7379-3 ↗
31. Structural characterization of supported nanocrystalline ZnO thin films prepared by dip-coating10.1016/j.apsusc.2011.06.136 ↗
32. Zinc oxide films prepared by sol–gel spin coating technique10.1007/s00339-010-6121-2 ↗
33. The transparent conductive properties of manganese-doped zinc oxide films deposited by chemical bath deposition10.1007/s11664-011-1770-2 ↗
34. Deposition and characterization of sputtered ZnO films10.1016/j.spmi.2007.04.081 ↗
35. Structural and optical properties of ZnO thin films by rf magnetron sputtering with rapid thermal annealing10.1063/1.2896642 ↗
36. Development of Pd-Pt functionalized high performance H2 gas sensor based on silicon carbide coated porous silicon for extreme environment applications10.1016/j.snb.2018.12.042 ↗
37. Hydrogenation and dehydrogenation of hydrophobic Pd capped vertically aligned porous Ti nanoflake thin film10.1007/s11837-018-3047-1 ↗
38. Effects of seed layer on growth of ZnO nanorod and performance of perovskite solar cell10.1021/acs.jpcc.5b03276 ↗
39. Inverted polymer solar cells including ZnO electron transport layer fabricated by facile spray pyrolysis10.1016/j.solmat.2013.05.062 ↗
40. Impact of preparation condition of ZnO electron transport layer on performance of hybrid organic-inorganic light-emitting diodes10.1063/1.4866993 ↗
41. Enhanced performance of ZnO based perovskite solar cells by Nb2O5 surface passivation10.1016/j.orgel.2018.06.038 ↗
42. Photoluminescence and photo electrochemical properties of nanocrystalline ZnO thin films synthesized by spray pyrolysis technique10.1016/j.apsusc.2011.07.099 ↗
43. Inverted polymer solar cells with a boron-doped zinc oxide layer deposited by metal organic chemical vapor deposition
44. Effects of heat treatment on properties of ITO films prepared by rf magnetron sputtering10.1016/j.vacuum.2004.01.081 ↗
45. ZnO thin Films with blue emission grown using chemical spray pyrolysis10.1016/j.mssp.2012.10.003 ↗
46. Annealing effect on the property of ultraviolet and green emissions of ZnO thin films10.1063/1.1633343 ↗
47. Silicon quantum wire array fabrication by electrochemical and chemical dissolution of wafers10.1063/1.103561 ↗
48. Improved optical properties of ZnO thin films by concurrently introduced interfacial voids during thermal annealing10.1063/1.3609321 ↗
49. Phase-dependent structural and electrochemical properties of single crystalline MnS thinfilms deposited by DC reactive sputtering10.1063/1.5053875 ↗
50. Nucleation layer evolution in metal-organic chemical vapor deposition grown GaN10.1063/1.116083 ↗
51. Characterization and optimization of zinc oxide films by RF magnetron sputtering10.1016/S0040-6090(96)09274-7 ↗
52. Ohring · 2002
53. Moulder · 1995
54. The role of the substrate on photophysical properties of highly ordered 15R-SiC thin films10.1007/s11664-018-6411-6 ↗
55. Adsorption of 1,2-diaminoethane on ZnO thin films fromp-xylene10.1016/j.apsusc.2008.02.170 ↗
56. High-sensitivity NO2 gas sensors based on flower-like and tube-like ZnO nanomaterials10.1016/j.snb.2011.05.023 ↗
57. Defect and its dominance in ZnO films: a new insight into the role of defect over photocatalytic activity10.1016/j.apcatb.2013.05.055 ↗
58. Inverted polymer solar cells integrated with a low temperature-annealed sol-gel-derived ZnO film as an electron transport layer10.1002/adma.201004301 ↗
59. Optical and luminescence properties of zinc oxide10.1134/S0030400X11120216 ↗
60. Optical and other physical properties of hydrophobic ZnO thin films prepared by dc magnetron sputtering at room temperature10.1063/1.5007717 ↗
61. Structural, optical and electrical properties of zinc oxide layers produced by pulsed laser deposition method10.1186/s11671-017-2033-9 ↗
62. Structural and optical characteristics of in-situ sputtered highly oriented 15R-SiC thin films on different substrates10.1063/1.5006976 ↗
63. Tunable optical properties of plasmonic Au/Al2O3 nanocomposite thin films analyzed by spectroscopic ellipsometry accounting surface characteristics10.1364/JOSAA.35.000740 ↗
64. Determination of optical constants including surface characteristics of optically thick nanostructured Ti films: analyzed by spectroscopic ellipsometry10.1364/AO.55.008368 ↗
65. Ellipsometric investigation of room temperature grown HighlyOriented anatase TiO2 thin films10.1007/s11664-018-06872-2 ↗
66. Woolam · 1999 · 3
67. Overview of variable angle spectroscopic ellipsometry (VASE), Part II: advanced applications
68. Extraction of optical constants of zinc oxide thin films by ellipsometry with various models10.1016/j.tsf.2005.10.089 ↗
69. Spectroscopic ellipsometry data analysis: measured versus calculated quantities10.1016/S0040-6090(97)00765-7 ↗