journal article·2026-02Open access

Enhanced formaldehyde sensing with UV-LED activated Nafion-coated in₂O₃ gas sensor

Ghazal Ghorbani, Muhammad Huzaifa, Fariborz Taghipour

Abstract

High-performance formaldehyde sensors are highly desirable in various industries and indoor gas monitoring systems. Recent advances in ultraviolet light-emitting diode (UV-LED) technology have provided the opportunity to develop UV-activated semiconductor sensors with many advantages. However, the typical UV-activated metal oxide semiconductor (MOS) sensing material is at fault of restructuring in the presence of ppm concentrations of formaldehyde, leading to inconsistent sensor measurements. In response, we developed a formaldehyde sensor featuring excellent response stability by exploiting Nafion-coated indium oxide (In 2 O 3 ) nanoparticles (NPs) as the sensing material, prepared via an indium nitrate precursor route along with Nafion solution, deposited using spin-coating on an electrode, under UV-LED irradiation. The results indicated that the presence of a thin layer of Nafion preserves the structure of the UV-activated sensing layer from agglomeration, resulting in stable and reproducible sensor responses. Sensor sensitivity (response) was found to be a function of two key parameters: Nafion concentration and UV irradiance. We studied the responses of the Nafion-coated In 2 O 3 NPs sensor with Nafion concentrations of 0.5 wt% and 2.5 wt% and under UV irradiances of 2.35, 2.49, and 2.56 mW/cm 2 . The characterization results revealed greater porosity and a reduction in particle size after reducing the Nafion concentration, leading to sensitivity improvement. Sensor sensitivity was further improved by increasing the UV irradiance due to the enhanced proton conductivity through the Nafion layer. The linear relationship between the transient response and formaldehyde concentration exhibited the feasibility of the developed sensor for fast formaldehyde measurement. The results showed a transient response of 0.15 for the 0.5 wt% Nafion-coated In 2 O 3 NPs sensor under 2.56 mW/cm 2 irradiance to 25 ppm of formaldehyde. This study presents a new approach in preventing sensing layer restructuring caused by formaldehyde (and likely other similar volatile organic compounds (VOCs) of semiconductor gas sensors), thereby providing a practical solution to formaldehyde and other VOCs detection. This approach enhanced sensor sensitivity to different concentrations of the target gas, with fast and consistent response and recovery.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Gas Sensing Nanomaterials and Sensors · Advanced Chemical Sensor Technologies · Analytical Chemistry and Sensors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (51)

Show source-provided references
1. UV-activated semiconductor gas sensor response measurement for formaldehyde detection10.1016/j.jphotochem.2024.115546 ↗
2. An investigation of formaldehyde concentration in residences and the development of a model for the prediction of its emission rates10.1016/j.buildenv.2018.10.045 ↗
3. Health risk assessment of inhalation exposure to formaldehyde and benzene in newly remodeled buildings, Beijing10.1371/journal.pone.0079553 ↗
4. Volatile organic compounds in indoor air: an overview of sources, concentrations, and health effects
5. W. H. Organization · 2010
6. Facile synthesis of ZnO/WO3 nanocomposite porous films for high-performance gas sensing of multiple VOCs10.3390/nano13040733 ↗
7. Dual-mode gas sensor for ultrasensitive and highly selective detection of xylene and toluene using Nb-doped NiO hollow spheres10.1016/j.snb.2019.127140 ↗
8. A solid-state Nafion-coated screen-printed electrochemical sensor for ultrasensitive and rapid detection of copper ions in water10.3390/pr13072178 ↗
9. Enhancement of electrode surface hydrophilicity and selectivity with Nafion-PSS composite for trace heavy metal sensing in electrochemical sensors10.1016/j.aca.2024.343423 ↗
10. Accessed: Oct. · 2025 · 29
11. Fabrication and optimization of Nafion as a protective membrane for TiN-based pH sensors10.3390/s23042331 ↗
12. An electrochemiluminescence sensor based on Nafion/magnetic Fe3O4 nanocrystals modified electrode for the determination of bisphenol a in environmental water samples10.3390/s18082537 ↗
13. Ghorbani · 2022
14. A Nafion film cover to enhance the analytical performance of the CuO/cu electrochemical sensor for determination of chemical oxygen demand10.3390/s19030669 ↗
15. Effect of nafion dispersion on the stability of Pt/WO 3 electrodes10.1149/1.1837094 ↗
16. The interference elimination for gas sensor by catalyst filters10.1016/S0925-4005(99)00463-3 ↗
17. Heterogeneous catalysis by solid superacids. 5. Methylation of benzene and methylbenzenes with methyl alcohol over a perfluorinated resin sulfonic acid (Nafion-H) catalyst10.1021/jo00410a011 ↗
18. Synthetic methods and reactions. Part 50. Rearrangement of allyl alcohols to aldehydes with superacids10.1021/jo00414a022 ↗
19. Nafion-based methanol gas sensor for fuel cell vehicles10.1016/j.snb.2020.127905 ↗
20. Nafion-based amperometric H2S sensor using Pt-rh/C sensing electrode10.1016/j.snb.2018.06.087 ↗
21. Facile E-nose based on single antenna and graphene oxide for sensing volatile organic compound gases with ultrahigh selectivity and accuracy10.1016/j.snb.2024.136409 ↗
22. Electrochemical MoOx/carbon nanocomposite-based gas sensor for formaldehyde detection at room temperature10.1149/1945-7111/ac0d3c ↗
23. Cyclic-voltammetry-based solid-state gas sensor for methane and other VOC detection10.1021/acs.analchem.8b00184 ↗
24. Effective analysis of gaseous formaldehyde based on a platinum-deposited screen-printed edge band ultramicroelectrode coated with Nafion as solid polymer electrolyte10.1016/j.snb.2010.03.090 ↗
25. A nafion coated capacitive humidity sensor on a flexible PET substrate
26. Humidity sensing under aggressive conditions using nafion conductors10.1007/BF02374157 ↗
27. Responses of hydrophobic and hydrophilic groups in Nafion differentiated by least squares Modeling of infrared spectra recorded during thin film hydration
28. Novel approach to interference analysis of glucose sensing materials coated with Nafion10.1016/j.bioelechem.2020.107575 ↗
29. State of understanding of Nafion10.1021/cr0207123 ↗
30. PVDF-Nafion nanomembranes coated microneedles for in vivo transcutaneous implantable glucose sensing10.1016/j.bios.2015.07.036 ↗
31. Sensitivity of Nafion films to organic substances, especially ketones
32. Metal/carbon hybrid nanostructures produced from plasma-enhanced chemical vapor deposition over nafion-supported electrochemically deposited cobalt nanoparticles10.3390/ma11050687 ↗
33. Synthesis and characterization of nano-sized ZnO powders by direct precipitation method10.1016/j.cej.2008.07.047 ↗
34. Accessed: Oct. · 2025 · 07
35. Facile synthesis of In2O3 nanoparticles with high response to formaldehyde at low temperature10.1111/ijac.13244 ↗
36. An investigation of the impact of nafion polymer on surface passivation and analysis of degradation in HIT solar cells for improvement performance10.1016/j.cap.2024.04.006 ↗
37. Photocatalytic reactivities of nafion-coated TiO2 for the degradation of charged organic compounds under UV or visible light10.1021/jp051222s ↗
38. Three-dimensional analysis of Nafion layers in fuel cell electrodes10.1038/ncomms6229 ↗
39. Effect of particle size reduction on the conductivity of Nafion®/phosphotungstic acid composite membranes10.1016/j.memsci.2005.05.019 ↗
40. Effects of porosity and particle size on the gas sensing properties of SnO2 films10.1016/j.apsusc.2019.03.043 ↗
41. Room temperature hydrogen sensor based on Nafion and pd/CF sensing electrode10.1016/j.snb.2022.132014 ↗
42. Pore size tuning of Nafion membranes by UV irradiation for enhanced proton conductivity for fuel cell applications10.1016/j.ijhydene.2019.07.084 ↗
43. Preparation and properties of UV irradiation-induced crosslinked sulfonated poly (ether ether ketone) proton exchange membranes10.1016/j.memsci.2008.10.029 ↗
44. Strongly coupled nafion molecules and ordered porous CdS networks for enhanced visible-light photoelectrochemical hydrogen evolution10.1002/adma.201600437 ↗
45. Development of highly sensitive ZnO/In2O3 composite gas sensor activated by UV-LED10.1016/j.snb.2016.10.129 ↗
46. The effect of radiation parameters on the performance of photo-activated gas sensors10.1016/j.jphotochem.2019.01.038 ↗
47. Highly stable and selective H2 gas sensors based on light-activated a-IGZO thin films with ZIF-8 selective membranes10.1016/j.snb.2024.136175 ↗
48. Formaldehyde detection with chemical gas sensors based on WO3 nanowires decorated with metal nanoparticles under dark conditions and UV light irradiation10.1016/j.snb.2020.128331 ↗
49. Formaldehyde gas sensing characteristics of ZnO-TiO2 gas sensors10.3390/chemosensors11020140 ↗
50. UV-activated au modified tio2/In2o3 hollow nanospheres for formaldehyde detection at room temperature10.3390/ma16114010 ↗
51. A formaldehyde gas sensor based on ag-decorated ZnCo2O4/FF composite10.1016/j.cplett.2024.141211 ↗