Analysis on the capacitance-voltage characteristics of metal-insulator-semiconductor capacitors based on thermally evaporated WOx on n- and p- type crystalline silicon
Source abstract
Abstract
Tungsten oxide (WO x) thin films were deposited on n- and p-type crystalline silicon (c-Si) wafers by thermal evaporation technique at room temperature. The electrical characterization of Ag/WO x/n-Si and Ag/WO x/p-Si metal–insulator-semiconductor (MIS) capacitors were examined by the capacitance- and conductance-voltage measurements as a function of applied frequency in the 10 kHz 10 MHz range. The admittance properties of both MIS devices have been evaluated by analyzing the interfacial nature and bulk c-Si in accumulation, depletion, and inversion regimes. The capacitance responses of interface traps, bulk c-Si, depletion, and shallow states at the WO x/c-Si interface indicated the appearance of the capacitance peaks in depletion and inversion regimes for Ag/WO x/n-Si and Ag/WO x/p-Si devices. From C-V characterization, various parameters such as the depletion layer width, depletion capacitance, flat-band voltage, total charge density, and net ionized state density were calculated as a function of applied frequency. For Ag/WO x/n-Si device, the total charge density and barrier height values of 7.642 × 10 −9 C and 1.119 eV at 1 MHz, respectively, were obtained. The same parameters were calculated to be 5.887 × 10 −8 C and 1.107 eV for Ag/WO x/p-Si. The results demonstrated that interfacial nature of WO x film significantly governs the electronic characteristics of the c-Si based MIS devices.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Semiconductor materials and interfaces · Silicon and Solar Cell Technologies · Semiconductor materials and devices
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (58)
Show source-provided references
1. Sze · 2007
2. Rectification and barrier height inhomogeneous in Rhodamine B based organic Schottky diode10.1016/j.synthmet.2010.10.030 ↗
3. Frequency and voltage dependence of admittance characteristics of Al/Al2O3/PVA:n-ZnSe Schottky barrier diodes10.1016/j.mssp.2015.07.028 ↗
4. Surface state and interface effects on the capacitance-voltage relationship in Schottky barriers10.1063/1.1658262 ↗
5. On the studies of capacitance-voltage-temperature and deep level characteristics of an Au/p-GaTe Schottky diode10.1016/j.jallcom.2016.08.097 ↗
6. Microelectronic properties of the organic Schottky diode with pyronin-Y: Admittance spectroscopy, and negative capacitance10.1016/j.physb.2018.05.011 ↗
7. Defect states assisted charge conduction in Au/MoO3-x/n-Si Schottky barrier diode
8. Thermal stability of hole-selective tungsten oxide: in situ transmission electron microscopy study10.1038/s41598-018-31053-w ↗
9. Molybdenum oxide MoOx: A versatile hole contact for silicon solar cells10.1063/1.4903467 ↗
10. Transition metal oxides as hole-selective contacts in silicon heterojunctions solar cells10.1016/j.solmat.2015.08.028 ↗
11. Dependence of n-cSi/MoOx heterojunction performance on cSi doping concentration10.1016/j.egypro.2017.09.267 ↗
12. Stable dopant-free asymmetric heterocontact silicon solar cells with efficiencies above 20%10.1021/acsenergylett.7b01279 ↗
13. Efficient silicon solar cells with dopant-free asymmetric heterocontacts10.1038/nenergy.2015.31 ↗
14. J. Bullock, D. Yan, A. Cuevas, Y. Wan, C. Samundsett, N- and p-typesilicon Solar Cells with Molybdenum Oxide Hole Contacts, in: Energy Procedia, Elsevier Ltd, 2015: pp. 446–450. https://doi.org/10.1016/j.egypro.2015.07.063.10.1016/j.egypro.2015.07.063 ↗
15. Electrical, optical and surface characterization of reactive RF magnetron sputtered molybdenum oxide films for solar cell applications10.1016/j.mssp.2019.05.018 ↗
16. Origin of passivation in hole-selective transition metal oxides for crystalline silicon heterojunction solar cells10.1557/jmr.2016.453 ↗
17. Simulation of an efficient silicon heterostructure solar cell concept featuring molybdenum oxide carrier-selective contact10.1002/er.3947 ↗
18. Silicon heterojunction solar cell with passivated hole selective MoO x contact10.1063/1.4868880 ↗
19. 22.5% efficient silicon heterojunction solar cell with molybdenum oxide hole collector10.1063/1.4928747 ↗
20. Atomic Layer deposited molybdenum oxide for the hole-selective contact of silicon solar cells10.1016/j.egypro.2016.07.125 ↗
21. Numerical analysis of dopant-free asymmetric silicon heterostructure solar cell with SiO2 as passivation layer10.1002/er.5720 ↗
22. MoOx/Ag/MoOx multilayers as hole transport transparent conductive electrodes for n-type crystalline silicon solar cells10.1002/er.5145 ↗
23. On the electrical and charge conduction properties of thermally evaporated MoOx on n- and p-type crystalline silicon10.1007/s10854-020-04884-5 ↗
24. On the application of hole-selective MoOx as full-area rear contact for industrial scale p-type c-Si solar cells10.1002/pip.3363 ↗
25. Fabrication and characterization of WO3 thin films on silicon surface by thermal evaporation10.1016/j.matlet.2017.02.078 ↗
26. Temperature dependent current-voltage characteristics of Au/n-Si Schottky barrier diodes and the effect of transition metal oxides as an interface layer10.1016/j.physb.2017.10.068 ↗
27. Thin-film metal oxides in organic semiconductor devices: Their electronic structures, work functions and interfaces10.1038/am.2013.29 ↗
28. Transition metal oxides for organic electronics: energetics, device physics and applications10.1002/adma.201201630 ↗
29. Transition metal oxide work functions: The influence of cation oxidation state and oxygen vacancies10.1002/adfm.201200615 ↗
30. Molybdenum and tungsten oxide: High work function wide band gap contact materials for hole selective contacts of silicon solar cells10.1016/j.solmat.2015.05.031 ↗
31. Physical device simulation of dopant-free asymmetric silicon heterojunction solar cell featuring tungsten oxide as a hole-selective layer with ultrathin silicon oxide passivation layer10.1016/j.renene.2021.10.073 ↗
32. Fourteen percent efficiency ultrathin silicon solar cells with improved infrared light management enabled by hole-selective transition metal oxide full-area rear passivating contacts10.1002/pip.3510 ↗
33. Optoelectronic characteristics of the Ag- doped Si p-n photodiodes prepared by a facile thermal diffusion process
34. Current-voltage and capacitance-conductance-voltage characteristics of Al/SiO2/p-Si and Al/Methyl Green (MG)/p-Si Structures10.1007/s11661-014-2621-6 ↗
35. Effects of temperature, bias and frequency on the dielectric properties and electrical conductivity of Ni/SiO2/p-Si/Al MIS Schottky diodes
36. A. V. Voitsekhovskii, S.N. Nesmelov, V. A. Novikov, S. M. Dzyadukh, T. N. Kopylova, I. V. Ivonin, K. M. Degtyarenko, E. v. Tereshchenko, Admittance characterization of pentacene metal-semiconductor capacitors with SiO2/Ga2O3 insulators in temperature range of 9-300 K, Thin Solid Films. 692 (2019) 137622 1-7. https://doi.org/10.1016/j.tsf.2019.137622.10.1016/j.tsf.2019.137622 ↗
37. Young-bog Park, Comparison of methods for extracting minority carrier lifetime from Mos capacitors. Master Thesis, The University of Arizona. 1993. http://hdl.handle.net/10150/278309.
38. D. Ahiboz, H. Nasser, R. Turan, Admittance analysis of thermally evaporated-hole selective MoO3 on crystalline silicon, in: Proceedings of 2016 International Renewable and Sustainable Energy Conference, IRSEC 2016, Institute of Electrical and Electronics Engineers Inc., 2017: pp. 144–151. https://doi.org/10.1109/IRSEC.2016.7983991.10.1109/IRSEC.2016.7983991 ↗
39. B.K. Jones, J. Santanat, M. Mcpherson, NEGATIVE CAPACITANCE EFFECTS IN SEMICONDUCTOR DIODES, 1998.10.1016/S0038-1098(98)00162-8 ↗
40. Temperature dependent negative capacitance behavior of Al/rhodamine-101/n- GaAs Schottky barrier diodes and R s effects on the C-V and G/ω-V characteristics10.1016/j.jallcom.2011.09.101 ↗
41. Negative capacitance in light-emitting devices10.1016/j.sse.2009.01.002 ↗
42. The source of negative capacitance and anomalous peak in the forward bias capacitance-voltage in Cr/p-Si Schottky barrier diodes (SBDs)10.1016/j.mssp.2015.05.044 ↗
43. Interface traps contribution to capacitance of Al2O3/(GaN)AlGaN/GaN heterostructures at low frequencies10.1016/j.physe.2017.06.022 ↗
44. Temperature dependent dielectric studies of Ni/n-GaP Schottky diodes by capacitance and conductance measurements10.1016/j.mssp.2015.11.010 ↗
45. Nicollian · 1982
46. Capacitance-conductance spectroscopic investigation of interfacial oxide layer in Ni/4H-SiC (0 0 0 1) Schottky diode10.1016/j.physb.2013.10.042 ↗
47. Admittance of pentacene- based mis-structures with two-layer insulator SiO2–Al2O310.1007/s11182-021-02454-8 ↗
48. Improvement of electrical properties of ZnS/CdTe-HgCdTe interface by (NH4)2S treatment10.1016/j.infrared.2019.102988 ↗
49. Flat-band potential of a semiconductor
50. Al2O3/Ag/Al2O3 passivating and conducting stacks for crystalline silicon solar cells10.1016/j.tsf.2016.07.002 ↗
51. Considerations on the C-V characteristics of pentacene metal-insulator- semiconductor capacitors
52. Interface states in polymer metal-insulator-semiconductor devices10.1063/1.2081109 ↗
53. Interface states in polyfluorene-based metal-insulator-semiconductor devices10.1016/j.orgel.2007.04.007 ↗
54. Experimental and modeling study of the capacitance-voltage characteristics of metal-insulator-semiconductor capacitor based on pentacene/parylene10.1016/j.tsf.2011.02.014 ↗
55. Quasi-static capacitance-voltage characteristics of pentacene-based metal-oxide-semiconductor structures10.1016/j.mejo.2013.02.017 ↗
56. Schroder · 2006
57. Study on the basic capacitance-voltage characteristics of organic molecular semiconductors10.1016/j.orgel.2015.03.002 ↗
58. A comparative investigation of electron transport properties in Li2CO3 doped and undoped organic semiconductors by admittance spectroscopy10.1016/j.orgel.2018.12.019 ↗