Properties of perovskite ferroelectrics deposited on F doped SnO 2 electrodes and the prospect of their integration into perovskite solar cells

Abstract The integration of ferroelectrics in perovskite solar cells is proposed as possible way to enhance charge collection efficiency. First results on solar cell manufactured with PbTiO 3 (PTO) instead of TiO 2 have shown negligible values for the power conversion efficiency (PCE). This is explained by the high serial resistance of sol-gel deposited PTO on F:SnO 2 electrodes (FTO). Although PTO layer has remnant polarization of 22 μC/cm 2 , the high potential barrier (0.25 ± 0.05 eV) at the FTO/PTO interface and low carrier mobility (10 − 8 cm 2 V − 1 s − 1 ) compared to TiO 2 leads to high serial resistance. Better results were obtained with thinner PTO layers grown by pulsed laser deposition, with PCE values up to 0.6%. Further enhancement was obtained by replacing PTO with BaTiO 3 (BTO), with PCE value reaching about 0.8% after poling the cell with + 3 V. The most important finding was that the magnitude of the short circuit current increases with the amplitude of the poling voltage while the value of the open-circuit voltage remains about the same, around 0.9 V. This is explained through more efficient collection of the charges generated under illumination in the absorber layer due to the polarization that is present in the ferroelectric film.