journal article·2026-06Open access

Effect of sputtering working pressure on InZnO and InZnMgO thin films and their application to solar cells

Dwinanri Egyna, Yoshihiro Oketou, Shogo Ishizuka, Yukiko Kamikawa, Jiro Nishinaga, Takayuki Negami, Abdurashid Mavlonov, Takashi Minemoto

Abstract

Transparent conductive oxides represent a critical materials platform for modern optoelectronic applications, particularly in photovoltaic devices where the transparent electrode substantially influences device performance parameters. This investigation examined the systematic effects of sputtering working pressure on the structural, optical, and electrical properties of InZnO (IZO) and Mg-doped IZO (IZMO) thin films deposited via radiofrequency magnetron sputtering. Results demonstrate that reducing working pressure enhances carrier mobility from 8.48 to 31.8 cm 2 /V·s and increases carrier concentration while widening optical bandgap. However, the dominant mechanism for bandgap widening differs between the two systems: for IZO, it is primarily attributed to reduced defect states from improved short-range order, while for IZMO, both the Burstein-Moss effect and defect reduction contribute. The Mg-doped variant exhibited superior photovoltaic performance, achieving 18.97% efficiency in Cu(In,Ga)Se 2 solar cells compared to 17.03% for the undoped composition. These findings establish material-specific optimal deposition conditions—with IZMO achieving peak performance at a higher working pressure (1.50 Pa) than IZO (0.25 Pa)—and demonstrate that compositional engineering effectively balances competing optical and electrical properties for enhanced device performance. • Systematic investigation of sputtering pressure effects on InZnO and InZnMgO thin films. • Lower deposition pressure enhances conductivity and widens the optical bandgap. • Mg-doping effectively breaks the inherent trade-off in transparent conductor performance. • InZnMgO based CIGSe solar cells achieved 18.97% PCE, outperforming InZnO.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: ZnO doping and properties · Chalcogenide Semiconductor Thin Films · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (60)

Show source-provided references
1. Flexible transparent heteroepitaxial conducting oxide with mobility exceeding 100 cm2 V− 1 s− 1 at room temperature10.1038/s41427-020-00251-2 ↗
2. Deposition of high-transmittance ITO thin films on polycarbonate substrates for capacitive-touch applications10.1016/j.vacuum.2021.110046 ↗
3. Advancements in transparent conductive oxides for photoelectrochemical applications10.3390/nano14070591 ↗
4. Performance limitations imposed by the TCO heterojunction in high efficiency perovskite solar cells10.1039/D2EE01742C ↗
5. Characterization of the TCO layer on a glass surface for PV IInd and IIIrd generation applications10.3390/en17133122 ↗
6. Photovoltaic performance in CIGS solar cells: effects of using Mg-and Al-doped ZnO thin-film layers as alternative TCO and front contact layer10.1007/s10854-024-13717-8 ↗
7. Benefits of low electron-affinity material as the n-type layer for Cu (In, Ga) S2 solar cell10.3390/en15010004 ↗
8. Total band alignment in theoretical and experimental aspects for enhanced performance of flexible and Cd‐free Cu (In, Ga)(S, Se) 2 solar cell fabricated by all‐dry process10.1002/pip.3616 ↗
9. Flexible and lightweight Cu (In, Ga)(S, Se) 2 solar cell on a stainless steel substrate with different structures for improving band alignment10.1016/j.solmat.2023.112589 ↗
10. Transparent conductive indium zinc oxide films: temperature and oxygen dependences of the electrical and optical properties10.3390/coatings12101583 ↗
11. Low-temperature high-mobility amorphous IZO for silicon heterojunction solar cells10.1109/JPHOTOV.2015.2450993 ↗
12. Sputtered transparent electrodes (IO: h and IZO) with low parasitic near-infrared absorption for perovskite–Cu (In, Ga) Se2 tandem solar cells10.1021/acsaem.9b01224 ↗
13. Cu (In, Ga)(S, Se) 2 solar cell with Zn (O, S, OH) x buffer on stainless steel utilizing Zn1–x Mg x O and Zn1–x Mg x O: al10.1021/acsaem.2c02814 ↗
14. Theoretical impacts of single band gap grading of perovskite and valence band offset of perovskite/hole transport layer interface on its solar cell performances10.1016/j.solener.2021.11.072 ↗
15. Influence of conduction band offset between Cu(In,Ga)Se2 absorber and Zn1−xMgxO buffer in Zn1−xMgxO:Al/Zn1−xMgxO/CdS/Cu(In,Ga)Se2 solar cell10.1021/acsaem.3c00506 ↗
16. Impact of band alignment at interfaces in perovskite-based solar cell devices10.1016/j.matpr.2023.02.117 ↗
17. Optical and electrical properties of gallium-doped MgxZn1−xO10.1063/1.3271415 ↗
18. Co-doping effects of Mg and be on properties of ZnMgBeGaO UV-range transparent conductive oxide films prepared by RF magnetron sputtering10.1016/j.jallcom.2014.06.148 ↗
19. Influence of Mg concentration in Zn1-xMgxO buffer layers for enhanced Cu2 (Sn, Ge) S3 solar cells performance10.1016/j.optmat.2024.115211 ↗
20. Application of Al-Doped (Zn, Mg) O on pure-sulfide Cu (In, Ga) S2 solar cells for enhancement of open-circuit voltage10.1016/j.solmat.2019.110157 ↗
21. Physical properties of IZO thin films deposited by ultrasonic spray pyrolysis. Effect of in concentration and precursor milling process
22. Low-temperature fabrication of IZO thin film for flexible transistors10.3390/nano11102552 ↗
23. Compositionally engineered amorphous InZnO thin-film transistor with high mobility and stability via atmospheric pressure spatial atomic layer deposition10.1016/j.jiec.2024.05.046 ↗
24. Controlled increase of indium content in IZO thin films used as window layer in solar cells
25. Room temperature deposition of pulsed laser-assisted (Al, In) co-doped ZnO transparent conducting films appropriate for flexible substrates10.1007/s10854-021-06224-7 ↗
26. Tunable‐conduction‐Band in–zn–o‐based transparent conductive oxide deposited at room temperature
27. Studies on InZnMgO amorphous buffer layer for Cu (In, Ga)(S, Se) 2 solar cell10.1016/j.ijleo.2024.172027 ↗
28. Effects of flow rate of oxygen and substrate temperature on the characteristics of IZO thin films for OLEDs
29. Impact of sputtering power on amorphous In–Al–Zn–O films and thin film transistors prepared by RF magnetron sputtering10.1109/TED.2019.2906892 ↗
30. Influence of sputtering power on the electrical properties of In-Sn-Zn oxide thin films deposited by high power impulse magnetron sputtering10.3390/coatings9110715 ↗
31. Assessing the impact of back-contact recombination on CIGS solar cells with improved crystal quality
32. Characteristics of Zn1− xMgxO: b and its application as transparent conductive oxide layer in Cu (In, Ga)(S, Se) 2 solar cells with and without CdS buffer layer10.1016/j.solener.2019.04.029 ↗
33. Zn1−xMgxO second buffer layer of Cu2Sn1-xGexS3 thin-film solar cell for minimizing carrier recombination and open-circuit voltage deficit10.1016/j.solener.2020.05.040 ↗
34. The effects of RF sputtering power and gas pressure on structural and electrical properties of ITiO thin film10.1155/2012/651587 ↗
35. Effect of deposition power and pressure on rate deposition and resistivity of titanium thin films grown by DC magnetron sputtering10.1080/00387010.2016.1212244 ↗
36. Effects of RF magnetron sputtering deposition process parameters on the properties of molybdenum thin films10.1016/j.tsf.2017.07.057 ↗
37. Working hypothesis to explore novel wide band gap electrically conducting amorphous oxides and examples10.1016/0022-3093(96)80019-6 ↗
38. Room-temperature fabrication of transparent flexible thin-film transistors using amorphous oxide semiconductors10.1038/nature03090 ↗
39. Indium-zinc-oxide thin films produced by low-cost chemical solution deposition: tuning the microstructure, optical and electrical properties with the processing conditions10.1016/j.heliyon.2023.e19744 ↗
40. Effect of sputtering working pressure on the reliability and performance of amorphous indium gallium zinc oxide thin film transistors10.1063/5.0188437 ↗
41. Decoupling free-carriers contributions from oxygen-vacancy and cation-substitution in extrinsic conducting oxides
42. Oxygen vacancies: the (in) visible friend of oxide electronics10.1063/1.5143309 ↗
43. A new fabrication method for ZnO: al thin films using modified DC magnetron sputtering10.2109/jcersj2.16228 ↗
44. Novel thin film transistors with oxide semiconductor MgIn2O4 with and without substitutional doping
45. Transparent conducting amorphous IZO thin films: an approach to improve the transparent electrode quality10.3390/ma16103740 ↗
46. Impact of pre-annealing process on electrical properties and stability of indium zinc oxide thin-film transistors10.1038/s41598-022-24093-w ↗
47. Optical properties of nanocrystalline/amorphous TiO 2 thin film deposited by rf plasma magnetron sputtering10.12693/APhysPolA.137.1068 ↗
48. Tunable optical properties of amorphous-like Ga2O3 thin films deposited by electron-beam evaporation with varying oxygen partial pressures10.3390/nano10091760 ↗
49. Effect of oxygen partial pressure on optical and electrical properties of co‐sputtered amorphous zinc indium tin oxide thin films10.1002/pssa.200824007 ↗
50. Investigation on energy bandgap states of amorphous SiZnSnO thin films
51. Fabrication and optoelectronic properties of advanced quinary amorphous oxide semiconductor InGaZnSnO thin film10.3390/ma18092090 ↗
52. Effect of oxygen amount on electrical and transparency characteristics of amorphous IGZO thin film fabricated by sputtering10.14723/tmrsj.38.593 ↗
53. General mobility and carrier concentration relationship in transparent amorphous indium zinc oxide films10.1103/PhysRevB.77.115215 ↗
54. Indium-Zinc-Tin-Oxide film prepared by reactive magnetron sputtering for electrochromic applications10.3390/ma11112221 ↗
55. Deepak, investigation of time-dependent stability and surface defects in sol–gel derived IGZO and IZO thin films10.1007/s10971-021-05615-w ↗
56. Effect of sputtering oxygen partial pressure on the praseodymium-doped InZnO thin film transistor using microwave photoconductivity decay method10.3390/mi12091044 ↗
57. Valence and conduction band offsets for sputtered AZO and ITO on (010)(Al0. 14Ga0. 86) 2O310.1088/1361-6641/aaf8d7 ↗
58. Manipulation of [Ga]/([Ga]+[In]) profile in 1.4-μm-thick Cu (In, Ga) Se2 thin film on flexible stainless steel substrate for enhancing short-circuit current density and conversion efficiency of its solar cell10.1016/j.solener.2020.04.069 ↗
59. Microscopic origins of performance losses in highly efficient Cu (In, Ga) Se2 thin-film solar cells10.1038/s41467-020-17507-8 ↗
60. Temperature dependent self-compensation in Al-and Ga-doped Mg0. 05Zn0. 95O thin films grown by pulsed laser deposition10.1063/1.4968544 ↗