article·2015-01-01Open access

Tribological behavior of PEEK and nano-TiO_2 reinforced PTFE composites

QI Yua

Open full text

Abstract

The PEEK and Nano-TiO2 particles synergetic filled PTFE composites were prepared by blending material with high speed mechanical mixer,cold press molding and sintering with temperature control program.The tribological behavior of composites was tested on different test conditions by a MRH-3 block-on-ring friction and wear tester.After testing,the transfer film on counterpart GCr15 ring was inspected and anslyzed with Quanta FEG450 scanning electronic microscopy(SEM).The results show that the special wear rate of composites filled with PEEK decreases dramatically and the friction coefficient increases gradually with the increasing content of PEEK.When 10% PEEK/PTFE composite is filled with different contents of Nano-TiO2 particles,the wear rate and the coefficient friction increase moderately with the increasing contents of nanoparticles.The lowest wear rate and coefficient friction are gained when the composite filled with 2% nano-TiO2 and 10% PEEK.Sliding speed and load,respectively,more than 2 m/s and 200 N has significantly effect on the wear rate,and ambient temperature at 25 to 120 ℃ within the scope of the impact on the volume wear rate and friction coefficient are not obvious.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Tribology and Wear Analysis · Polymer Nanocomposites and Properties · Synthesis and properties of polymers

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.