article·2015-01-01Open access

Effects of semi-solid microstructure on plasticity and latent heat of Sn-52Bi alloy

HU Yong-ju

Open full text

Abstract

The hypo eutectic semi-solid Sn-52 Bi slurry at 150 ℃ was mechanically agitated for 5,10 and 15 min,respectively,and cooled by water after vacuum suction casting. The microstructure,mechanical property and latent heat of semi-solid Sn-52 Bi were tested. The effect of the shear force on the microstructure evolution of low solid fraction of Sn-52 Bi semi-solid slurry and the correlation between elongation and latent heat of semi-solid alloys were investigated. The results show that during mechanical agitation of the semi-solid Sn-52 Bi slurry,the shear force can inhibit the formation of dendritic primary Sn phase. The microstructure of semi-solid Sn-52 Bi alloy consists of non-dendrite primary Sn and the eutectic. With the stirring time increase,primary Sn phase changes from short mallet particles to nearly spherical particles with the diameter of about 20 μm. When the time of mechanical stir increase to 15 minutes,the diameter of spherical primary Sn phase becomes smaller,but the particles appear aggregation to some extent. The elongation of semi-solid Sn-52 Bi alloy obtained by mechanical stirring speed of 320 r / min for 10 min is 46. 75%,which is improved distinctly by129. 10%,compared to conventional liquid casting Sn-52 Bi alloy. The analysis of DSC curve shows the endothermic peak temperature of the semi-solid Sn-52 Bi alloys prepared by different time of mechanical stir is 140 ℃. The higher the elongation is,the smaller the latent heat is.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Intermetallics and Advanced Alloy Properties · Metallurgy and Material Forming

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.