Preparation of super-hydrophobic polyvinylidene fluoride separation membrane
Source abstract
Abstract
The surface of polyvinylidene fluride(PVDF) hollow fiber membranes was modified by non-solvent induced phase separation and then obtained super-hydrophobic separation membranes.The influences of PVDF percentage composition in the coating solution and coating conditiongs(such as:soaking time,pre-evaporation time,coagulation bath composition and coagulation bath temperature) were researched.The results show that composite membranes had the largest contact angle that was 136°when PVDF solid content is 1.88wt% in the coating solution;with the extension of soaking time,the contact angle of composite membrane at first increase and then decreased,when the soaking time is 40s,the contact angle reach to a maximum of 133°;in a relatively short period of time(0-5s),the pre-evaporation time have little effect on the contact angle of composite membrane;contact angle of composite membrane decrease with DMAc concentration in the coagulation bath increase,but increase with the coagulation bath temperature increase,when the coagulation bath temperature is 65℃,the membrane surface contact angle increase to 153°.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Membrane Separation and Gas Transport · Membrane Separation Technologies · Surface Modification and Superhydrophobicity
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.