Research on preparation for composite materials by evaporative pattern casting process
Source abstract
Abstract
In this paper, orthogonal test was carried out to investigate the factors, such as pouring temperature, alloy powder size, flux content and binder content on process of surface alloying in evaporative pattern casting process. Constitutes of the coating were determined. The surface chromizing composites with cast iron HT200 were prepared. Microstructure and properties of the alloying layer were studied. The results showed that: a suitable coating for surface alloying consists of Cr Fe powder with a diameter of 0.127 to 0.181mm, phenolic resin 2wt%, the compound flux 7.5wt%, CMC 0.5wt%, water and some trace additives. The appropriate pouring temperature is about 1400 to 1500℃. The surface alloying layers consisted of three zones, and with the increase of the distance from the surface, the carbide was transformed from M 7C 3 to M 3C and the hardness of the alloying layers decrease gradually. Among the factors acting on the process of surface alloying, pouring temperature was the most prominent, alloy powder size secondary, binder content the third, and flux content the least; wear resistant properties of the alloying layer were high, and 2.8 times as higher as that of 45# steel, respectively.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Tribology and Lubrication Engineering · High-Temperature Coating Behaviors
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.