Preparation and cutting performance of TiCN-based functionally gradient cermets
Source abstract
Abstract
TiCN-based functionally gradient cermets were prepared by controlling of the composition and atmosphere and by using TiCN-WC-Mo2C-TaC-Co-Ni as experimental materials.Material microstructure and phase composition were observed and analyzed by scanning electron microscopy with EDS and X-ray diffractometer,and the cutting performance was investigated by turning.The result shows that TiCN-based functionally gradient cermets with Ti-enriched surface layer,W-enriched middle layer and the bottom were obtained by the control of atmosphere when WC content was lower.Appropriate increasing of the sintering temperature was benefit to increase the thickness of gradient layers.WC was concentration at the surface when WC content was higher in raw composition sintering at nitrogen gas.The thickness of Ti and W enriched layer was about 15-20 μm when 15% WC-TiCN based ceramics sintered at 1 460 ℃ in nitrogen atmosphere for 1 h.The(Ti,W,Mo)(C,N) diffraction peaks of the material surface shift to the right relative to the internal after nitriding sintering.In vacuum sintering,the element of Ti and W was distributed uniform in a vacuum sintering when WC content was low.With the increase of WC content,the layers with poor Ti and W-enriched in gradually were appeared on the surface;in the meantime,the thickness of W-enriched on surface layer was increased.When WC content was 24%,W-enriched layer thickness was more than 25 μm.Cutting experiment shows that TiCN-based functionally gradient cermets with Ti-enriched surface layer was superior than that with W-enriched surface.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced materials and composites · Metal and Thin Film Mechanics · Orthopaedic implants and arthroplasty
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.