Long-Term Stability of Mold Compounds and the Influence on Semiconductor Device Reliability
Source abstract
Abstract
Lifetimes of semiconductor devices are specified according to the products and their applications to ensure safe operation, for instance as part of an automobile product. The long-term stability of the device is strongly dependent on the chip encapsulation and its adhesion to the chip and substrate. Molded silicon strips that act as a model system for molded chips inside semiconductor devices were investigated. Four commercially available mold compounds were applied on silicon strips and stored over 5 years at room temperature (RT), and changes in the thermomechanical behavior were analyzed. After storage, all molded strips exhibited warpage reduction in the range of 11% to 14% at RT with respect to the initial warpage. The temperatures for the stress-free state also changed during storage and were located between 228°C and 235°C for each mold. Additional stress applied to the stored modules, by temperature cycling as well as high-temperature storage, increased the warpage of the molded silicon samples. For further interpretation of measured results, finite-element method calculations were performed.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Electronic Packaging and Soldering Technologies · 3D IC and TSV technologies · Silicon and Solar Cell Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (11)
Show source-provided references
1. AEC (Automotive Electronics Council), www.aecouncil.com and www.onsemi.com/pub_link/Collateral/TND387-D.PDF , p. 13. Accessed 17th June 2011.
2. JEDEC (Joint Electron Device Engineering Council) Standard No. 22-A104-B.
3. M. Mengel and J. Mahler, J. Electron. Mater. 38, 2362 (2009).10.1007/s11664-009-0886-0 ↗
4. M. Lebbai, K. Jang-Kyo, and M.M.F. Yeun, J. Electron. Mater. 32, 574 (2003).10.1007/s11664-003-0144-9 ↗
5. E. Nguegang, J. Franz, A. Kretschmann, and H.E. Sandmaier, 11th International Conference on Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microelectronics and Microsystems (EuroSimE) (2010), p. 28.
6. S. Noijen, R. Engelen, J. Martens, A. Opran, and O. van der Sluis, 10th International Conference on Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microelectronics and Microsystems (EuroSimE) (2009), p. 215.
7. M. Xiaosong, K.M.B. Jansen, L.J. Ernst, W.D. van Driel, O. van der Sluis, G.Q. Zhang, C. Regard, C. Gautier, and H. Fremont, 9th International Conference on Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microelectronics and Microsystems (EuroSimE) (2008), 361.
8. A. Teverovsky, Effects of Environments on Degradation of Molding Compound and Wire Bonds in PEMs, NASA Electronic Parts and Packaging Program—Reliability of COTS-PEMs (2005).
9. www.akrometrics.com . Accessed 10th June 2011.
10. www.sonoscan.com . Accessed 15th June 2011.
11. www.ansys.com . Accessed 6th May 2011.