Ti/Pd/Ag Contacts to n-Type GaAs for High Current Density Devices
Source abstract
Abstract
The metallization stack Ti/Pd/Ag on n-type Si has been readily used in solar cells due to its low metal/semiconductor specific contact resistance, very high sheet conductance, bondability, long-term durability, and cost-effectiveness. In this study, the use of Ti/Pd/Ag metallization on n-type GaAs is examined, targeting electronic devices that need to handle high current densities and with grid-like contacts with limited surface coverage (i.e., solar cells, lasers, or light emitting diodes). Ti/Pd/Ag (50 nm/50 nm/1000 nm) metal layers were deposited on n-type GaAs by electron beam evaporation and the contact quality was assessed for different doping levels (from 1.3 × 1018 cm−3 to 1.6 × 1019 cm−3) and annealing temperatures (from 300°C to 750°C). The metal/semiconductor specific contact resistance, metal resistivity, and the morphology of the contacts were studied. The results show that samples doped in the range of 1018 cm−3 had Schottky-like I–V characteristics and only samples doped 1.6 × 1019 cm−3 exhibited ohmic behavior even before annealing. For the ohmic contacts, increasing annealing temperature causes a decrease in the specific contact resistance (ρ c,Ti/Pd/Ag ~ 5 × 10−4 Ω cm2). In regard to the metal resistivity, Ti/Pd/Ag metallization presents a very good metal conductivity for samples treated below 500°C (ρ M,Ti/Pd/Ag ~ 2.3 × 10−6 Ω cm); however, for samples treated at 750°C, metal resistivity is strongly degraded due to morphological degradation and contamination in the silver overlayer. As compared to the classic AuGe/Ni/Au metal system, the Ti/Pd/Ag system shows higher metal/semiconductor specific contact resistance and one order of magnitude lower metal resistivity.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Semiconductor materials and interfaces · solar cell performance optimization · Silicon and Solar Cell Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. L.J. Brillson, Contacts to Semiconductors: Fundamentals and Technology (Park Ridge, New Jersey: Noyes, 1993), pp. 1–3.
2. D.K. Schroder and D.L. Meier, IEEE Trans. Electron. Dev. 31, 637 (1984).10.1109/T-ED.1984.21583 ↗
3. V.L. Rideout, Solid State Electron. 18, 541 (1975).10.1016/0038-1101(75)90031-3 ↗
4. A. Piotrowska, A. Guivarc’h, and G. Pelous, Solid State Electron. 26, 179 (1983).10.1016/0038-1101(83)90083-7 ↗
5. A. Piotrowska, Acta Phys. Pol. A 84, 491 (1993).10.12693/APhysPolA.84.491 ↗
6. A.G. Baca, F. Ren, J.C. Zolper, R.D. Briggs, and S.J. Pearton, Thin Solid Films 308–309, 599 (1997).10.1016/S0040-6090(97)00439-2 ↗
7. D.L. Meier and D.K. Schroder, IEEE Trans. Electron. Dev. 31, 647 (1984).10.1109/T-ED.1984.21584 ↗
8. A.R. Burgers, Prog. Photovolt. 7, 457 (1999).10.1002/(SICI)1099-159X(199911/12)7:6<457::AID-PIP278>3.0.CO;2-U ↗
9. M.M. Shabana, M.B. Saleh, and M.M. Soliman, Solar Cells 26, 177 (1989).10.1016/0379-6787(89)90079-3 ↗
10. N. Braslau, J.B. Gunn, and J.L. Staples, Solid State Electron. 10, 381 (1967).10.1016/0038-1101(67)90037-8 ↗
11. T.S. Kuan, P.E. Batson, T.N. Jackson, H. Rupprecht, and E.L. Wilkie, J. Appl. Phys. 54, 6952 (1983).10.1063/1.332011 ↗
12. Y.C. Shih, M. Murakami, E.L. Wilkie, and A.C. Callegari, J. Appl. Phys. 62, 582 (1987).10.1063/1.339860 ↗
13. A.G. Baca and C.I.H. Ashby, Fabrication of GaAs Devices (London: Institution of Electrical Engineers, 2005), p. 196.10.1049/PBEP006E ↗
14. Y. Wang, D. Liu, G. Feng, Z. Ye, Z. Gao, and X. Wang, J. Semicond. 36, 036002 (2015).10.1088/1674-4926/36/3/036002 ↗
15. J. Zhou, G. Xia, B. Li, and W. Liu, Appl. Phys. A 76, 939 (2003).10.1007/s00339-002-1439-z ↗
16. H. Cotal, C. Fetzer, J. Boisvert, G. Kinsey, R. King, P. Hebert, H. Yoon, and N. Karam, Energy. Environ. Sci. 2, 174 (2009).10.1039/B809257E ↗
17. W.K. Chong, E.F. Chor, C.H. Heng, and S.J. Chua, Inst. Phys. Conf. Ser. 156, 171 (1998).
18. K.C. Sahoo, C.W. Chang, Y.Y. Wong, T.L. Hsieh, E.Y. Chang, and C.T. Lee, J. Electron. Mater. 37, 901 (2008).10.1007/s11664-008-0398-3 ↗
19. D.G. Ivey, S. Eicher, S. Wingar, and T. Lester, J. Mater. Sci. 8, 63 (1997).
20. C.-H. Hsu, H.-J. Chang, H.-W. Yu, H.-Q. Nguyen, J.-S. Ma, E.Y. Chang, and I.E.E.E. Int, Conf. Semicond. Electron. (2014). doi: 10.1109/SMELEC.2014.6920866 .
21. C. Gutsche, A. Lysov, I. Regolin, A. Brodt, L. Liborius, J. Frohleiks, W. Prost, and F.-J. Tegude, J. Appl. Phys. 110, 014305 (2011).10.1063/1.3603041 ↗
22. T.V. Blank and Y.A. Gol’dberg, Semiconductors 41, 1263 (2007).10.1134/S1063782607110012 ↗
23. H. Fischer and R. Gereth, IEEE Trans. Electron. Dev. 18, 459 (1971).10.1109/T-ED.1971.17228 ↗
24. X. Loozen, J.B. Larsen, F. Dross, M. Aleman, T. Bearda, B.J. O’Sullivan, I. Gordon, and J. Poortmans, Energy Procedia 21, 75 (2011).10.1016/j.egypro.2012.05.010 ↗
25. A.K. Sinha, T.E. Smith, M.H. Read, and J.M. Poate, Solid State Electron. 19, 489 (1976).10.1016/0038-1101(76)90012-5 ↗
26. B.K. Sehgal, B. Bhattacharya, S. Vinayak, and R. Gulati, Thin Solid Films 330, 146 (1998).10.1016/S0040-6090(98)00756-1 ↗
27. T. Göksu, N. Yıldırım, H. Korkut, A.F. özdemir, A. Turut, and A. Kökçe, Microelectron. Eng. 87, 1781 (2010).10.1016/j.mee.2009.10.012 ↗
28. I.-H. Tan, G.L. Snider, L.D. Chang, and E.L. Hu, J. Appl. Phys. 68, 4071 (1990).10.1063/1.346245 ↗
29. E.F. Chor, D. Zhang, H. Gong, W.K. Chong, and S.Y. Ong, J. Appl. Phys. 87, 2437 (2000).10.1063/1.372198 ↗
30. K.A. Jones, M.W. Cole, W.Y. Han, D.W. Eckart, K.P. Hilton, M.A. Crouch, and B.H. Hughes, J. Appl. Phys. 82, 1723 (1997).10.1063/1.365973 ↗
31. A. Katz, C.R. Abernathy, and S.J. Pearton, Appl. Phys. Lett. 56, 1028 (1990).10.1063/1.102605 ↗
32. G.K. Reeves and H.B. Harrison, IEEE Electr. Device Lett. 3, 111 (1982).10.1109/EDL.1982.25502 ↗
33. L.J. van der Pauw, Philips Res. Rep. 13, 1 (1958).
34. J.-L. Lee, Y.-T. Kim, J.-W. Oh, and B.-T. Lee, Jpn. J. Appl. Phys. 40, 1188 (2001).10.1143/JJAP.40.1188 ↗
35. O. Wada, S. Yanagisawa, and H. Takanashi, Appl. Phys. Lett. 29, 263 (1976).10.1063/1.89039 ↗
36. M. Kniffin and C.R. Helms, J. Vac. Sci. Technol. A 5, 1511 (1987).10.1116/1.574593 ↗