Effect of Firing Conditions on Phase Formation, Microstructure, and Electrical Properties of (K0.5Na0.5)(Nb0.7Ta0.3)O3 Ceramics Synthesized by Solid-State Combustion Method
Source abstract
Abstract
The effect of the firing conditions on the phase formation, microstructure, and electrical properties of (K0.5Na0.5)(Nb0.7Ta0.3)O3 (KNNT) ceramics synthesized by the solid-state combustion technique using glycine as fuel has been investigated. All samples were calcined at 600°C to 800°C for 2 h and sintered at 1150°C to 1190°C for 2 h to 5 h. Pure KNNT powders were produced after calcination at 600°C for 2 h. The average particle size increased when the calcination temperature was increased. The KNNT powder calcined at 600°C for 2 h showed rather square morphology with average particle size of ∼ 160 nm. The x-ray diffraction (XRD) analysis results for the ceramics revealed the presence of orthorhombic (O) and tetragonal (T) phases in all samples. When sintering at 1150°C for 4 h, the O:T ratio was 50:50, as verified by the Rietveld refinement technique. The average grain size, density values, and dielectric properties tended to increase when the dwell time was increased from 2 h to 4 h, but then degraded. The KNNT ceramic produced at the optimum firing condition (1150°C for 4 h) showed good crystalline morphology, the highest density (ρ = 5.28 g/cm3), the highest dielectric constant (eC = 5002), and good ferroelectric behavior (Pr = 18.50 μC/cm2 and Ec = 9.04 kV/cm).
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Ferroelectric and Piezoelectric Materials · Microwave Dielectric Ceramics Synthesis · Electronic and Structural Properties of Oxides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (45)
Show source-provided references
1. Y.H. Seo, D.J. Franzbach, J. Koruza, A. Bencan, B. Malic, M. Kosec, J.L. Jones, and K.G. Webber, Phys. Rev. Lett. 84, 5423 (2000).10.1103/PhysRevLett.84.5423 ↗
2. L. Bellaiche, A. García, and D. Vanderbilt, Phys. Rev. Lett. 84, 5427 (2000).10.1103/PhysRevLett.84.5427 ↗
3. N. Ledermann, P. Muralt, J. Baborowski, S. Gentil, K. Mukati, M. Cantoni, A. Seifert, and N. Setter, Sens. Actuators, A. 105 (2), 162 (2003).10.1016/S0924-4247(03)00090-6 ↗
4. A.W.J. Hewat, J. Phys. C: Solid State Phys. 6, 2559 (1973).10.1088/0022-3719/6/16/010 ↗
5. J. Wu, D. Xiao, and J. Zho, J. Am. Chem. Soc. 115, 2559 (2015).
6. G.A. Somlenskii, V.A. Isupov, A.I. Agranovskaya, and N.N. Krainik, Phys. Solid State 2, 2651 (1961).
7. W.G. Cady, Piezoelectricity (New York: McGraw-Hill, 1946), pp. 1–20.
8. B. Jaffe, W.R. Cook, and H. Jaffe, Piezoelectric Ceramics (London: Academic, 1971).
9. D. Xiao, J. Wu, L. Wu, J. Zhu, P. Yu, D. Lin, Y. Liao, and Y.J. Sun, Mater. Sci. 44, 5408 (2009).10.1007/s10853-009-3543-3 ↗
10. P.K. Panda, J. Mater. Sci. 44, 5049 (2009).10.1007/s10853-009-3643-0 ↗
11. J. Rodel, W. Jo, K.T.P. Seifert, E. Anton, T. Granzow, and D. Damjanovic, J. Am. Ceram. Soc. 89, 1153 (2009).10.1111/j.1551-2916.2009.03061.x ↗
12. P. Kumar, M. Pattanaik, and Sonia, Ceram. Int. 39, 65 (2013).10.1016/j.ceramint.2012.05.093 ↗
13. L. Lu, Q.G. Yue, J.G. Lun, D. Hui, F.Y. Xi, and J.Z. Xue, Mater. Des. 33, 362 (2012).10.1016/j.matdes.2011.07.025 ↗
14. F. Jean, F. Scjpemsteom, M. Zaghrioui, M. Bah, P. Marchet, J. Bustillo, and F. Giovannelli, Ceram. Int. 44, 9463 (2018).10.1016/j.ceramint.2018.02.163 ↗
15. Y.G. Lv, C.L. Wang, J.L. Zhang, L. Wu, M.L. Zhao, and J.P. Xu, Mater. Res. Bull. 44, 284 (2009).10.1016/j.materresbull.2008.06.019 ↗
16. Z. Yuan, G. Min, Z. Ci, and Z. Mei, Ceram. Int. 35, 3253 (2009).10.1016/j.ceramint.2009.05.018 ↗
17. C. Kornphom, S.Yotthuan, S. Chootin, and T. Bongkarn, Phys. Status Solid A. 1701058 (2018).10.1002/pssa.201701058 ↗
18. P. Bhupaijit, C. Kornphom, N. Vittayakorn, and T. Bongkarn, Ceram. Int. 41, S81 (2015).10.1016/j.ceramint.2015.03.226 ↗
19. C. Wattanawikkam, N. Vittayakorn, and T. Bongkarn, Ceram. Int. 39, S399 (2013).10.1016/j.ceramint.2012.10.102 ↗
20. Powder Diffraction File No. 01-071-0946, International Centre for Diffraction Data, Newton Square, PA, 2000.
21. Powder Diffraction File No. 01-074-2486, International Centre for Diffraction Data, Newton Square, PA, 2000.
22. R.K. Lenka, T. Mahata, P.K. Sinha, and A.K. Tyagi, J. Alloys Compd. 466, 326 (2008).10.1016/j.jallcom.2007.11.028 ↗
23. N. Nandini, M. Krishna, A.V. Suresh, and H.N. Narasimha Murthy, Mater. Sci. Eng. B. 231, 40 (2018).10.1016/j.mseb.2018.09.001 ↗
24. Z. Yu, C. Ang, R. Guo, and A.S. Bhalla, J. Appl. Phys. 92, 1489 (2002).10.1063/1.1487435 ↗
25. R. Sumang, C. Wicheanrat, T. Bongkarn, and S. Maensiri, Ceram. Int. 41, S136 (2015).10.1016/j.ceramint.2015.03.228 ↗
26. B. Malic, J. Bernard, A. Bencan, and M. Kosec, J. Eur. Ceram. Soc. 28, 1191 (2008).10.1016/j.jeurceramsoc.2007.11.004 ↗
27. C. Hua-Iei, Z. Wan-cheng, D.U. Hong-liang, L.U.O. Fa, and Z.H.U. Dong-mei, Trans. Nonferrous Met. Soc. China 23, 2984 (2013).10.1016/S1003-6326(13)62824-1 ↗
28. W. Jiagang, X. Dingquan, W. Wenjuan, Z. Jianguo, and W. John, J. Alloys Compd. 509, L359 (2011).10.1016/j.jallcom.2011.08.024 ↗
29. Powder Diffraction File No. 01-071-0945, International Centre for Diffraction Data, Newton Square, PA, 2000.
30. S. Monica, A. Neetu, S. Sujata, A. Ashish, D. Reetu, and A. Navneet, Curr. Appl. Phys. 12, 1429 (2012).10.1016/j.cap.2012.03.034 ↗
31. R. Cong, G. Qiu, C. Yue, M. Guo, F. Cheng, and M. Zhang, Ceram. Int. 44, 19764 (2018).10.1016/j.ceramint.2018.07.232 ↗
32. M. Zhong, J. Li, J. Shao, Y. Cao, K. Li, and W. Zhao, Ceram. Int. 45, 14983 (2019).10.1016/j.ceramint.2019.04.235 ↗
33. Z. Cen, Y. Zhen, W. Feng, P. Zhao, L. Chen, X. Wang, and L. Li, J. Eur. Ceram. Soc. 38, 3136 (2018).10.1016/j.jeurceramsoc.2018.03.033 ↗
34. P.R. Bueno, E.R. Leite, L.O.S. Bulhoes, E. Longo, and C.O. Paiva-Santos, J. Eur. Ceram. Soc. 23, 887 (2003).10.1016/S0955-2219(02)00234-0 ↗
35. M. Sun, J. Du, C. Chen, P. Fu, P. Li, J. Hao, Z. Yue, and W. Li, Ceram. Int. (2020).
36. Y.H. Zhen and J.F. Li, J. Am. Ceram. Soc. 89, 3669 (2006).10.1111/j.1551-2916.2006.01313.x ↗
37. C. Fang, L. Chen, and D. Zhou, Phys. B 409, 83 (2013).10.1016/j.physb.2012.10.016 ↗
38. S.V. Trukhanov, A.V. Trukhanov, H. Szymczak, R. Szymczak, and M. Baran, J. Phys. Chem. Solids 67, 675 (2006).10.1016/j.jpcs.2005.09.099 ↗
39. S.V. Trukhanov, A.V. Trukhanov, S.G. Stepin, H. Szymczak, and C.E. Botez, Phys. Solid State 50, 849 (2008).10.1134/S1063783408050144 ↗
40. X.G. Tang, K.H. Chew, and H.L.W. Chan, Acta Mater. 52, 5177 (2004).10.1016/j.actamat.2004.07.028 ↗
41. Y. Tian, L. Cao, S. Li, S. Fu, Z. Chen, X. Ji, and Q. Jing, Phys. Status Solidi A 216, 1800622 (2019).10.1002/pssa.201800622 ↗
42. S.V. Trukhanov, L.S. Lobanovski, M.V. Bushinsky, V.A. Khomchenko, N.V. Pushkarev, I.O. Troyanchuk, A. Maignan, D. Flahaut, H. Szymczak, and R. Szymczak, Eur. Phys. J. B 42, 51 (2004).10.1140/epjb/e2004-00357-8 ↗
43. S.V. Trukhanov, I.O. Troyanchuk, V.A. Khomchenko, I.M. Fita, A.N. Vasil’ev, A. Maignan, and H. Szymczak, JETP Lett. 83, 36 (2006).10.1134/S0021364006010085 ↗
44. I. Coondoo, N. Panwar, H. Amorin, V.E. Ramama, M. Alguero, and A. Kholkin, J. Am. Ceram. Soc. 98, 3127 (2015).10.1111/jace.13713 ↗
45. T. Bongkarn, S. Chootin, S. Pinitsoontorn, and S. Maensiri, J. Alloys Compd. 682, 14 (2016).10.1016/j.jallcom.2016.04.285 ↗