journal article·2022-12

Thermoelectric Material Transport Properties-Based Performance Analysis of a Concentrated Photovoltaic–Thermoelectric System

Aminu Yusuf, Sedat Ballikaya, Hasan Tiryaki

Journal of Electronic Materials· Volume 51· Issue 12
Publisher page

Abstract

A concentrated photovoltaic-thermoelectric (CPV-TE) hybrid system, if operated properly, can generate higher output power than a stand-alone concentrated photovoltaic system, due to the contribution of a thermoelectric generator in the system. Herein, to understand the effect of the transport properties of thermoelectric (TE) materials on the hybrid system, a figure of merit-based analysis is conducted. The results reveal that the output performance of the TE module can be enhanced by almost 100% when the value of the dimensionless figure of merit increases from 1 to 2. Moreover, at higher concentration ratios, the output power of the TE module with an average figure of merit of 2 can exceed that of the photovoltaic cell. Under the same circumstances, the energy efficiency of the hybrid system increases with an increase in the concentration ratio. Furthermore, the output performance of the CPV-TE hybrid system can be improved if TE materials with very low thermal conductivity are used. [GRAPHICS] .
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced Thermoelectric Materials and Devices · Thermal Radiation and Cooling Technologies · Thermal properties of materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (38)

Show source-provided references
1. S.S. Das, P. Kumar, and S.S. Sandhu, Hybrid Photovoltaic-Thermal Systems Utilizing Liquid–Gas Phase Change Material. Energy Sources Part A Recovery Util. Environ. Eff. 43, 2896 (2021).10.1080/15567036.2019.1659459 ↗
2. G.J. Snyder and T.S. Ursell, Thermoelectric Efficiency and Compatibility. Phys. Rev. Lett. 91, 148301 (2003).10.1103/PhysRevLett.91.148301 ↗
3. G.J. Snyder, Application of the Compatibility Factor to the Design of Segmented and Cascaded Thermoelectric Generators. Appl. Phys. Lett. 84, 2436 (2004).10.1063/1.1689396 ↗
4. A. Yusuf and S. Ballikaya, Modelling a Segmented Skutterudite-Based Thermoelectric Generator to Achieve Maximum Conversion Efficiency. Appl. Sci. 10, 408 (2020).10.3390/app10010408 ↗
5. Z. Ouyang and D. Li, Modelling of Segmented High Performance Thermoelectric Generators with Effects of Thermal Radiation, Electrical and Thermal Contact Resistances. Sci. Rep. 6, 24123 (2016).10.1038/srep24123 ↗
6. Q. Zhang, J. Liao, Y. Tang, M. Gu, C. Ming, P. Qiu, S. Bai, X. Shi, C. Uher, and L. Chen, Realizing a Thermoelectric Conversion Efficiency of 12% in Bismuth Telluride/Skutterudite Segmented Modules through Full-PARAMETER OPTIMIZATION and Energy-Loss Minimized Integration. Energy Environ. Sci. 10, 956 (2017).10.1039/C7EE00447H ↗
7. A. Yusuf and S. Ballikaya, Electrical, Thermomechanical and Cost Analyses of a Low-Cost Thermoelectric Generator. Energy 241, 122934 (2022).10.1016/j.energy.2021.122934 ↗
8. A. Yusuf, N. Bayhan, H. Tiryaki, B. Hamawandi, M.S. Toprak, and S. Ballikaya, Multi-objective Optimization of Concentrated Photovoltaic-Thermoelectric Hybrid System via Non-dominated Sorting Genetic Algorithm (NSGA II). Energy Convers. Manag. 236, 114065 (2021).10.1016/j.enconman.2021.114065 ↗
9. P. Sundarraj, S.S. Roy, R.A. Taylor, and D. Maity, Energy Sources, Performance Analysis of a Hybrid Solar Thermoelectric Generator. Part A Recovery Util. Environ. Eff. 38, 2977 (2016).
10. S. Ballikaya, N. Uzar, S. Yildirim, H. Chi, X. Su, G. Tan, X. Tang, and C. Uher, Lower Thermal Conductivity and Higher Thermoelectric Performance of Fe-Substituted and Ce, Yb Double-Filled p-Type Skutterudites. J. Electron. Mater. 42, 1622 (2013).10.1007/s11664-012-2357-2 ↗
11. Z. Liu and G. Chen, Advancing Flexible Thermoelectric Devices with Polymer Composites. Adv. Mater. Technol. 5, 2000049 (2020).10.1002/admt.202000049 ↗
12. C. Zhou, Y.K. Lee, Y. Yu, S. Byun, Z.-Z. Luo, H. Lee, B. Ge, Y.-L. Lee, X. Chen, J.Y. Lee, O. Cojocaru-Mirédin, H. Chang, J. Im, S.-P. Cho, M. Wuttig, V.P. Dravid, M.G. Kanatzidis, and I. Chung, Polycrystalline SnSe with a Thermoelectric Figure of Merit Greater Than the Single Crystal. Nat. Mater. 20, 1378 (2021).10.1038/s41563-021-01064-6 ↗
13. A. Yusuf and S. Ballikaya, Thermal Resistance Analysis of Trapezoidal Concentrated Photovoltaic Thermoelectric Systems. Energy Convers. Manag. 250, 114908 (2021).10.1016/j.enconman.2021.114908 ↗
14. E. Yin, Q. Li, and Y. Xuan, Thermal Resistance Analysis and Optimization of Photovoltaic-Thermoelectric Hybrid System. Energy Convers. Manag. 143, 188 (2017).10.1016/j.enconman.2017.04.004 ↗
15. A. Abdo, T. Saito, S. Ookawara, A. Radwan, and M. Ahmed, Experimental Study of the Performance of Concentrator Photovoltaic/Thermoelectric Generator System Integrated with a New 3D Printed Microchannel Heat Sink. Int. J. Energy Res. 45, 7741 (2021).10.1002/er.6359 ↗
16. D. Chandan, U.C. Arunachala, and K. Varun, Improved Energy Conversion of a Photovoltaic Module-Thermoelectric Generator Hybrid System with Different Cooling Techniques: Indoor and Outdoor Performance Comparison. Int. J. Energy Res. 46, 9498 (2022).10.1002/er.7820 ↗
17. F. Rajaee, M.A.V. Rad, A. Kasaeian, O. Mahian, and W.-M. Yan, Experimental Analysis of a Photovoltaic/Thermoelectric Generator Using Cobalt Oxide Nanofluid and Phase Change Material Heat Sink. Energy Convers. Manag. 212, 112780 (2020).10.1016/j.enconman.2020.112780 ↗
18. J. Darkwa, J. Calautit, D. Du, and G. Kokogianakis, A Numerical and Experimental Analysis of an Integrated TEG-PCM Power Enhancement System for Photovoltaic Cells. Appl. Energy 248, 688 (2019).10.1016/j.apenergy.2019.04.147 ↗
19. A. Abdo, S. Ookawara, and M. Ahmed, Performance Evaluation of a New Design of Concentrator Photovoltaic and Solar Thermoelectric Generator Hybrid System. Energy Convers. Manag. 195, 1382 (2019).10.1016/j.enconman.2019.04.093 ↗
20. Y. Gao, D. Wu, Z. Dai, C. Wang, B. Chen, and X. Zhang, Performance Analysis of a Hybrid Photovoltaic-Thermoelectric Generator System Using Heat Pipe as Heat Sink for Synergistic Production of Electricity. Energy Convers. Manag. 249, 114830 (2021).10.1016/j.enconman.2021.114830 ↗
21. E.J.H. Skjølstrup and T. Søndergaard, Design and Optimization of Spectral Beamsplitter for Hybrid Thermoelectric-Photovoltaic Concentrated Solar Energy Devices. Sol. Energy 139, 149 (2016).10.1016/j.solener.2016.09.036 ↗
22. F.J. Willars-Rodríguez, E.A. Chávez-Urbiola, P. Vorobiev, and Yu.V. Vorobiev, Investigation of Solar Hybrid System with Concentrating Fresnel lens, Photovoltaic and Thermoelectric Generators. Int. J. Energy Res. 41, 377 (2017).10.1002/er.3614 ↗
23. G. Li, K. Zhou, Z. Song, X. Zhao, and J. Ji, Inconsistent Phenomenon of Thermoelectric Load Resistance for Photovoltaic–Thermoelectric Module. Energy Convers. Manag. 161, 155 (2018).10.1016/j.enconman.2018.01.079 ↗
24. E. Yin, Q. Li, and Y. Xuan, Experimental Optimization of Operating Conditions for Concentrating Photovoltaic-Thermoelectric Hybrid System. J. Power Sources 422, 25 (2019).10.1016/j.jpowsour.2019.03.034 ↗
25. G. Li, S. Shittu, X. Ma, and X. Zhao, Comparative Analysis of Thermoelectric Elements Optimum Geometry Between Photovoltaic-Thermoelectric and Solar Thermoelectric. Energy 171, 599 (2019).10.1016/j.energy.2019.01.057 ↗
26. S. Shittu, G. Li, X. Zhao, and X. Ma, Series of Detail Comparison and Optimization of Thermoelectric Element Geometry Considering the PV Effect. Renew. Energy 130, 930 (2019).10.1016/j.renene.2018.07.002 ↗
27. D.N. Kossyvakis, G.D. Voutsinas, and E.V. Hristoforou, Experimental Analysis and Performance Evaluation of a Tandem Photovoltaic–Thermoelectric Hybrid System. Energy Convers. Manag. 117, 490 (2016).10.1016/j.enconman.2016.03.023 ↗
28. A. Yusuf, N. Bayhan, A.A. Ibrahim, H. Tiryaki, and S. Ballikaya, Geometric Optimization of Thermoelectric Generator Using Genetic Algorithm Considering Contact Resistance and Thomson Effect. Int. J. Energy Res. 45, 9382 (2021).10.1002/er.6467 ↗
29. D. Ebling, K. Bartholomé, M. Bartel, and M. Jägle, Module Geometry and Contact Resistance of Thermoelectric Generators Analyzed by Multiphysics Simulation. J. Electron. Mater. 39, 1376 (2010).10.1007/s11664-010-1331-0 ↗
30. A. Yusuf, Y. Demirci, T. Maras, S.E. Moon, J. Pil-Im, J.H. Kim, and S. Ballikaya, Experimental and Theoretical Investigation of the Effect of Filler Material on the Performance of Flexible and Rigid Thermoelectric Generators. ACS Appl. Mater. Interfaces 13, 61275 (2021).10.1021/acsami.1c20004 ↗
31. S. Shittu, G. Li, X. Zhao, X. Ma, Y.G. Akhlaghi, and Y. Fan, Comprehensive Study and Optimization of Concentrated Photovoltaic-Thermoelectric Considering All Contact Resistances. Energy Convers. Manag. 205, 112422 (2020).10.1016/j.enconman.2019.112422 ↗
32. A. Yusuf and S. Ballikaya, Exergetic Assessment of a Concentrated Photovoltaic-Thermoelectric System with Consideration of Contact Resistance. Int. J. Exergy 38, 4 (2022).10.1504/IJEX.2022.124609 ↗
33. E. Yin and Q. Li, Device Performance Matching and Optimization of Photovoltaic-Thermoelectric Hybrid System. Energy Convers. Manag. X 12, 100115 (2021).
34. A. Yusuf, R. Tabakh, and S. Ballikaya, Performance Assessment of a Trapezoidal Concentrated Photovoltaic–Thermoelectric System. in 6th International Conference on Smart and Sustainable Technologies (SpliTech) (2021).10.23919/SpliTech52315.2021.9566328 ↗
35. T.L. Bergman and F.P. Incropera eds., Fundamentals of Heat and Mass Transfer. 7th ed., (Hoboken: Wiley, 2011).
36. R.W. Knight, D.J. Hall, J.S. Goodling, and R.C. Jaeger, Heat Sink Optimization with Application to Microchannels. IEEE Trans. Compon. Hybrids Manuf. Technol. 15, 832 (1992).10.1109/33.180049 ↗
37. M.B. Kleiner, S.A. Kuhn, and K. Haberger, High performance forced air cooling scheme employing microchannel heat exchangers. IEEE Trans. Compon. Packag. Manuf. Technol. A 18, 795 (1995).10.1109/95.477466 ↗
38. E. Yin, Q. Li, and Y. Xuan, Optimal Design Method for Concentrating Photovoltaic-Thermoelectric Hybrid. Appl. Energy 226, 320 (2018).10.1016/j.apenergy.2018.05.127 ↗