High thermoelectric performance in donor-substituted strontium titanate-based composites processed by laser floating zone
Source abstract
Abstract
Oxide thermoelectrics, made from abundant, eco-friendly materials, can withstand high-temperature gradients, making them highly promising for high-temperature waste heat harvesting. Recent advancements in the efficiency of thermoelectric material families have been driven by composite approaches, fostering synergistic effects between materials, further enhanced by advanced processing techniques. Accordingly, this study explores the design of oxide-based thermoelectric composites, involving the redistribution of a common substituting cation between composite phases, driven by laser floating zone (LFZ) processing. Niobium substituted strontium titanate/rutile composite material with a nominal composition Sr 0.97 Ti 0.8 Nb 0.2 O 3 / 0.15Ti 0.95 Nb 0.05 O 2 was processed by LFZ at various pulling rates (50, 100, and 200 mm/h), followed by post-thermal treatment under highly reducing conditions. The obtained samples showed inhomogeneous niobium distribution between perovskite and rutile phases shaped by strongly non-equilibrium conditions inherent to the LFZ processing, in contrast to the conventional solid-state route. Adjusting the pulling rate enabled a certain degree of control over niobium incorporation into both phases. Primarily driven by an enhanced Seebeck coefficient, the LFZ-processed and thermally treated samples demonstrated high power factors, reaching 1350–820 μW·K −2 ·m −1 at 473–1173 K, respectively. An appealing ZT of 0.52 at 1173 K was achieved for the composite sample processed at 100 mm/h and subjected to thermal treatment. This performance is attributed to a combination of a high power factor and low thermal conductivity (∼2 W·m −1 ·K −1 at 1173 K), enabled by phase and compositional inhomogeneities, as well as residual porosity introduced by LFZ processing. The LFZ technique offers considerable potential for optimisation and has proven to be a powerful tool for designing ceramic composite thermoelectric materials. • Laser floating zone processing enables the tuning of Nb distribution between phases in SrTiO 3 /TiO 2 composites. • Post-thermal treatment promotes phase equilibration, significantly enhancing thermoelectric performance. • Optimised LFZ processing combined with post-thermal treatment results in a power factor of 820 μW/K 2 ·m at 1173 K. • LFZ-induced inhomogeneity and porosity lower thermal conductivity (∼2 W/m·K), yielding ZT = 0.52 at 1173 K.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Thermography and Photoacoustic Techniques · Transition Metal Oxide Nanomaterials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (58)
Show source-provided references
1. Oxide thermoelectrics: the challenges, progress, and outlook10.1557/jmr.2011.108 ↗
2. Boosting thermoelectric performance by controlled defect chemistry engineering in Ta-substituted strontium titanate10.1021/acs.chemmater.5b01389 ↗
3. High performance oxides-based thermoelectric materials10.1007/s11837-014-1218-2 ↗
4. Artificial intelligence guided thermoelectric materials design and discovery
5. Research progress and prospects of liquid–liquid triboelectric nanogenerators: mechanisms, applications, and future challenges10.1021/acsaelm.4c01729 ↗
6. A novel approach for state of health estimation and remaining useful life prediction of supercapacitors using an improved honey badger algorithm assisted hybrid Neural Network10.23919/PCMP.2023.000187 ↗
7. Recent progress in oxide thermoelectric materials: p-type Ca3Co4O9 and n-Type SrTiO3’10.1021/ic800644x ↗
8. SrTiO3-based thermoelectrics: progress and challenges10.1016/j.nanoen.2020.105195 ↗
9. Superconductivity in single-crystalline S r 1- x L a x T i O 310.1143/JPSJ.65.1529 ↗
10. Towards a high thermoelectric performance in rare-earth substituted SrTiO 3: effects provided by strongly-reducing sintering conditions10.1039/C4CP04127E ↗
11. Effect of TiO2 additive on thermoelectric properties of SrTiO310.1142/S1793604720510017 ↗
12. Designing strontium titanate-based thermoelectrics: insight into defect chemistry mechanisms10.1039/C6TA09860F ↗
13. Enhancement of thermoelectric properties of SrTiO 3 /LaNb–SrTiO 3 composite by different doping levels10.1088/1674-1056/27/4/048401 ↗
14. Redox engineering of strontium titanate-based thermoelectrics10.1039/C9TA13824B ↗
15. M. Acharya, S.S. Jana, M. Ranjan, and T. Maiti, ‘High performance (ZT>1) n-type oxide thermoelectric composites from earth abundant materials’, Nano Energy, vol. 84, no. November 2020, p. 105905, Jun. 2021, doi: 10.1016/j.nanoen.2021.105905.10.1016/j.nanoen.2021.105905 ↗
16. Densification, microstructure, and thermoelectric properties of AZO/SrTiO3 composites10.1016/j.ceramint.2022.01.239 ↗
17. Enhanced thermoelectric performance in oxide composites of La and Nb codoped SrTiO 3 by using graphite as the electron mobility booster10.1021/acsami.1c24625 ↗
18. Thermoelectric properties of Nb-doped SrTiO3 / TiO2 multiphase composite
19. Phase transformations and numerical modelling in simulated HAZ of nanostructured P91B steel for high temperature applications10.1007/s13204-018-0854-1 ↗
20. On the heat-affected zone role for mechanical properties of structural-steel MIG and CMT–MIG weldments10.1007/s12666-024-03460-3 ↗
21. Growth rate effects on the thermoelectric performance of CaMnO3-based ceramics10.1016/j.jeurceramsoc.2019.06.011 ↗
22. Preparation of high-performance Ca3Co4O9 thermoelectric ceramics produced by a new two-step method10.1016/j.jeurceramsoc.2013.01.029 ↗
23. Drastic modification of low temperature thermoelectric properties of Na-doped Bi2Sr2Co2Oy ceramics prepared via laser floating zone technique10.1007/s10854-020-04119-7 ↗
24. High thermoelectric performance in Bi2-xPbxBa2Co2Oy promoted by directional growth and annealing10.1016/j.jeurceramsoc.2015.09.034 ↗
25. Thermoelectric properties of Nb-doped SrTiO 3 ceramics enhanced by potassium titanate nanowires addition10.2109/jcersj2.118.1098 ↗
26. Influence of Bi on the thermoelectric properties of SrTiO3-δ10.1007/s10853-019-04007-4 ↗
27. C. Wu et al., ‘The Effect of Reduced Graphene Oxide on Microstructure and Thermoelectric Properties of Nb-Doped A-site-Deficient SrTiO3 Ceramics’, 2019. doi: 10.1016/j.jallcom.2019.01.376.10.1016/j.jallcom.2019.01.376 ↗
28. Tuning the thermoelectric properties of A-site deficient SrTiO3 ceramics by vacancies and carrier concentration10.1039/C6CP05523K ↗
29. ‘Effect of A - site cation deficiency on the thermoelectric performance of donor-substituted strontium titanate’10.1021/jp409872e ↗
30. High temperature thermoelectric properties of strontium titanate thin films with oxygen vacancy and niobium doping10.1021/am4015956 ↗
31. Preparation of novel titanium-niobium-oxygen composite ceramic with excellent thermoelectric properties using the high-pressure and high-temperature method10.1016/j.jeurceramsoc.2022.05.016 ↗
32. All-electron GW calculation of rutile TiO2 with and without Nb impurities10.1103/PhysRevB.92.035205 ↗
33. Influence of Nb-doping on the local structure and thermoelectric properties of transparent TiO2:Nb thin films10.1016/j.jallcom.2020.155561 ↗
34. Controlling the thermoelectric properties of Nb-Doped TiO2 ceramics through engineering defect structures10.1021/acsami.1c18236 ↗
35. Z. Yuan, J. Gong, S. Xu, Z. Li, and G. Tang, Investigation of the thermoelectric properties of reduced Nb-doped TiO2-δ ceramics’, 2017. doi: 10.1016/j.jallcom.2017.03.336.10.1016/j.jallcom.2017.03.336 ↗
36. Laser processing as a tool for designing donor-substituted calcium manganite-based thermoelectrics10.1016/j.jallcom.2020.154466 ↗
37. Thermoelectric modules built using ceramic legs grown by laser floating zone10.1016/j.ceramint.2020.06.213 ↗
38. Assessment of the laser floating zone processing of thermoelectric CuFe1–xNixO2 delafossites and their magnetic characterisation10.1016/j.jallcom.2022.165678 ↗
39. Enhancement of thermoelectric performance in strontium titanate by praseodymium substitution10.1063/1.4790307 ↗
40. Tuning thermoelectric properties of Ca0.9Gd0.1MnO3 by laser processing10.1007/s10854-020-04428-x ↗
41. Laser floating zone growth: overview, singular materials, broad applications, and future perspectives10.3390/cryst11010038 ↗
42. Tubular thermoelectric module based on oxide elements grown by the laser floating zone10.1021/acsaem.1c00677 ↗
43. Revised effective ionic radii and systematic studies of interatomic distances in halides and chalcogenides10.1107/S0567739476001551 ↗
44. Niobium segregation in niobium-doped titanium dioxide (Rutile)10.1021/jp4110536 ↗
45. Design of SrTiO 3 -based thermoelectrics by tungsten substitution10.1021/jp510743h ↗
46. Modified strontium titanates: from defect chemistry to SOFC anodes10.1039/C4RA09751C ↗
47. Electrical conductivity and thermal expansion of Ln-substituted SrTiO3 for solid oxide cell electrodes and interconnects: the effect of rare-earth cation size10.1016/j.jpowsour.2020.228531 ↗
48. Improvements in the thermoelectric efficiency of SrTiO3 through donor doping10.1016/j.ceramint.2021.11.131 ↗
49. Doping effect of Nb on ionic polarization of SrTiO3’10.2109/jcersj2.19031 ↗
50. Defect and electrical transport properties of Nb-doped SrTiO310.1016/j.ssi.2008.06.023 ↗
51. Enhanced thermoelectric performance of Nb-doped SrTiO3 by nano-inclusion with low thermal conductivity10.1038/srep03449 ↗
52. Colossal seebeck coefficient in Aurivillius phase-perovskite oxide composite10.1016/j.jallcom.2020.157001 ↗
53. Thermoelectric power generation from lanthanum strontium titanium oxide at room temperature through the addition of graphene10.1021/acsami.5b03522 ↗
54. D. Liu et al., ‘Ultrahigh electrical conductivities and low lattice thermal conductivities of La, Dy, and Nb Co-doped SrTiO3 thermoelectric materials with complex structures’, 2020. doi: 10.1016/j.jmst.2020.02.065.10.1016/j.jmst.2020.02.065 ↗
55. Thermoelectric properties of A-site deficient La-doped SrTiO3 at 100–900 °C under reducing conditions10.1016/j.jeurceramsoc.2019.09.024 ↗
56. Preparation and thermoelectric properties of Nd and Dy co-doped SrTiO3 bulk materials10.1016/j.materresbull.2019.110650 ↗
57. La and Sm Co-doped SrTiO 3- δ thermoelectric ceramics
58. Microstructure and thermoelectric properties of La-doped SrTiO3/TiO2 eutectic crystals grown by Micro-Pulling-Down method10.1016/j.jcrysgro.2022.126551 ↗