Simultaneously enhancing the dielectric constant, photo-response and deepening HOMO levels of benzo[1,2-b;4,5-b']dithiophene derivatives-based conjugated polymers
Source abstract
Abstract
Abstract An alternating conjugated polymer (CPs) named as PBDT-TS-DPP, derived from 2-ethylhexylthiothiophen-2-yl-flanked (TS) benzo[1,2-b;4,5-b']dithiophene (BDT-TS) and diketopyrrolopyrrole derivatives (DPP), was prepared by Palladium-catalyzed Stille coupling reaction. The comparison investigations of the opto-electronic properties and aggregation characteristics between the PBDT-TS-DPP and PBDT-T-DPP, which was derived from 2-ethylhexylthiophen-2-yl-flanked (T) benzo[1,2-b;4,5-b']dithiophene (BDT-T) and DPP, were implemented. The results indicated that the PBDT-TS-DPP not only presented narrower optical band gap, deeper HOMO energy levels, similar charger transporting and aggregation characteristics etc., but also held enhanced relative dielectric constant (er) in relative to that for the PBDT-T-DPP. To our knowledge, it is firstly to verify that the replacement of T with TS flanks would result in the enhancing er besides the deepening HOMO energy levels and broadening the light response range for the BDT based CPs. Beyond that, the inverted photovoltaic cells (i-OPVs) with power conversion efficiencies (PCEs) of 5.48% and 4.78%, open circuit voltage (VOC) of 0.78 V and 0.74 V, short current density (JSC) of 11.52 mA/cm2 and 9.46 mA/cm2, fill factors (FF) of 61.0% and 68.3%, were respectively presented in PBDT-TS-DPP and PBDT-T-DPP based i-OPVs. Meanwhile, it has also been certified that the i-OPVs from PBDT-TS-DPP exhibited higher exciton dissociation probability, charge carrier density, charger carriers lifetime, and lower recombination rate co-efficiency etc., which might be attributed to the higher dielectric constant of PBDT-TS-DPP as compared with PBDT-T-DPP, thus devote to the additional improvement of the PCEs, VOC and JSC for the PBDT-TS-DPP based i-OPVs, except that the improvement of the these parameters were compensated from the deepening HOMO energy level and broadening light response of the PBDT-TS-DPP.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Organic Electronics and Photovoltaics · Perovskite Materials and Applications · Conducting polymers and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (58)
Show source-provided references
1. Photoinduced electron transfer from a conducting polymer to buckminsterfullerene10.1126/science.258.5087.1474 ↗
2. Polymer photovoltaic cells: enhanced efficiencies via a network of internal donor-acceptor heterojunctions10.1126/science.270.5243.1789 ↗
3. Polymer homo–tandem solar cells with best efficiency of 11.3%10.1002/adma.201404220 ↗
4. Single-junction polymer solar cells with high efficiency and photovoltage10.1038/nphoton.2015.6 ↗
5. Quinoxaline–thiophene based thick photovoltaic devices with an efficiency of~ 8%10.1039/C6TA03801H ↗
6. Semi-crystalline photovoltaic polymers with efficiency exceeding 9% in a ~300 nm thick conventional single-cell device10.1039/C4EE01529K ↗
7. Aggregation and morphology control enables multiple cases of high-efficiency polymer solar cells10.1038/ncomms6293 ↗
8. n-Type water/alcohol-soluble naphthalene diimide-based conjugated polymers for high-performance polymer solar cells10.1021/jacs.5b12664 ↗
9. Over 16% efficiency organic photovoltaic cells enabled by a chlorinated acceptor with increased open-circuit voltages10.1038/s41467-019-10351-5 ↗
10. Organic and solution-processed tandem solar cells with 17.3% efficiency10.1126/science.aat2612 ↗
11. Non-toxic green food additive enables efficient polymer solar cells through adjusting phase composition distribution and boosting charge transport
12. Self-doping n-type polymer as a cathode interface layer enables efficient organic solar cells by increasing built-in electric field and boosting interface contact10.1039/C9TC03506K ↗
13. The comprehensive utilization of the synergistic effect of fullerene and non-fullerene acceptors to achieve highly efficient polymer solar cells10.1039/C9TA04286E ↗
14. An alcohol-soluble polymer electron transport layer based on perylene diimide derivatives for polymer solar cells10.1109/JPHOTOV.2019.2941828 ↗
15. Surface passivation of perovskite film for efficient solar cells10.1038/s41566-019-0398-2 ↗
16. Development of heterojunction back contact Si solar cells10.1109/JPHOTOV.2014.2358377 ↗
17. A high dielectric constant non-fullerene acceptor for efficient bulk-heterojunction organic solar cells10.1039/C7TA10136H ↗
18. High–dielectric constant side–chain polymers show reduced non–geminate recombination in heterojunction solar cells10.1002/aenm.201301857 ↗
19. High-performance all-polymer solar cells based on fluorinated naphthalene diimide acceptor polymers with fine-tuned crystallinity and enhanced dielectric constants10.1016/j.nanoen.2018.01.012 ↗
20. Influence of fluorine substituents on the film dielectric constant and open-circuit voltage in organic photovoltaics10.1039/C3TC32087A ↗
21. Role of the charge transfer state in organic donor–acceptor solar cells10.1002/adma.201000376 ↗
22. Pathways to a new efficiency regime for organic solar cells10.1002/aenm.201200103 ↗
23. Fluorine substituted thiophene–quinoxaline copolymer to reduce the HOMO level and increase the dielectric constant for high open-circuit voltage organic solar cells10.1039/C2TC00327A ↗
24. Charge transfer excitons in polymer/fullerene blends: the role of morphology and polymer chain conformation10.1002/adfm.200901398 ↗
25. Measuring the competition between bimolecular charge recombination and charge transport in organic solar cells under operating conditions10.1039/C8EE01559G ↗
26. An effective strategy to enhance the dielectric constant of organic semiconductors – CPDTTPD-based low band gap polymers bearing oligo(ethylene glycol) side chains10.1039/C7TC05264B ↗
27. Dielectric constant enhancement of non-fullerene acceptors via side-chain modification10.1039/C5CC05853H ↗
28. Determining the dielectric constants of organic photovoltaic materials using impedance spectroscopy10.1002/adfm.201801542 ↗
29. George · 1992 · vol. 1
30. Synthesis and characterization of high refractive index and high abbe's number poly(thioether sulfone)s based on tricyclo[5.2.1.02,6]decane moiety10.1021/ma300379w ↗
31. Poly (thioether sulfone) with high refractive index and high Abbe's number10.1021/ma800797p ↗
32. Synthesis and photovoltaic properties of novel 3,4-ethylenedithiathiophene-based copolymers for organic solar cells10.1039/c2py20995k ↗
33. Synthesis and characterization of highly refractive polyimides derived from thiophene-containing aromatic diamines and aromatic dianhydrides10.1021/ma902013y ↗
34. New infrared transmitting material via inverse vulcanization of elemental sulfur to prepare high refractive index polymers10.1002/adma.201305607 ↗
35. Highly efficient 2D-conjugated benzodithiophene-based photovoltaic polymer with linear alkylthio side chain10.1021/cm501513n ↗
36. A wide bandgap polymer with strong π–π interaction for efficient fullerene–free polymer solar cells10.1002/aenm.201600742 ↗
37. Non-fullerene polymer solar cells based on alkylthio and fluorine substituted 2D-conjugated polymers reach 9.5% efficiency10.1021/jacs.6b01744 ↗
38. Side-chain manipulation on accepting units of two-dimensional benzo [1, 2-b: 4, 5-b′] dithiophene polymers for organic photovoltaics10.1039/C5PY01632K ↗
39. Low-bandgap conjugated polymers based on alkylthiothienyl-substituted benzodithiophene for efficient bulk heterojunction polymer solar cells10.1016/j.polymer.2017.06.047 ↗
40. Replacing alkoxy groups with alkylthienyl groups: a feasible approach to improve the properties of photovoltaic polymers10.1002/ange.201103313 ↗
41. Synthetically controlling the optoelectronic properties of dithieno[2,3-d:2′,3′-d′]benzo[1,2-b:4,5-b′]dithiophene-alt-diketopyrrolopyrrole-conjugated polymers for efficient solar cells10.1039/C4TA01632G ↗
42. Systematically investigating the influence of inserting alkylthiophene spacers on the aggregation, photo-stability and optoelectronic properties of copolymers from dithieno[2,3-d:2′,3′-d′]benzo[1,2-b:4,5-b′]dithiophene and benzothiadiazole derivatives10.1039/C8PY01764F ↗
43. Effects of backbone planarity and tightly packed alkyl chains in the donor–acceptor polymers for high photostability10.1021/acs.macromol.6b01580 ↗
44. Relationship between the ionization and oxidation potentials of molecular organic semiconductors10.1016/j.orgel.2005.01.002 ↗
45. Naphtho [1, 2-c: 5, 6-c′] bis [1, 2, 5]thiadiazole-based conjugated polymers consisting of oligothiophenes for efficient polymer solar cells10.1016/j.polymer.2017.06.023 ↗
46. Medium band gap conjugated polymers from thienoacene derivatives and pentacyclic aromatic lactam as promising alternatives of poly(3–hexylthiophene) in photovoltaic application10.1002/pola.28874 ↗
47. Enhanced power-conversion efficiency in polymer solar cells using an inverted device structure10.1038/nphoton.2012.190 ↗
48. Effect of π-conjugated bridges of TPD-based medium bandgap conjugated copolymers for efficient tandem organic photovoltaic cells10.1039/C4EE02318H ↗
49. Polymer solar cells with enhanced fill factors10.1038/nphoton.2013.207 ↗
50. Boosting up performance of inverted photovoltaic cells from bis(alkylthien-2-yl)dithieno[2,3-d:2′,3′-d′]benzo[1,2-b:4′,5′-b′]dithiophene-based copolymers by advantageous vertical phase separation10.1021/acsami.6b15436 ↗
51. An alkylthieno-2-yl flanked dithieno[2,3-d:2′,3′-d′]benzo[1,2-b:4,5-b′]dithiophene-based low band gap conjugated polymer for high performance photovoltaic solar cells10.1039/C4RA14532A ↗
52. Understanding the enhanced open-circuit voltage of polymer solar cells based on a diketopyrrolopyrrole small molecular acceptor10.1021/acsami.8b06717 ↗
53. Enhanced efficiency of polymer solar cells through synergistic optimization of mobility and tuning donor alloys by adding high-mobility conjugated polymers10.1039/C8TC03612H ↗
54. Small-molecule acceptor based on the heptacyclic benzodi (cyclopentadithiophene) unit for highly efficient nonfullerene organic solar cells10.1021/jacs.7b01170 ↗
55. Charge-density-based analysis of the current–voltage response of polythiophene/fullerene photovoltaic devices10.1073/pnas.1004363107 ↗
56. Non–geminate recombination as the primary determinant of open–circuit voltage in polythiophene:fullerene blend solar cells: an analysis of the influence of device processing conditions10.1002/adfm.201100225 ↗
57. Experimental determination of the rate law for charge carrier decay in a polythiophene: fullerene solar cell10.1063/1.2891871 ↗
58. Recent advances in water/alcohol-soluble π-conjugated materials: new materials and growing applications in solar cells10.1039/c3cs60200a ↗