Modeling the degradation/recovery of open-circuit voltage in perovskite and thin film solar cells
Source abstract
Abstract
Abstract Developing theories behind the degradation/recovery of polycrystalline perovskite and thin film solar cells is essential in promoting the stability of such devices under stress conditions. Here we propose a novel approach to model the variation of open-circuit voltage by time, Voc(t) for perovskite, CdTe, CIGS and CZTS-based solar cells. Several time-dependent equations have been derived and fitted with the experimental data on degradation/recovery of Voc under stress of light, bias, moisture and temperature. Any stress condition will change the defect density across the absorber layer of a solar cell. This will in turn effect on the saturation current density, depletion width and finally on the Voc of a device. A good fit has been obtained between these proposed models and the data reported in the literature on degradation rate of Voc. In some cases more than one model is required to fit with the data as urges by the non-crystalline nature of perovskite and thin film materials and specific influence of every stress condition (i.e. prolonged irradiation, elevated temperature or air humidity) on materials properties and defect profile across the device. Therefore, the distribution of defects may change by time depend on the intensity, type of the stress or recovery process. Different than previous believes, we showed that Voc, as a measure of recombination rate and carrier collection efficiency of a device, may follow 8 different time-dependent models.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Perovskite Materials and Applications · Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. The effect of damp heat-illumination exposure on CIGS solar cells: a combined XRD and electrical characterization study10.1016/j.solmat.2016.07.051 ↗
2. Interface studies of the planar heterojunction perovskite solar cells10.1016/j.solmat.2016.07.045 ↗
3. Comparison of amorphous silicon absorber materials: kinetics of light-induced degradation10.1002/pip.2559 ↗
4. Tetali · 2005
5. Fjallstrom · 2015
6. Accelerated testing and modeling of potential-induced degradation as a function of temperature and relative humidity10.1109/JPHOTOV.2015.2466463 ↗
7. Modeling the degradation and recovery of perovskite solar cells10.1039/C6RA06635F ↗
8. Towards understanding junction degradation in cadmium telluride solar cells10.1063/1.4883368 ↗
9. Polarization phenomena in Al/p-CdTe/Pt X-ray detectors10.1016/j.nima.2013.05.157 ↗
10. Electrical characterization of CdTe pixel detectors with Al Schottky anode10.1016/j.nima.2014.07.011 ↗
11. Degradation of CdTe solar cells: simulation and experiment10.1109/JPHOTOV.2015.2405763 ↗
12. Modeling of depletion width variation over time in thin film photovoltaics10.1142/S0217984916500445 ↗
13. Numerical analysis of degradation kinetics in CdTe thin films10.1016/j.solener.2015.05.041 ↗
14. Potential-induced degradation (PID): incomplete recovery of shunt resistance and quantum efficiency losses10.1109/JPHOTOV.2015.2459919 ↗
15. Direct determination of doping concentration and built-in voltage from extraction current transients10.1016/j.orgel.2014.09.027 ↗
16. Handbook of Photovoltaic Science and Engineering
17. Research update: strategies for improving the stability of perovskite solar cells10.1063/1.4961210 ↗
18. Annealing kinetic model using fast and slow metastable defects for hydrogenated-amorphous-silicon-based solar cells10.1063/1.2213507 ↗
19. Experimental evidence of multiple diffusion mechanisms in thin-film Cu(In,Ga)Se210.1109/JPHOTOV.2015.2459911 ↗
20. Systematic study on the impact of water on the performance and stability of perovskite solar cells10.1039/C6RA11379F ↗
21. Yang · J. Appl. Phys. · 2015 · 117 · 09550210.1063/1.4913519 ↗
22. Dependence of efficiency of thin-film CdS/CdTe solar cell on parameters of absorber layer and barrier structure10.1016/j.tsf.2008.11.012 ↗
23. Curing of degraded MAPbi3 perovskite films10.1039/C6RA09714F ↗
24. Potential-induced degradation (PID): incomplete recovery of shunt resistance and quantum efficiency losses10.1109/JPHOTOV.2015.2459919 ↗
25. Amazing stable open-circuit voltage in perovskite solar cells using AgAl alloy electrode10.1016/j.solmat.2015.11.026 ↗
26. Solution processed pristine PDPP3t polymer as hole transport layer for efficient perovskite solar cells with slower degradation10.1016/j.solmat.2015.10.008 ↗
27. Novel CdS hole-blocking layer for photostable perovskite solar cells, ACS Appl10.1021/acsami.5b12336 ↗
28. Modulating crystal grain size and optoelectronic properties of perovskite films for solar cells by reaction temperature10.1039/C5NR08935B ↗
29. Degradation of CIGS solar cells due to the migration of alkali-elements
30. CdTe thin-film solar cells with cobalt-phthalocyanine back contacts10.1063/1.4871093 ↗
31. Stability of CZTS thin film solar cells upon accelerated thermal cycling and damp heat exposure
32. Modeling the PbI2 formation in perovskite solar cells using XRD/XPS patterns10.1016/j.spmi.2016.07.026 ↗
33. Understanding the rate-dependent J-V hysteresis, slow time component, and aging in CH3NH3PbI3 perovskite solar cells: the role of a compensated electric field10.1039/C4EE03664F ↗
34. Persistent photoconductivity in polycrystalline Cu(In,Ga)Se2 thin films: experiment versus theoretical predictions10.1109/JPHOTOV.2015.2423491 ↗
35. Analysis of governing factors for photovoltaic loss mechanism of n-CdS/p-CdTe heterojunction via multiway data decomposition10.1002/pip.2394 ↗
36. Proceedings of the 15th Conference on NCPV Photovoltaics Program Review, Denver,Colorado