journal article·2024-09

Natural aging-induced nanoprecipitation and its impact on tensile properties of Al–Si–Cu–Mg cast alloy

Sang-Hwa Lee, Namhyuk Seo, Minwoo Kang, Seung Bae Son, Seok-Jae Lee, Jae-Gil Jung

Publisher page

Abstract

The nanoprecipitation of naturally aging Al–5.70Si–2.06Cu–0.29Mg (wt.%) cast alloy and its impact on tensile properties was investigated based on atomic-scale characterization by transmission electron microscopy and atom probe tomographic analyses. Solution treatment led to the dissolution of θ-Al 2Cu and Q-Al 5Cu 2Mg 8Si 6 phases, along with the spheroidization of the eutectic Si phase of the cast alloy. Upon quenching of the solution-treated alloy, nanoscale Si precipitates with equivalent radii of ∼1.77 nm were formed. Subsequent natural aging resulted in the formation of coherent solute clusters (0.66 ± 0.11 nm in radius), rich in Mg/Si or Cu, which correspond to the precursor phases Q-Al 5Cu 2Mg 8Si 6 and θ-Al 2Cu. Microhardness of the matrix and the strength of the alloy significantly increased due to the natural aging-induced solute clustering. Analysis of the strengthening mechanism indicated that the enhanced strength of the naturally aged alloy was primarily due to the coherency and modulus strengthening of the dislocation-shearable solute clusters. These clusters suppressed the dynamic strain aging, whereas no significant changes were observed in the strain-hardening behavior. However, natural aging led to the degradation of the alloy ductility due to the presence of shearable solute clusters, which could create slip bands and promote failure in regions with a high fraction of secondary phases within the cast alloy.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (72)

Show source-provided references
1. Kaufman · 2000
2. Polmear · 2006
3. The effect of Mg on the structure and properties of type 319 aluminum casting alloys10.1016/j.actamat.2008.11.021 ↗
4. The microstructure and precipitation kinetics of a cast aluminium alloy10.1016/j.scriptamat.2006.03.065 ↗
5. Precipitation behavior of an Al–Cu alloy during isothermal aging at low temperatures10.1016/j.matlet.2004.10.058 ↗
6. Nanocluster formation and two-step aging behavior in Al–Mg–Si(–xCu; X = 0–4 mass%) alloys10.1016/j.jallcom.2020.157596 ↗
7. Strengthening precipitates and mechanical performance of Al–Si–Cu–Mg cast alloys containing transition elements10.1016/j.msea.2021.141497 ↗
8. Precipitation during high temperature aging of Al–cu alloys: A multiscale analysis based on first principles calculations10.1016/j.actamat.2019.01.024 ↗
9. Guinier-Preston (GP) zone revisited: Atomic level observation by HAADF-TEM technique10.1016/S1359-6462(01)00909-5 ↗
10. Multiple precipitation reactions and formation of θ’-phase in a pre-deformed Al–Cu alloy10.1016/j.msea.2018.07.039 ↗
11. The morphology and orientation relationship variations of Q′ phase in Al–Mg–Si–Cu alloy10.1016/j.matchar.2016.06.005 ↗
12. The structural and compositional evolution of precipitates in Al–Mg–Si–Cu alloy10.1016/j.actamat.2017.12.036 ↗
13. The evolution of precipitate crystal structures in an Al–Mg–Si(–Cu) alloy studied by a combined HAADF-STEM and SPED approach10.1016/j.matchar.2018.05.031 ↗
14. Precipitates and intermetallic phases in precipitation hardening Al–cu–mg–(Li) based alloys10.1179/174328005X14357 ↗
15. Structural phase transition in Al–cu–mg–Si alloys by transmission electron microscopy study on an Al–4 wt%cu–1 wt%mg–ag alloy reinforced by SiC particles10.1080/01418619908212027 ↗
16. Decomposition of supersaturated solid solutions in Al–cu–mg–Si alloys10.1023/A:1021109514892 ↗
17. Precipitation of aluminum in the silicon phase contained in W319 and 356 aluminum alloys10.1007/s11661-003-0088-y ↗
18. Crystal structure and stability of complex precipitate phases in Al–cu–mg–(Si) and Al–Zn–mg alloys10.1016/S1359-6454(01)00229-4 ↗
19. Energetics of native defects, solute partitioning, and interfacial energy of Q precipitate in Al–cu–mg–Si alloys10.1016/j.actamat.2018.05.031 ↗
20. Compositional evolution of Q-phase precipitates in an aluminum alloy10.1016/j.actamat.2014.05.001 ↗
21. Temporal evolution of coherent precipitates in an aluminum alloy W319: A correlative anisotropic small angle X-ray scattering, transmission electron microscopy and atom-probe tomography study10.1016/j.actamat.2016.06.043 ↗
22. Ageing evolution process of the θ’-phase in Al–Si–cu–mg alloys: Atomic-scale observations and first-principles calculations10.1016/j.jallcom.2023.171787 ↗
23. Atomic-scale pathway of early-stage precipitation in Al–mg–Si alloys10.1016/j.actamat.2014.09.004 ↗
24. Pre-precipitate clusters and precipitation processes in Al–mg–Si alloys10.1016/S1359-6454(99)00033-6 ↗
25. Precipitation strengthening in naturally aged Al–Zn–mg–cu alloy10.1016/j.msea.2020.140719 ↗
26. The effect of shearable clusters and precipitates on dynamic recovery of Al alloys10.1016/j.actamat.2023.119643 ↗
27. Lattice mismatch modeling of aluminum alloys10.1016/j.commatsci.2017.06.021 ↗
28. Effective parameter for the selection of modifying agent for Al–Si alloy10.1016/j.msea.2006.02.363 ↗
29. Systematic study of growth behavior of β-Al9Fe2Si2 in Al alloys with high iron and silicon contents10.1016/j.jmrt.2023.07.212 ↗
30. ASTM E8/E8M-13a · 2013
31. Mechanisms affecting hardness and electrical conductivity in artificially-aged B319 aluminum alloy10.1016/j.jallcom.2021.159121 ↗
32. Quantitative size-factors for metallic solid solutions10.1007/BF00549722 ↗
33. The sequence of precipitation in the Al–mg–Si–cu alloy AA661110.1007/BF02586103 ↗
34. The effect of cu on precipitation in Al–mg–Si alloys10.1080/14786430701287377 ↗
35. Simulation of the effect of composition on the precipitation in 6xxx Al alloys during continuous-heating DSC10.1016/j.jallcom.2014.05.191 ↗
36. Enhanced mechanical properties of high-temperature-resistant Al–cu cast alloy by microalloying with mg10.1016/j.jallcom.2020.154305 ↗
37. Microstructural changes at the initial stage of precipitation in an aluminum-silicon alloy10.2320/matertrans.46.779 ↗
38. On the silicon spheroidization in Al–Si alloys10.1016/S1471-5317(03)00010-5 ↗
39. Shewmon · 1963 · 66
40. Coupling of dislocations and precipitates: Impact on the mechanical behavior of ultrafine grained Al–Zn–mg alloys10.1016/j.actamat.2015.09.017 ↗
41. Enhanced mechanical properties and homogeneous T5 age-hardening behavior of Al–Si–cu–mg casting alloys10.1016/j.jallcom.2023.170982 ↗
42. Cu-segregation at the Q′/α-Al interface in Al–mg–Si–cu alloy10.1016/S1359-6462(02)00325-1 ↗
43. A sensitivity analysis of the maximum separation method for the characterization of solute clusters10.1016/j.ultramic.2010.12.015 ↗
44. Impact of directional walk on atom probe microanalysis10.1016/j.ultramic.2011.06.005 ↗
45. Size-dependent diffusion controls natural aging in aluminium alloys10.1038/s41467-019-12762-w ↗
46. Effects of Sn addition on precipitation of Al–Zn–mg alloy at early stage of natural aging10.1016/j.jmrt.2023.07.187 ↗
47. Natural aging behaviors and mechanisms of 7050 and 5A90 Al alloys: A comparative study10.1016/j.msea.2018.01.119 ↗
48. The effect of precipitation on the Portevin-Le Chatelier effect in an Al–Zn–mg–cu alloy10.1016/S0921-5093(99)00029-5 ↗
49. Effects of precipitation state on serrated flow in Al-mg(-Zn) alloys10.2320/matertrans.L-M2016814 ↗
50. Mechanical behavior and strengthening mechanisms in ultrafine grain precipitation-strengthened aluminum alloy10.1016/j.actamat.2013.09.042 ↗
51. Strengthening mechanisms in Al–Ni–Sc alloys containing Al3Ni microfibers and Al3Sc nanoprecipitates10.1016/j.actamat.2018.10.059 ↗
52. Effects of Mo and Mn microadditions on strengthening and over-aging resistance of nanoprecipitation-strengthened Al–Zr–Sc–Er–Si alloys10.1016/j.actamat.2018.11.031 ↗
53. Effects of natural aging on the formation and strengthening effect of G.P. zones in a retrogression and re-aged Al–Zn–mg–cu alloy10.1016/j.jallcom.2020.154469 ↗
54. On the estimation of true hall-Petch constants and their role on the superposition law exponent in Al alloys10.1002/adem.201200114 ↗
55. Tensile behavior of bulk nanocrystalline aluminum synthesized by hot extrusion of ball-milled powders10.1016/j.scriptamat.2008.07.030 ↗
56. The dislocation distribution, flow stress, and stored energy in cold-worked polycrystalline silver10.1080/14786436008238300 ↗
57. Davis · 1993
58. Strengthening mechanisms in a high-strength bulk nanostructured cu–Zn–Al alloy processed via cryomilling and spark plasma sintering10.1016/j.actamat.2012.09.036 ↗
59. Precipitation hardening10.1007/BF02670416 ↗
60. Atomistic modeling of interface strengthening in Al-Si eutectic alloys10.1016/j.actamat.2021.117586 ↗
61. Ultrahigh strength and plasticity in laser rapid solidified Al-Si nanoscale eutectics10.1080/21663831.2020.1755380 ↗
62. Influence of annealing treatment on Si morphology and strength of rapid solidified Al-12 wt% Si powders10.1016/j.jallcom.2019.01.257 ↗
63. Microstructural evolution and strengthening mechanism of an Al–Si–mg alloy processed by high-pressure torsion with different heat treatments10.1016/j.msea.2020.139932 ↗
64. The shearable-non-sherable transition in Al–mg–Si–cu precipitation hardening alloys: Implications on the distribution of slip, work hardening and fracture10.1080/14786430500154935 ↗
65. Quantified contribution of “β” and β’ precipitates to the strengthening of an aged Al–mg–Si alloy10.1016/j.msea.2019.138776 ↗
66. Preparation of Al–Si alloys by a rapid solidification and powder metallurgy route10.1016/j.matdes.2015.08.106 ↗
67. A first-principles study of the cu-containing “β” precipitates in Al–mg–Si–cu alloy10.3390/ma14247879 ↗
68. Domain epitaxy: A unified paradigm for thin film growth10.1063/1.1528301 ↗
69. Rafting and elastoplastic deformation of superalloys studied by neutron diffraction10.1016/j.scriptamat.2017.03.007 ↗
70. The influence of precipitation on the work-hardening behavior of the aluminum alloys AA6111 and AA703010.1007/s11661-003-0007-2 ↗
71. Microstrucutre-based modelling of isotropic and kinematic strain hardening in a precipitation-hardened aluminium alloy10.1016/j.actamat.2011.02.035 ↗
72. Tensile flow and work hardening behavior of hot cross-rolled AA7010 aluminum alloy sheets10.1016/j.msea.2013.03.079 ↗