journal article·2011-09

Effect of binders on microstructural and mechanical properties of sintered alumina

Rym Taktak, Samir Baklouti, Jamel Bouaziz

Materials Characterization· Volume 62· Issue 9
Publisher page

Abstract

Abstract This study examines the effects of organic binder content, plasticity and sintering temperature on the microstructural and mechanical properties of sintered samples prepared from alumina spray-dried powders. Measurements of mechanical strength of sintered samples prepared from spray-dried alumina powders containing the two binders polyvinyl alcohol (PVA) or polyethylene glycol (PEG) are reported. This analysis revealed that the introduction of an optimal amount of binder in the composition of spray dried powders enhances the relative density and the mechanical strength of sintered samples prepared from these powders. The variation of mechanical strength of these samples with sintering temperature is compared to those prepared from alumina with no additive and discussed. For powders containing PVA as a binder, the samples' properties are better when the amount of PVA is lower. It was also observed a good deformability of alumina granules spray dried with the PEG binder which leads to get more homogeneous microstructure and therefore a good sintering and densification of samples.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Polymer Foaming and Composites · Innovations in Concrete and Construction Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (14)

Show source-provided references
1. Rahman · 2003
2. Carnen, R., Gay, D., Messing, L., 2001, Response of granular powders to uniaxial loading and unloading powder technology, 115, 131–138.10.1016/S0032-5910(00)00330-2 ↗
3. Compaction behaviour of alumina powders spray dried with organic binders10.1051/jp3:1996186 ↗
4. Binder distribution in spray-dried alumina agglomerates10.1016/S0955-2219(98)00107-1 ↗
5. Mechanical properties of dry-pressed ceramics: the effect of the binder10.1111/j.1151-2916.1997.tb03082.x ↗
6. Young's modulus of dry-pressed ceramics: the effect of the binder10.1016/S0955-2219(98)00262-3 ↗
7. Dependence of compaction on the glass transition temperature of the binder phase
8. Effect of relative humidity on the compaction of barium titanate and manganese zinc ferrite agglomerates containing polyvinylalchool
9. Compaction of spray-dried powders
10. Particle and granule parameters affecting compaction efficiency in dry pressing10.1111/j.1151-2916.1988.tb07546.x ↗
11. The effect of binders on the strength and Young's modulus of dry pressed alumina10.1016/S0955-2219(97)00129-5 ↗
12. Binder burnout and evolution of the mechanical strength of dry-pressed ceramics containing poly(vinylalcohool)10.1016/S0955-2219(00)00305-8 ↗
13. Tensile strength of the ceramic powders10.1007/BF01116029 ↗
14. Baklouti, S., 1996, Pressage de poudres d'alumine atomisées: Influence des liants organiques sur l'aptitude au pressage, Thèse Doctorat Ecole Nationale Supérieure de Céramique Industrielle de Limoges, France.