journal article·2015-01

Out-of-plane structural response of interlocking compressed earth block walls

P. T. Laursen, N. A. Herskedal, D. C. Jansen, B. Qu

Materials and Structures· Volume 48· Issue 1-2
Publisher page

Abstract

Stabilized compressed earth block (CEB) structures are popular in developing countries because of their low cost, sustainable use of indigenous materials, and inherent simplicity. Interlocking CEB blocks are dry stacked (no mortar in the joints), reinforced through flues and grouted. CEBs are typically used for single story homes and school houses. The current design practice for CEB structures in regions with severe natural hazards (typhoons and earthquakes) is questionable in terms of structural integrity. This is accentuated by the complete lack of experimental out‐of‐plane load testing of CEB walls. Scientific evidence reported in this paper has the potential to improve the current design practice to make this a safer construction form. Five CEB walls were built according to current design practice in Indonesia and Thailand, and subjected to out-of-plane loading. Two walls were full-scale panels and the remaining three walls were 1.1 m tall. All tests showed flexure dominated behavior, except for one full scale wall in which shear dominated failure was observed in the stiffening element. Results from the experimentation showed that the CEB walls were relatively flexible, mainly due to slack in the dry-stack joints, and that the current US masonry design code procedures (MSJC-11, Building code requirements for masonry structures (TMS 402-11/ACI 530-11/ASCE 5-11) (2011)) adequately predict the wall flexural strength. A moment–curvature based model was proposed for prediction of the out-of-plane force–displacement response and validated by the experimental results.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Hygrothermal properties of building materials · Masonry and Concrete Structural Analysis · Architectural and Urban Studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. Anand KB, Ramamurthy K (2005) Development and performance of interlocking-block masonry. J Arch Eng, ASCE 23(1):11–12
2. Bales C, Donahue C, Fischer M, Mellbom A, Pearson T (2009) Interlocking compressed earth blocks: from soils to structures. Senior Project, Department of Civil Engineering, California Polytechnic University of San Luis, Obispo
3. Bland DW (2011) In-plane cyclic shear performance of interlocking compressed earth block walls. Masters thesis, Department of Civil Engineering, California Polytechnic University of San Luis, Obispo. http://digitalcommons.calpoly.edu/theses/495 . Accessed 10 April 2013
4. Bland DW, Jansen DC, Stirling BJ, Qu B and Laursen PT (2011) In-plane cyclic performance of interlocking compressed earth block shear walls, The 11th North American Masonry Conference. Minneapolis, The Masonry Society, Boulder, 5–8 June 2011
5. Heathcote K (1991) Compressive strength of cement stabilized pressed earth blocks. Build Res Inf 19(2):101–10510.1080/09613219108727106 ↗
6. Herskedal NA (2012) Investigation of out-of-plane properties of interlocking compressed earth block walls. Masters thesis, Department of Architectural Engineering, California Polytechnic University of San Luis, Obispo. http://digitalcommons.calpoly.edu/theses/916 . Accessed 10 April 2013
7. Jayasinghe C, Mallawaarachchi RS (2009) Flexural strength of compressed stabilized earth masonry materials. Mater Des 30:3859–386810.1016/j.matdes.2009.01.029 ↗
8. MacGregor JG, Wight JK (2009) Reinforced concrete: mechanics and design, 5th edn. Prentice Hall, Upper Saddle River
9. Maini S (2010) Earthen Architecture in the World, Auroville Earth Institute. http://www.earth-aurovillecom/?nav=menu&pg=earthworld&id1=26&lang_code=en . Accessed Sept 2011
10. MSJC-11 (2011) Building code requirements for masonry structures (TMS 402-11/ACI 530-11/ASCE 5-11). The Masonry Society, Boulder
11. Pave RF (2007) Strength evaluation of dry-stack masonry. Thesis, University of Witwatersrand, Johannesburg, South Africa. http://wiredspace.wits.ac.za/handle/10539/5691 . Accessed 10 June 2011
12. Perera A, Jayasinghe C (2003) Strength characteristics and structural design methods for compressed earth block walls. Mason Int 16(1):34–38
13. Priestley MJN, Elder DM (1983) Stress-strain curves for unconfined and confined concrete masonry. ACI J 80(3):192–201
14. Proto C, Sanchez D, Rowley K, Thompson R (2010) ICEB: design and construction manual. Senior Project, California Polytechnic State University, San Luis, Obispo
15. Qu B, Stirling BJ, Laursen PT, Jansen DC and Bland DW (2012) Interlocking compressed earth block walls: in-plane structural response of flexure-dominated walls, 15th world conference on earthquake engineering, IIAE, Lisbon
16. Reddy BV, Lal R, Rao KS (2007) Optimum soil grading for the soil-cement blocks. ASCE J Mater Civ Eng 19(2):139–14810.1061/(ASCE)0899-1561(2007)19:2(139) ↗
17. Stirling BJ (2011) Flexural behavior of interlocking compressed earth block shear walls subjected to in-plane loading, M.S. thesis, California Polytechnic State University, San Luis, Obispo. http://digitalcommons.calpoly.edu/theses/593 . Accessed 10 April 2013
18. Vaculik J, Griffith MC, Hogarth BME and Todd J (2004) Out-of-plane flexural response tests using dry-stack masonry, In: Proceedings of the Australian Earthquake Engineering Society Conference, Mt. Gambier, South Australia, 2004, Paper 18
19. Wheeler G (2005) Manual of construction interlocking compressed earth blocks. Volume II. Center for Vocational Building Technology, Isarn