Experimental investigation and strength modeling of CFRP-confined concrete rectangular prisms under axial monotonic compression
Source abstract
Abstract
The effectiveness of an FRP jacket for a rectangular concrete column depends mainly on the edge sharpness and aspect ratio of its cross-section. This is because the effective confined area of cross-section will change with the variation of these parameters. In this paper results of an experimental study on the monotonic behavior of CFRP-confined concrete rectangular prisms are presented and the effects of simultaneous changes of aspect ratio and edge sharpness on this behavior are investigated. Other variable which is considered in this study is the unconfined concrete strength. Also the experimental results are compared with the existing models for this type of specimens. The findings of the present study indicate that for both the square and rectangular specimens the strength of confined concrete increases almost linearly with the decrease of edge sharpness. Results also demonstrated that the strength gain of specimens with higher aspect ratios, are much smaller than those of square specimens. The comparison between the experimental results and existing stress–strain models shows that, still there are some deficiencies in the models and further research is required to develop a more accurate stress–strain model for rectangular columns confined by FRP composites.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Structural Behavior of Reinforced Concrete · Structural Load-Bearing Analysis · Concrete Corrosion and Durability
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (28)
Show source-provided references
1. Lam L, Teng JG (2003) Design-oriented stress–strain model for FRP-confined concrete in rectangular columns. J Reinf Plast Compos 22(13):1149–118610.1177/0731684403035429 ↗
2. Lam L, Teng JG (2004) Behavior and modeling of fiber reinforced polymer-confined concrete. J Struct Eng ASCE 130(11):1713–172310.1061/(ASCE)0733-9445(2004)130:11(1713) ↗
3. Mirmiran A, Shahawy M (1997) Behavior of concrete columns confined by fiber composites. J Struct Eng ASCE 123(5):583–59010.1061/(ASCE)0733-9445(1997)123:5(583) ↗
4. Xiao Y, Wu H (2000) Compressive behavior of concrete confined by carbon fiber composite jackets. J Mater Civ Eng ASCE 12(2):139–14610.1061/(ASCE)0899-1561(2000)12:2(139) ↗
5. Lam L, Teng JG (2004) Ultimate condition of fiber reinforced polymer-confined concrete. J Compos Constr ASCE 8(6):539–54810.1061/(ASCE)1090-0268(2004)8:6(539) ↗
6. Lam L, Teng JG (2003) Design-oriented stress–strain model for FRP-confined concrete. Constr Build Mater 17(6–7):471–48910.1016/S0950-0618(03)00045-X ↗
7. Samaan M, Mirmiran A, Shahawy M (1998) Model of concrete confined by fiber composite. J Struct Eng ASCE 124(9):1025–103110.1061/(ASCE)0733-9445(1998)124:9(1025) ↗
8. Spoelstra MR, Monti G (1999) FRP-confined concrete model. J Compos Constr ASCE 3(3):143–15010.1061/(ASCE)1090-0268(1999)3:3(143) ↗
9. Jiang T, Teng JG (2007) Analysis-oriented stress–strain models for FRP-confined concrete. Eng Struct 29:2968–298610.1016/j.engstruct.2007.01.010 ↗
10. Rousakis TC, Karabinis AI (2008) Substandard reinforced concrete members subjected to compression FRP confining effects. Mater Struct 41:1595–161110.1617/s11527-008-9351-4 ↗
11. Mirmiran A, Shahawy M (1997) Dilation characteristics of confined concrete. Int J Mech Cohes-Frict Mater 2(3):237–24910.1002/(SICI)1099-1484(199707)2:3<237::AID-CFM32>3.0.CO;2-2 ↗
12. Teng JG, Jiang T, Lam L, Luo YZ (2009) Refinement of a design-oriented stress–strain model for FRP-confined concrete. ASCE J Compos Constr 13(4):269–27810.1061/(ASCE)CC.1943-5614.0000012 ↗
13. Rousakis TC, Karabinis AI (2012) Adequately FRP confined reinforced concrete columns under axial compressive monotonic or cyclic loading. RILEM Mater Struct 45(7):957–97510.1617/s11527-011-9810-1 ↗
14. Mirmiran A, Shahawy M, Samaan M, El Echary H (1998) Effect of column parameters on FRP-confined concrete. J Compos Constr ASCE 2(4):175–18510.1061/(ASCE)1090-0268(1998)2:4(175) ↗
15. Al-Salloum YA (2007) Influence of edge sharpness on the strength of square concrete columns confined with FRP composite laminates. Compos B 38:640–65010.1016/j.compositesb.2006.06.019 ↗
16. Wang LM, Wu YF (2008) Effect of corner radius on the performance of CFRP-confined square concrete columns. Eng Struct 30:493–50510.1016/j.engstruct.2007.04.016 ↗
17. Rochette P, Labossière P (2000) Axial testing of rectangular column models confined with composites. J Compos Constr ASCE 4(3):129–13610.1061/(ASCE)1090-0268(2000)4:3(129) ↗
18. Wu G, Wu ZS, Lu ZT (2007) Design-oriented stress–strain model for concrete prisms confined with FRP composites. Constr Build Mater 21:1107–112110.1016/j.conbuildmat.2005.12.014 ↗
19. Harajli MH (2006) Axial stress–strain relationship for FRP-confined circular and rectangular concrete columns. Cem Concr Compos 28:938–94810.1016/j.cemconcomp.2006.07.005 ↗
20. Harajli MH, Hantouche E, Soudki K (2006) Stress–strain model for fiber-reinforced polymer jacketed concrete columns. ACI Struct J 103(5):672–682
21. Youssef MN, Feng Q, Mosallam AS (2007) Stress–strain model for concrete confined by FRP composites. Compos B 38:614–62810.1016/j.compositesb.2006.07.020 ↗
22. Wu YF, Wei YY (2010) Effect of cross-sectional aspect ratio on the strength of CFRP-confined rectangular concrete columns. Eng Struct 32:32–4510.1016/j.engstruct.2009.08.012 ↗
23. Wang YC, Hsu K (2008) Design of FRP-wrapped reinforced concrete columns for enhancing axial load carrying capacity. Compos Struct 82:132–13910.1016/j.compstruct.2007.04.002 ↗
24. Wei YY, Wu YF (2012) Unified stress–strain model of concrete for FRP-confined columns. Constr Build Mater 26:381–39210.1016/j.conbuildmat.2011.06.037 ↗
25. Abbasnia R, Hosseinpour F, Rostamian M, Ziaadiny H (2012) Effect of corner radius on stress–strain behavior of FRP confined prisms under axial cyclic compression. Eng Struct 40:529–53510.1016/j.engstruct.2012.03.020 ↗
26. Abbasnia R, Hosseinpour F, Rostamian M, Ziaadiny H (2013) Cyclic and monotonic behavior of FRP confined concrete rectangular prisms with different aspect ratios. Constr Build Mater 40:118–12510.1016/j.conbuildmat.2012.10.008 ↗
27. Abbasnia R, Ziaadiny H (2010) Behavior of concrete prisms confined with FRP composites under axial cyclic compression. Eng Struct 32:648–65510.1016/j.engstruct.2009.11.011 ↗
28. ASTM D3039/D3039M-95 (1995) Standard test method for tensile properties of polymer matrix composite materials, vol. 14.02. Annual Book of ASTM Standards