Cu2O Homojunction Solar Cells: Efficiency Enhancement with a High Short Circuit Current

Cu2O homojunction solar cells were fabricated using potentiostatic electrodeposition technique. n-Cu2O thin films were grown in an acetate bath while p-Cu2O thin films were grown in a lactate bath. In the growth of n-Cu2O films, cupric acetate concentration, pH and temperature of the bath, deposition potential and duration (film thickness) and annealing temperature were investigated. In the growth of p-Cu2O on n-Cu2O, concentration of copper sulphate and lactic acid solutions, pH and temperature of the bath, deposition potential and duration were investigated. In addition, the procedure of sulfidation of p-Cu2O film surface using (NH4)2S vapor, before depositing Au front contact, was also optimized to enhance the photoactive performance. The structural, morphological and optoelectronic properties of the Cu2O films were investigated using scanning electron microscopy (SEMs), high energy X-ray diffraction (HEXRD), hard X-ray photoelectron spectroscopy (HAXPES), spectral response and current–voltage (J-V) measurements. The best Cu2O homojunction solar cell exhibited Voc = 460 mV, Jsc = 12.99 mA·cm−2, FF = 42% and η = 2.51%, under AM 1.5 illumination. Efficiency enhancement with the record high Jsc value for the Cu2O homojunction solar cell has mainly been due to the optimization of pH of the n-Cu2O deposition bath and lactic acid concentration of the p-Cu2O deposition bath.