The prediction of elastic modulus of the mullite fiber network based on the actual structure architecture

Abstract Accurately establishing the relationship between the network architecture characteristics and performance of fibrous porous ceramics is instructive for structural design and performance control. In the present work, fibrous, high porous (82.87–90.02%), low density (0.247–0.512 g/cm 3 ) and low elastic modulus (50.62–188.56 MPa) mullite ceramics were fabricated by freeze casting. The three dimensional network architectures were characterized by X-ray tomography technique and quantitatively analyzed by 3D image analysis software (imorph, www.imorph.fr ). The radius (5.04 µm), types, lengths (64.72–96.49 µm) and orientations (0.87–1.45, anisotropy parameter) of fiber segments in the network architecture were investigated. The extracted results were employed to predict the Young's modulus of the mullite fibrous porous ceramics according to a model based on the bending and axial compression of single fiber segment. The predicted Young's modulus agreed well with the experimental results. The differences of Young's modulus and Poisson ratio between the prediction and the model of Markaki and Clyne were compared. The comparison showed that the difference became larger when the aspect ratio of the fiber segment was less than 6 due to the effect of axial compression. The predicted Poisson ratio had a certain dependence on fiber segment aspect ratio and got close to the constant (1/π) reported by Markaki and Clyne with the increase of fiber segment aspect ratio.