journal article·2009-09

Characterization of Ce0.9Gd0.1O1.95 powders synthesized by spray drying

Peter Blennow, Weiwu Chen, Mats Lundberg, Mohan Menon

Ceramics International· Volume 35· Issue 7
Publisher page

Abstract

Abstract Ce 0.9 Gd 0.1 O 1.95 powders were synthesized by spray drying and successive calcinations. The phase purity, BET surface area, and particle morphology of as-sprayed and calcined powders were characterized. After calcination above 300 °C, the powders were single phase and showed a BET surface area of 68 m 2 /g when calcined at 300 °C. The conductivity, in air, of sintered pellets was measured by electrochemical impedance spectroscopy (EIS) and it was found to be comparable with literature values. The activation energy for the total conductivity was around 0.83 eV. The powder calcined at lower temperature showed better sinterability and higher total conductivity due to an increased bulk conductivity.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electronic and Structural Properties of Oxides · Magnetic and transport properties of perovskites and related materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (22)

Show source-provided references
1. Sol–gel electrochromic coatings and devices: a review10.1016/S0927-0248(00)00369-X ↗
2. Influence of minor additions to Fe–Mn–Al alloys in an oxidizing environment—role of a cerium oxide modified surface on silicon-containing alloys10.1051/jp4:1993930 ↗
3. Synthesis of thermally stable mesoporous cerium oxide with nanocrystalline frameworks using mesoporous silica templates10.1039/B305524H ↗
4. Synthesis and UV-shielding properties of ZnO- and CaO-doped CeO2 via soft solution chemical process10.1016/S0167-2738(02)00715-4 ↗
5. Oxygen gas sensors based on CeO2 thick and thin films10.1016/0925-4005(91)80141-6 ↗
6. Materials for fuel-cell technologies10.1038/35104620 ↗
7. Assessment of doped ceria as electrolyte10.1007/s10008-006-0135-x ↗
8. Internal reforming of methane at Ni/YSZ and Ni/CGO SOFC cermet anodes10.1002/fuce.200600002 ↗
9. Spray-drying ceramic powders10.1111/j.1151-2916.1989.tb06184.x ↗
10. The effect of processing conditions on the properties of spray dried Nd1Ba2Cu3Oy/Ag composite superconductors10.1016/S0955-2219(03)00444-8 ↗
11. Spray drying process for synthesis of nanosized LiMn2O4 cathode10.1007/s10853-006-6129-3 ↗
12. The adsorption of gases on plane surfaces of glass, mica and platinum10.1021/ja02242a004 ↗
13. Reporting physisorption data for gas/solid systems with special reference to the determination of surface area and porosity (Recommendations 1984)10.1351/pac198557040603 ↗
14. Reactive cerium(IV) oxide powders by the homogeneous precipitation method10.1111/j.1151-2916.1993.tb03942.x ↗
15. Reactive 10mol% RE2O3 (RE=Gd and Sm) doped CeO2 nanopowders: synthesis, characterization, and low-temperature sintering into dense ceramics10.1016/j.mseb.2005.03.001 ↗
16. Low-temperature synthesis of 10mol% Gd2O3-doped CeO2 ceramics and its characterization
17. Room temperature co-precipitation of nanocrystalline CeO2 and Ce0.8Gd0.2O1.9−δ powder10.1016/j.matlet.2006.07.152 ↗
18. Combustion synthesis and characterization of nanocrystalline CeO2-based powders10.1021/cm048583p ↗
19. Synthesis and electrical properties of dense Ce0.9Gd0.1O1.95 ceramics10.1111/j.1151-2916.1998.tb02341.x ↗
20. Processing and characterisation of fine crystalline ceria gadolinia–yttria stabilized zirconia powders10.1016/S0955-2219(98)00342-2 ↗
21. Soft-chemistry synthesis, characterization, and stabilization of CGO/Al2O3/Pt nanostructured composite powders10.1111/j.1551-2916.2007.01506.x ↗
22. Development of mass production of Ce0.9Gd0.1O1.95 nanopowder with high-sintering characteristics10.2109/jcersj.113.793 ↗