journal article·2010-03

Structure–conductivity relations of simulated highly porous nanoparticle aggregate films

Norbert Riefler, Lutz Mädler

Journal of Nanoparticle Research· Volume 12· Issue 3
Publisher page

Abstract

Electrical conductivity of porous films composed of nanoparticle aggregates is theoretically evaluated with respect to aggregate structure and film packing density. The aggregates are fractals composed of 5–30 primary particles with diameter of 10 nm. The film properties are derived from simulated boxes in the range of 0.5–1 μm. The electrical conductivity across the films of packing densities ranging from 0.01 to 0.15 was studied. All films prepared by an aerosol deposition technique, which uses nanoparticle aggregates, exhibited percolation behavior between planes parallel to the moving direction of the aggregates. They also followed the classical percolation relation for electrical conductivity while the critical percolation packing density depends on the aggregate size and structure used to build the films. Films using larger aggregates as building blocks have higher electrical conductance than smaller aggregates close to the percolation limit. For validation and supplementary information, two independent models are developed: one model follows the percolation theory to get detailed physical insights and another one computes the exact conductivities but at the cost of some details. This analysis gives new insights into the conduction backbone structures of these films with regard to neck contacts within an aggregate and grain boundary contacts between aggregates. The results shown are important for solar application of these films and especially for gas sensors where high sensitivity is often counteracted by low conductivity.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Gas Sensing Nanomaterials and Sensors · Advanced Chemical Sensor Technologies · Theoretical and Computational Physics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Andrade JS, Auto AM et al (1998) Percolation conduction in vapour grown carbon fibre. Phys A 248(3–4):227–23410.1016/S0378-4371(97)00568-2 ↗
2. Barsan N, Weimar U (2003) Understanding the fundamental principles of metal oxide based gas sensors; the example of CO sensing with SnO2 sensors in the presence of humidity. J Phys Condens Matter 15(20):R813–R83910.1088/0953-8984/15/20/201 ↗
3. Benkstein KD, Kopidakis N et al (2003) Influence of the percolation network geometry on electron transport in dye-sensitized titanium dioxide solar cells. J Phys Chem B 107(31):7759–776710.1021/jp022681l ↗
4. Chen Z, Brokken-Zijp JCM et al (2006) Cross-linked epoxy composites filled with intrinsically conductive phthalocyanine nanocrystals. Influence of filler amount, layer thickness, and cross-linkers used on the percolation threshold and conductivity level of the composites. Macromolecules 39(18):6115–612410.1021/ma052144+ ↗
5. Cormen TH, Leiserson CE et al (1998) Introduction to algorithms. Prentice-Hall, New Delhi
6. Ehrburger-Dolle F, Lahaye J et al (1994) Percolation in carbon-black powders. Carbon 32(7):1363–136810.1016/0008-6223(94)90123-6 ↗
7. Isichenko MB (1992) Percolation, statistical topography, and transport in random-media. Rev Mod Phys 64(4):961–104310.1103/RevModPhys.64.961 ↗
8. Kluppel M (2003) The role of disorder in filler reinforcement of elastomers on various length scales. Filler-reinforced elastomers scanning force microscopy, vol 164. Springer, Berlin, pp 1–8610.1007/b11054 ↗
9. Kulkarni P, Biswas P (2003) Morphology of nanostructured films for environmental applications: simulation of simultaneous sintering and growth. J Nanopart Res 5(3–4):259–26810.1023/A:1025534815540 ↗
10. Mädler L, Kammler HK et al (2002) Controlled synthesis of nanostructured particles by flame spray pyrolysis. J Aerosol Sci 33(2):369–38910.1016/S0021-8502(01)00159-8 ↗
11. Mädler L, Lall AA et al (2006a) One-step aerosol synthesis of nanoparticle agglomerate films: simulation of film porosity and thickness. Nanotechnology 17(19):4783–479510.1088/0957-4484/17/19/001 ↗
12. Mädler L, Roessler A et al (2006b) Direct formation of highly porous gas-sensing films by in situ thermophoretic deposition of flame-made Pt/SnO2 nanoparticles. Sens Actuators B 114(1):283–29510.1016/j.snb.2005.05.014 ↗
13. Mädler L, Sahm T et al (2006c) Sensing low concentrations of CO using flame-spray-made Pt/SnO2 nanoparticles. J Nanopart Res 8(6):783–79610.1007/s11051-005-9029-6 ↗
14. Meier JG, Mani JW et al (2007) Analysis of carbon black networking in elastomers by dielectric spectroscopy. Phys Rev B 75(5):054202:1–054202:10
15. Montes JM, Cuevas FG et al (2005) Electrical conductivity of sintered powder compacts. Powder Metall 48(4):343–34410.1179/174329005X66854 ↗
16. Mueller R, Kammler HK et al (2004) Non-agglomerated dry silica nanoparticles. Powder Technol 140(1–2):40–4810.1016/j.powtec.2004.01.004 ↗
17. Pederson DO (1984) A historical review of circuit simulation. IEEE Trans Circuits Syst 31(1):103–11110.1109/TCS.1984.1085422 ↗
18. Rong W, Ding W et al (2006) Aggregates by combined AFM and SEM: isolated aggregates and networks. Nano Lett 6(12):2646–265510.1021/nl061146k ↗
19. Rothschild A, Komem Y (2004) The effect of grain size on the sensitivity of nanocrystalline metal-oxide gas sensors. J Appl Phys 95(11):6374–638010.1063/1.1728314 ↗
20. Sahm T, Rong W et al (2007) Formation of multilayer films for gas sensing by in situ thermophoretic deposition of nanoparticles from aerosol phase. J Mater Res 22(4):850–85710.1557/jmr.2007.0106 ↗
21. Schulz H, Mädler L, Strobel R, Jossen R, Pratsinis SE, Johannessen T (2005) Independent control of metal cluster and ceramic particle characteristics during one-step synthesis of Pt/TiO2. J Mater Res 20(9):2568–2577. http://dx.doi.org/10.1557/JMR.2005.031910.1557/jmr.2005.0319 ↗
22. Shamala KS, Murthy LCS et al (2004) Studies on tin oxide films prepared by electron beam evaporation and spray pyrolysis methods. Bull Mater Sci 27(3):295–30110.1007/BF02708520 ↗
23. Stauffer D (1979) Scaling theory of percolation clusters. Phys Rep 54(1):1–7410.1016/0370-1573(79)90060-7 ↗
24. Stauffer D, Aharony A (1994) Introduction to percolation theory. Taylor & Francis, Bristol
25. Thimsen E, Biswas P (2007) Nanostructured photoactive films synthesized by a flame aerosol reactor. AIChE J 53(7):1727–173510.1002/aic.11210 ↗
26. Tsantilis S, Pratsinis SE (2004) Soft- and hard-agglomerate aerosols made at high temperatures. Langmuir 20(14):5933–593910.1021/la036389w ↗
27. Wang XD, Yee SS et al (1995) Transition between neck-controlled and grain-boundary-controlled sensitivity of metal-oxide gas sensors. Sens Actuators B 25(1–3):454–45710.1016/0925-4005(94)01395-0 ↗
28. Weber AP, Friedlander SK (1997) In situ determination of the activation energy for restructuring of nanometer aerosol agglomerates. J Aerosol Sci 28(2):179–19210.1016/S0021-8502(96)00062-6 ↗
29. Xu C, Tamaki J et al (1991) Grain-size effects on gas sensitivity of porous SnO2-based elements. Sens Actuators B 3(2):147–15510.1016/0925-4005(91)80207-Z ↗