Trimethylamine sensing properties of nano-SnO2 prepared using microwave heating method

Abstract The precursor was obtained through the reaction between SnCl 4 ·5H 2 O and NaOH in the presence of PEG400 (polyethylene glycol, M = 400). Tin oxide (SnO 2 ) nano-powders were prepared by heating the precursor with microwave method. SnO 2 thick film sensors were fabricated using SnO 2 nano-materials as sensing materials. The phase composition and morphology of the material particles were characterized through X-ray diffraction (XRD) and transmission electron microscopy (TEM), respectively. The average particle sizes of the samples obtained with 616 W microwave heating and 800 W microwave heating (20 min) are about 5 and 15 nm, respectively. The influence of the heating duration and heating power on the gas-sensing properties of sensors based on SnO 2 nano-materials were investigated. The sensitivities of the sensors based on SnO 2 nano-materials heated with 616 and 800 W for 20 min were higher than those of the sensors based on SnO 2 nano-materials heated with 136, 264 and 440 W for 20 min. When operating at 200–310 °C, the sensor based on SnO 2 heated with 616 W for 20 min exhibits highest sensitivities in all sensors based on SnO 2 heated with 616 W for different duration. The sensitivity to a few kinds of organic gases, such as (CH 3 ) 3 N and (CH 3 ) 2 CO were studied. It was found that the sensor based on SnO 2 nano-materials (with 616 W microwave heating for 20 min) exhibited good performance characterized by high sensitivity and short response time to dilute trimethylamine when operated at 255 °C. The sensitivity to 0.001 ppm (CH 3 ) 3 N at 255 °C was 3. The response time and recovery time were about 30 and 100 s, respectively.