Local flow assisted platelet template alignment and corresponding alumina texturing in ceramic stereolithography process
Bibliographic record
Abstract
No abstract is available for this record. The assistant can identify its topic from the title, but cannot infer the study’s results.
Source: Not provided · Quality: missing
Research context
OpenAlex topics: Additive Manufacturing and 3D Printing Technologies · Injection Molding Process and Properties · Nanomaterials and Printing Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (23)
Show source-provided references
1. Preparation, microstructure, and properties of ZrO2 (3Y)/Al2O3 bioceramics for 3D printing of all-ceramic dental implants by vat photopolymerization
2. Research progress of ceramic matrix composite parts based on additive manufacturing technology10.1080/17452759.2019.1607759 ↗
3. Additive Manufacturing and size-dependent mechanical properties of three-dimensional microarchitected, high-temperature ceramic metamaterials10.1557/jmr.2018.11 ↗
4. Photopolymerization-based additive manufacturing of ceramics: a systematic review10.1007/s40145-021-0468-z ↗
5. A review of additive manufacturing for ceramic production10.1108/RPJ-09-2015-0128 ↗
6. Recent advances in the stereolithographic three-dimensional printing of ceramic cores: challenges and prospects10.1016/j.jmst.2021.10.041 ↗
7. Additive manufacturing of hydroxyapatite bioceramic scaffolds with projection based 3D printing
8. Research progress of the defects and innovations of ceramic vat photopolymerization
9. Additive manufacturing of ceramics from liquid feedstocks
10. Processing and mechanical response of highly textured Al2O310.1016/j.jeurceramsoc.2010.02.009 ↗
11. Preparation and anisotropic properties of textured structural ceramics: a review10.1007/s40145-019-0325-5 ↗
12. Additive manufacturing of textured ceramics: a review10.1557/s43578-021-00283-6 ↗
13. Additive manufacturing of highly textured alumina ceramics10.1016/j.oceram.2021.100085 ↗
14. Influence of Al2O3 platelets addition on ceramic slurry and local flow induced platelets alignment in ceramic mask stereolithography process10.1016/j.ceramint.2022.01.190 ↗
15. Influence of the doctor blade shape on tape casting-comparison between analytical, numerical, and experimental results10.1111/jace.14343 ↗
16. Influence of the recoating parameters on resin topography in stereolithography
17. Experimental and numerical analysis on the leading-edge bulge effect during the recoating process in ceramic stereolithography
18. CFD analysis and prediction of suction force during the pulling-up stage of the continuous liquid interface production process
19. Tilting separation analysis of bottom-up mask projection stereolithography based on cohesive zone model10.1016/j.jmatprotec.2016.12.016 ↗
20. Effects of platelet addition and loading direction on the mechanical properties of textured alumina fabricated by ceramic mask stereolithography10.1016/j.ceramint.2023.07.032 ↗
21. A review on the rheological behavior and formulations of ceramic suspensions for vat photopolymerization10.1016/j.ceramint.2021.01.031 ↗
22. Texture development by templated grain growth in liquid‐phase‐sintered α‐alumina10.1111/j.1151-2916.1997.tb02961.x ↗
23. High transmittance and grain-orientated alumina ceramics fabricated by adding fine template particles10.1007/s40145-021-0558-y ↗