Suspension stability and sintering influence on yttria-stabilized zirconia fabricated by colloidal processing

Abstract The stability of nano-zirconia 3YSZ powder in suspension was extensively studied by the colloidal method, and the optimum sintering temperature of the green sample fabricated through slip casting was determined. Zirconia suspensions with 10 vol% powder loading were prepared with distilled water, and HNO 3 was used to adjust the pH of the suspension to pH 1–6. All of the suspensions were subjected to sedimentation test, and the results showed that the suspensions adjusted to pH 2 had the lowest sediment volume. This finding indicates that a suspension with pH 2 produces higher packing density. Viscosity test was carried out for the suspensions added with dispersant ranging from 0.3 wt% to 0.7 wt% polyethyleneimine (PEI) with and without pH adjustment. The suspension containing 0.5 wt% PEI with pH 2 adjustment produced the lowest viscosity because of interparticle bond breakage in the aggregates, thus forming colloidally stable suspensions. The zirconia suspension containing 0.5 wt% PEI and whose pH was adjusted to pH 2 was chosen to be slip casted into cylindrical shape. Green samples were sintered at various sintering temperatures that ranged from 1100 °C to 1500 °C through a two-step sintering method. The sample sintered at 1500 °C was found to be porosite-free, and its highest relative density was 99.6% of the theoretical density. Morphological studies detected pores in the microstructure of the samples sintered at low sintering temperatures (1100 and 1200 °C). By contrast, the samples sintered at 1400 and 1500 °C were fully densified. However, the grain size of the sample sintered at 1500 °C was 230 nm, which indicated excessive grain growth. The Vickers hardness of the sample sintered at 1400 °C was found to be highest (12.9 GPa) and comparable to results found in the literature.