Comparative evaluation investigation of slag corrosion on Al2O3 and MgO-Al2O3 refractories via experiments and thermodynamic simulations

Abstract Al 2 O 3 - and MgO-based refractories are widely used in the steel industry as lining materials for many metallurgical reactors. Due to their direct contact with slag and steel, they suffer corrosion and degradation, especially in the slag-line position, which limits their service performance. The purpose of this article is to obtain a better understanding of the corrosion behavior of the two refractories with different compositions of virtual steelmaking slags (wt%CaO/wt%SiO 2 = 3.0–7.0, Al 2 O 3 : 18–35 wt%) using laboratory experiments and FactSage thermodynamic modeling. Pure Al 2 O 3 and MgO-Al 2 O 3 crucibles were adopted to simulate the two refractories, respectively, during the experiment. The results show that the degree of corrosion of both crucibles increases with an increase in slag basicity and a decrease in Al 2 O 3 content in the slag. The Al 2 O 3 crucible is more susceptible to corrosion than the MgO-Al 2 O 3 crucible, which is attributed to the effect of the slag penetrating through the Al 2 O 3 crucible matrix and substituting part of its matrix. For the MgO-Al 2 O 3 crucible, there was no obvious slag substitution, but a transition layer was found in the contact region between the crucible and the slag. The Al 2 O 3 in the crucible matrix reacts with slag to produce calcium alumina (CaAl 12 O 19 , CaAl 4 O 7 ) and other complex oxides, while the MgO particles at the MgO-Al 2 O 3 crucible-slag interface were only surrounded by liquid slag without an obvious chemical reaction between them. The mechanism of corrosion was studied by experiments combined with thermodynamic calculations and with the establishment of a new corrosion model. This study is expected to provide a guide for the design of related refractories and slags in industrial applications.