Controlled material removal mode and depth of micro cracks in precision grinding of fused silica – A theoretical model and experimental verification

Abstract A critical function for crack propagation for the single grit scratching of fused silica is developed based on the fracture mechanics. The effects of original crack density on the surface, strain rate and grinding coolant are considered in the function. A theoretical model for controlled material removal mode and depth of micro cracks precision grinding is presented based on the critical function for crack propagation. It can be predicted by the model that the material removal mode in the grinding of fused silica with original cracks damage will change from a ductile mode to a semi-brittle mode, a full-brittle mode and a semi-brittle mode in sequence with the increasing single grit scratching depth. It was found that the micro crack damage depth of fused silica does not increase with the single grit scratching depth after a full brittle mode grinding and it is always smaller than that after a semi brittle mode grinding even with a smaller single grit scratching depth. These interesting results are explained by the fracture mechanics. The ductile mode grinding is a recognized desirable process of fabricating fused silica while the full-brittle grinding is also a feasible process for its shallow subsurface damage, high efficiency, low grinding force and energy consumption. Therefore, the depth of micro cracks after grinding can be controlled by choosing suitable grinding parameters. Grinding experiments are conducted on fused silica. The undeformed chip thickness of randomly distributed effective grits is simulated based on 3D reconstruction of wheel topography to reveal the relationship between the grinding parameters and the single grit scratching depth. Ground surface roughness, sub-surface damage (SSD) depth and grinding force are measured and discussed. It is shown that the model predictions correlate well with the experimental trend of grinding modes.