Water-retention properties of porous ceramics prepared from mixtures of allophane and vermiculite for materials to counteract heat island effects

Abstract Porous ceramics for anti-heat island effect were prepared from mixtures of allophane and vermiculite (VA samples). Allophane and vermiculite which had been ground for 0.5–2 h was mixed in various mass ratios, formed into pellets by uniaxial pressing at 40 MPa, and heated at 600–800 °C to form porous ceramics. The large thermal expansion of the vermiculite upon explosive dehydration of interlayer water causes cracking of the pellets with higher vermiculite contents. However, this can be controlled by grinding the vermiculite prior to heating. Grinding the vermiculite for ≥2 h suppresses its expansion, enabling pellet samples with high vermiculite contents to be prepared without cracking. The bulk densities of samples prepared at 800 °C from vermiculite ground for 2 h decrease from 1.72 to 0.94 with increasing allophane content. The pore size distribution in these samples shows a distinct peak at about 1 μm irrespective of the mixing ratio. The number of smaller pores ( W a ) of the samples increases from 37 to 63% with increasing allophane content. This absorption rate is fast enough to absorb >90% of the W a within 1 min for samples of 10 mm O × 5 mm 3 size. By contrast, the release of the absorbed water is very slow, with 50% of the W a retained for ≥30 h in the VA samples at a relative humidity of 55% at 20 °C; this is slower than in pure allophane and much slower than in a reference sample of foamed glass (about 4 h). All these properties make the VA samples useful as water-retaining materials to combat “heat island” effects.