Effect of Cu and Fe addition on electrical properties of Ni–Mn–Co–O NTC thermistor compositions
Source abstract
Abstract
Abstract The effect of addition of Cu and Fe on the electrical properties of Ni–Mn–Co–O based NTC thermistor compositions is studied. Compositions with very low resistivity were prepared by co-doping of very small amounts of Cu along with Co in NiMn 2 O 4 , without affecting the sensitivity very much. Compositions with high resistivity and good sensitivity were achieved by co-doping Fe with Co in NiMn 2 O 4 . The effect of sintering temperature on electrical properties was investigated and it was found that the resistivity and material constant increase with sintering temperature. The reliability characteristics of the compositions were studied by the accelerated thermal aging method. All the compositions exhibited very good reliability.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Electrical and Thermal Properties of Materials · Ferroelectric and Piezoelectric Materials · Dielectric properties of ceramics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (20)
Show source-provided references
1. Microstructural, electrical and reliability aspects of chromium doped Ni–Mn–Fe–O NTC thermistor materials10.1016/j.mseb.2007.12.005 ↗
2. Optimization of process parameters for the production of Ni–Mn–Co–Fe based NTC chip thermistors through tape casting route10.1016/j.jallcom.2011.07.037 ↗
3. Macklen · 1979
4. Reliability and reproducibility of ceramic sensors. I: NTC thermistors
5. Hill · 1986 · 249
6. Ni–Mn–Fe–Cr–O Negative temperature coefficient thermistor compositions: correlation between processing conditions and electrical characteristics10.1007/s10832-008-9489-z ↗
7. Microstructure, crystal structure and electrical properties of Cu0.1Ni0.8Co0.2Mn1.9O4 ceramics obtained at different sintering conditions10.1016/S0925-8388(02)00675-8 ↗
8. Preparation and characterization of Fe3+-doped Ni0.9Co0.8Mn1.3−xFexO4 (0≤x≤0.7) negative temperature coefficient ceramic materials10.1016/j.mee.2011.04.023 ↗
9. Preparation and characterization of spinel type Mn–Ni–Co–O negative temperature coefficient ceramic thermistors10.1023/A:1004351809932 ↗
10. Studies of temperature dependent ac impedance of a negative temperature coefficient Mn–Co–Ni–O thin film thermistor10.1063/1.3596454 ↗
11. The effect of a sintered microstructure on the electrical properties of a Mn–Co–Ni–O thermistor
12. Electrical properties of Ni–Mn–Co–(Fe) oxide thick film NTC thermistors prepared by screen printing10.1023/A:1021900618988 ↗
13. Influence of the composition and the sintering temperature on the electrical resistivities of Ni–Mn–Co–(Fe) oxide NTC thermistors
14. Improvement in the electrical stability of Ni–Mn–Co–O NTC thermistors by substituting Cr2O3 for Co3O410.1016/j.jallcom.2006.07.070 ↗
15. The effect of Zn on the microstructure and electrical properties of Mn1.17−xNi0.93Co0.9ZnxO4 (0≤x≤0.075) NTC thermistors10.1016/j.jallcom.2007.11.105 ↗
16. Controlled coordination and oxidation states of copper and manganese cations in complex nickel–copper–cobalt–manganese oxide thin films10.1116/1.1355361 ↗
17. Preparation and electrical properties of copper–nickel manganite ceramic derived from mixed oxalate10.1016/j.sna.2006.09.005 ↗
18. Mn–Ni–Co–Cu–Zn–O NTC thermistors with high thermal stability for low resistance applications10.1016/j.scriptamat.2007.04.026 ↗
19. Effects of Cu and Zn co-doping on the electrical properties of Ni0.5Mn2.5O4 NTC ceramics10.1016/j.jeurceramsoc.2007.06.007 ↗
20. Electrical conductivity and cation distribution in nickel manganite10.1016/0022-3697(86)90074-0 ↗