Influence of process parameters in gel casting of a pure yttria nanopowder to fabricate transparent ceramics

Abstract The goal of this research is to fabricate pure transparent yttria ceramics through gel casting and vacuum sintering. A specific processing method has been used and optimized for this purpose. A pure yttria nanopowder was synthesized as the starting material to produce pure transparent ceramics through a low-temperature sintering process. It was attempted to minimize the undesirable nanopowder hydration by using the as-synthesized yttria nanopowder and a rapid deagglomeration and slurry preparation process. The synthesized nanopowders were deagglomerated to enhance the efficiency of both powder shaping and sintering stages. Carrageenan was used as the gelling agent because it is a low-cost and abundant material, and because the temperature is the only catalyst needed for its gelation; therefore, it is possible to control its gelation to obtain high-density and pure optical ceramics. The effect of the deagglomeration method and the processing parameters, including the amounts of dispersant, gelling agent, solid loading, pH, and deagglomeration time, on the rheology of slurry, density, and microstructure of the obtained green yttria ceramics was examined and optimized in order to obtain high solid loading nanoyttria suspensions of 38 vol%, which is more than those obtained in many of the previous investigations. The precise gelling temperature and time were measured, and green gel cast ceramics with a density of 63 % of the theoretical density were produced. A rapid deagglomeration and slurry preparation method was used instead of using a conventional planetary ball-milling approach to minimize the risk of the hydrolysis of yttria nanopowder. No sintering aid was necessary, and transparent yttria ceramics with 99 % of the theoretical density were produced after vacuum-furnace sintering at 10-2 mbar and 1715 °C.