Mn-doped Ruddlesden-Popper oxide La1.5Sr0.5NiO4+δ as a novel air electrode material for solid oxide electrolysis cells

Abstract Solid oxide electrolysis cell (SOEC) is a promising electrochemical device with high efficiency for energy conversion and storage. In this work, La1.5Sr0.5Ni1-xMnxO4+δ (LSNMx) (x = 0, 0.1, 0.25, 0.5, 0.75) Ruddlesden-Popper oxides are synthesized via the conventional solid-state method and evaluated as potential air electrodes for SOEC. The effects of substituting Mn for Ni on the crystal structure, oxygen content, thermal expansion behavior, electrical conductivity, and electrochemical performance are comprehensively investigated. XRD results show that the solid-solution concentration of Mn in LSNMx cannot exceed 0.5. The X-ray photoelectron spectroscopy of O1s suggest that Mn doping increases the concentration of oxygen vacancy. The polarization resistance (Rp) of LSNMx (x = 0, 0.1, 0.25, 0.5) exhibits a significantly decreasing tendency with increasing Mn content. LSNM0.5 shows the lowest Rp value of 0.488 Ω cm2 at 800 °C and is reduced by as much as 81.1% in comparison with that of the LSN electrode. A current density of 500 mA cm−2 at 1.4 V is obtained for the LSNM0.5 air electrode with 70% CO2 + 30% CO feed gas on the fuel electrode in a fuel electrode-supported single cell at 800 °C. This current density shows an increase of approximately 85.2% compared with that of the un-doped LSN electrode. The stability test of the half-cell shows that the LSNM0.5 air electrode is relatively stable after anodic polarization at 500 mA cm−2 and 800 °C in air for 145 h. Thus, the Mn-doped LSNM0.5 Ruddlesden-Popper material is a promising air electrode for SOEC.