journal article·2025-07Open access

Instrumentation and experimental hygrothermal investigations of a raw compressed earth brick house in Sense-City equipment: From material to building scale

Julien Waeytens, Myriam Duc, Yan Ulanowski, Laurent Ibos, Thibaut Colinart, Hadi Nasser, Mostafa Mortada, Hamza Allam, Abderrahim Boudenne, Nicolas Dujardin, Kamel Zibouche, Etienne Gourlay, Jean-Pierre Monchau, Fionn McGregor

Abstract

Raw earth is a material of interest in the building sector. It has the advantages of being sustainable, being readily available and having a low-energy manufacturing process. Unfortunately, only a few case studies of instrumented earthen houses exist in the literature. Thus, a raw compressed earth brick (CEB) test house was specifically built and extensively instrumented for research purposes in Sense-City equipment at Champs-sur-Marne, France. A wide variety of sensors were deployed in the walls and in the indoor and outdoor environments for monitoring energy efficiency, hygrothermal behavior and thermal comfort. The CEB was studied from the material scale with chemical and hygrothermal characterization tests to the building scale during different seasons. After the instrumentation and practical techniques for the placement of temperature and humidity sensors in the walls and of heat flux sensors on wall surfaces for long-term monitoring were presented, an experimental analysis of the sensor outputs was carried out. Although the low wall thermal resistance was estimated at 0.34 m 2 .K.W -1 via the ISO 9869-1 standard method, the CEB hygroscopic wall had the abilities to regulate the indoor temperature and humidity and dampen and delay hot outdoor temperatures during summer heat waves. Especially in winter periods, concerning the humidity in walls, we observed different humidity levels depending on wall orientation and height-dependent humidity variation in walls exposed to rain. All the measurement data are provided in the associated data article. • Deployment of 39 sensors in a raw compressed earth brick (CEB) house. • Technique for the placement of temperature and humidity sensors in CEB walls. • Study of energy performance, hygrothermal behavior and thermal comfort in CEB house. • Height-dependent variation of humidity in wall exposed to rain. • Regulation of indoor temp./humidity, attenuation/delay of high outdoor temp.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Hygrothermal properties of building materials · Masonry and Concrete Structural Analysis · Urban Heat Island Mitigation

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (69)

Show source-provided references
1. European Commission · 2020
2. Environment · 2022
3. Double “CE” for construction products: “Circular economy” in “CE marking”
4. Building houses with local materials: means to drastically reduce the environmental impact of construction10.1016/S0360-1323(00)00054-8 ↗
5. Minke · 2006 · vol. 198
6. Energy use and thermal comfort in a rammed earth office building10.1016/j.enbuild.2007.05.013 ↗
7. Hygrothermal behaviour and relative humidity buffering of unfired and hydrated lime-stabilised clay composites in a Mediterranean climate10.1016/j.buildenv.2012.12.006 ↗
8. The moisture buffering capacity of unfired clay masonry10.1016/j.buildenv.2014.09.027 ↗
9. Hygrothermal assessment of a traditional earthen wall in a dry Mediterranean climate10.1080/09613218.2019.1709787 ↗
10. Thermal performance of fired and unfired earth bricks walls
11. Adaptation of rammed earth to modern construction systems: Comparative study of thermal behavior under summer conditions10.1016/j.apenergy.2016.05.010 ↗
12. Improving the thermal performance of earthen walls to satisfy current building regulations10.1016/j.enbuild.2021.110873 ↗
13. C. Jimenez, B. Wieser M., S.T. S. Chung, R.L. Morris, Improving thermal performance of traditional cabins in the high-altitude Peruvian Andean Region, in: Proceedings of the PLEA 2017 Conference – Design to Thrive, 2017.
14. Moisture buffer effect and its impact on indoor environment10.1016/j.proeng.2017.10.417 ↗
15. Intrinsic evaporative cooling by hygroscopic earth materials10.3390/geosciences6030038 ↗
16. Experimental and numerical analysis of the transient hygrothermal behavior of multilayered hemp concrete wall10.1016/j.enbuild.2015.11.027 ↗
17. Hygrothermal performance of lime-hemp wall assemblies10.1177/1744259109355730 ↗
18. Laboratory investigation of hygrothermal monitoring of hemp-concrete walls10.21809/rilemtechlett.2017.36 ↗
19. Effect of coupled heat, air and moisture transfers modeling in the wall on the hygrothermal behavior of buildings10.1016/j.egypro.2015.11.293 ↗
20. Hygrothermal performance of rammed earth wall in Tibetan autonomous prefecture in Sichuan province of China10.1016/j.buildenv.2020.107128 ↗
21. Experimental study on the hygrothermal behavior of a coated sprayed hemp concrete wall10.3390/buildings3010079 ↗
22. Determination of parameters influencing thermal comfort in a building10.11648/j.sjee.20180603.11 ↗
23. A procedure to measure the in-situ hygrothermal behavior of earth walls10.3390/ma7043002 ↗
24. Uncertainty and sensitivity analysis applied to a rammed earth wall: evaluation of the discrepancies between experimental and numerical data10.1051/e3sconf/202017217004 ↗
25. From biobased & geosourced materials to building hygrothermal transfers: a review of modeling, simulation and experiment (accepted)
26. Preventing overheating in offices through thermal inertial properties of compressed earth bricks: A study on a real scale prototype10.1016/j.enbuild.2017.09.070 ↗
27. Thermal assessment of low-cost rural housing—A case study in the Ecuadorian Andes10.3390/buildings6030036 ↗
28. Effect of hygrothermal behaviour of earth brick on indoor environment in a desert climate10.1016/j.scs.2020.102070 ↗
29. Improving the thermal comfort in hot region through the design of walls made of compressed earth blocks: An experimental investigation
30. Monitoring of drying kinetics evolution and hygrothermal properties of new earth-based materials using climatic chamber simulation
31. Passive strategies used in Southern Portugal vernacular rammed earth buildings and their influence in thermal performance10.1016/j.renene.2019.04.098 ↗
32. Evaluation of summer thermal comfort in arid desert areas. Case study: Old adobe building in Adrar (South of Algeria)10.1016/j.buildenv.2021.108140 ↗
33. Measured and simulated thermal behaviour in rammed earth houses in a hot-arid climate. Part B: Comfort10.1016/j.jobe.2017.07.013 ↗
34. Measured and simulated thermal behaviour in rammed earth houses in a hot-arid climate. Part A: Structural behaviour10.1016/j.jobe.2017.11.013 ↗
35. Measurement prototype for fast estimation of building wall thermal resistance under controlled and natural environmental conditions10.1016/j.enbuild.2022.112166 ↗
36. Goal-oriented sensor placement and model updating strategies applied to a real building in the Sense-City equipment under controlled winter and heat wave scenarios10.1016/j.enbuild.2020.110486 ↗
37. Thermal behavior of a two-story concrete building under controlled winter and heat wave scenarios in the sense-city equipment through temperature, flux and energy consumption dataset10.1016/j.dib.2020.106458 ↗
38. Simulation and validation of CFD turbulent airflow at pedestrian level using 3D ultrasonic anemometer in the controlled urban area “Sense-City”10.1016/j.jweia.2021.104801 ↗
39. ZnO nanostructures based innovative photocatalytic road for air purification10.1016/j.jclepro.2021.128447 ↗
40. Smart placement of depolluting panels in urban areas as regards of the airflow using adjoint framework and district digital twin10.1016/j.buildenv.2023.111111 ↗
41. Comparison of cooling grey solutions in the sense-city urban demonstrator for adapting cities to heat waves10.1016/j.uclim.2024.101874 ↗
42. Towards an easy decision tool to assess soil suitability for earth building10.1016/j.conbuildmat.2020.119544 ↗
43. T. Colinart, F. Mc Gregor, M. Duc, L. Le Guen, Y. Ferroukhi, A. Boudenne, Preliminary results of interlaboratory tests on hygrothermal properties of CEB, in: Springer Proceeding of the ICEC conference, 2024.10.1007/978-3-031-62690-6_47 ↗
44. Influence de la terre sur les propriétés physiques de briques de terre crue
45. Dataset of hygrothermal and energy measurements for a raw compressed earth brick house of Sense-City equipment during different seasons10.1016/j.dib.2025.111405 ↗
46. Assessment of fungal development risk on bio-based thermal insulation10.1016/j.indcrop.2024.119889 ↗
47. Hygrothermal performance of a straw bale building: In situ and laboratory investigations10.1016/j.jobe.2016.10.002 ↗
48. Beckett · 2014
49. Measured and simulated thermal behaviour in rammed earth houses in a hot-arid climate. Part A: Structural behaviour10.1016/j.jobe.2017.11.013 ↗
50. Behavior of capacitive humidity sensors in monitoring the drying of concrete walls10.1051/matecconf/201928202053 ↗
51. Hygrothermal performance of natural building materials: Simulations and field monitoring of a case study home made of wood fiber insulation and clay10.1177/17442591231195639 ↗
52. Hygrothermal behaviour of hemp-lime walls: the effect of binder carbonation over time10.1016/j.buildenv.2023.110129 ↗
53. Analysis of the thermal performances of uninsulated and bio-based insulated compressed earth blocks walls: from the material to the wall scale
54. Laboratory investigation of hygrothermal monitoring of hemp-concrete walls10.21809/rilemtechlett.2017.36 ↗
55. Chabriac · 2014
56. Evaluating rammed earth walls: a case study10.1016/j.solener.2003.08.026 ↗
57. Energy evaluation of rammed earth walls using long term in-situ measurements10.1016/j.solener.2016.11.002 ↗
58. 2014
59. 2017
60. Laurent · 1987 · 17
61. Hygrothermal parameters measurement and building performance study of modified rammed earth materials10.1016/j.enbuild.2023.113609 ↗
62. Experimental investigation of hygrothermal properties of raw earth compressed blocks
63. Benchmark of identification methods for the estimation of building wall thermal resistance using active method: numerical study for iwi and single-wall structures10.1016/j.enbuild.2020.110130 ↗
64. Incorporating multi-source uncertainties in fast building wall thermal resistance estimation through physics-based and multi-fidelity statistical learning models
65. Measured and simulated thermal behaviour in rammed earth houses in a hot-arid climate. Part B: Comfort10.1016/j.jobe.2017.07.013 ↗
66. Passive strategies used in Southern Portugal vernacular rammed earth buildings and their influence in thermal performance10.1016/j.renene.2019.04.098 ↗
67. Evaluation of summer thermal comfort in arid desert areas. Case study: Old adobe building in Adrar (South of Algeria)10.1016/j.buildenv.2021.108140 ↗
68. Comfort, climate analysis and building design guidelines10.1016/0378-7788(92)90047-K ↗
69. Kunzel · 1995