Effect of calcined concrete slurry waste on the hardened properties and microstructure of fly ash-based alkali-activated materials
Source abstract
Abstract
Large volumes of concrete slurry waste (CSW), accounting for approximately 0.8% of concrete production in ready-mix plants, are generated and pose notable environmental challenges. To address these issues, this study assesses the potential of utilising CSW as a precursor material in the production of alkali-activated materials (AAMs), as AAMs are recognized for their lower carbon footprint compared to OPC-based materials. In this study, CSW were partially replaced fly ash (FA) at replacement levels ranging from 10 to 50%, followed by activation with sodium hydroxide and sodium silicate. Both uncalcined and calcined CSW (400, 600 and 800 °C) were employed to evaluate the effect of calcination of CSW on the properties of AAMs, specifically compressive strength, water absorption and microstructure. The results demonstrated that calcination of CSW significantly enhanced the compressive strength of AAMs compared to uncalcined CSW. Among the samples, AAMs prepared with CSW calcined at 800 °C achieved the highest compressive strength of 46.9 MPa. A similar trend was observed for water absorption, where AAMs prepared with CSW calcined at 800 °C show a reduction from 24.0 to 20.5% compared to those using uncalcined CSW. The strength enhancement was mainly attributed to the filler effect of calcined CSW, which densified the microstructure by filling voids. This study demonstrates the potential of recycling CSW into AAMs, thereby reducing concrete waste and promoting sustainable construction.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Concrete and Cement Materials Research · Bauxite Residue and Utilization · Tailings Management and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (62)
Show source-provided references
1. Alkali activation of waste concrete powder: effects of alkali type and concentration10.1016/j.ceramint.2023.01.224 ↗
2. Recent advances in the concrete industry to reduce its carbon dioxide emissions
3. Energy and CO2 emission assessments of alkali-activated concrete and Ordinary Portland Cement concrete: a comparative analysis of different grades of concrete
4. Pilot-scale operation of a concrete sludge recycling plant and simultaneous production of calcium carbonate10.1080/00986445.2016.1235564 ↗
5. Management and sustainable utilization of processing wastes from ready-mixed concrete plants in construction: a review10.1016/j.resconrec.2018.04.007 ↗
6. Use of CO2 curing to enhance the properties of cold bonded lightweight aggregates (CBLAs) produced with concrete slurry waste (CSW) and fine incineration bottom ash (IBA)10.1016/j.jhazmat.2019.120951 ↗
7. Recycling of fresh concrete slurry waste as supplementary cementing material: characterization, application and leaching of selected elements10.1016/j.conbuildmat.2021.124061 ↗
8. Innovative reuse of concrete slurry waste from ready-mixed concrete plants in construction products10.1016/j.jhazmat.2016.03.036 ↗
9. Recycling fresh concrete waste: a review10.1002/suco.201800057 ↗
10. Utilization of sludge from ready-mixed concrete plants as a substitute for limestone fillers10.1016/j.conbuildmat.2016.02.044 ↗
11. Reuse of by-products from ready-mixed concrete plants for the production of cement mortars10.13044/j.sdewes.2013.01.0011 ↗
12. New treatment technology: The use of wet-milling concrete slurry waste to substitute cement10.1016/j.jclepro.2019.118347 ↗
13. Geopolymers as an alternative to Portland cement: an overview10.1016/j.conbuildmat.2019.117455 ↗
14. Geopolymers and geopolymeric materials10.1007/BF01904446 ↗
15. Methods to evaluate and quantify the geopolymerization reactivity of waste-derived aluminosilicate precursor in alkali-activated material: a state-of-the-art review10.1016/j.conbuildmat.2022.129784 ↗
16. Basic properties of fly ash/slag-concrete slurry waste geopolymer activated by sodium carbonate and different silicon sources10.3389/fmats.2021.751585 ↗
17. Incorporation of waste glass as an activator in Class-C Fly Ash/GGBS based Alkali activated material10.3390/ma13173906 ↗
18. Study on improving measures of mechanical properties of geopolymer materials and its effect on CO2 emission10.3390/polym15071699 ↗
19. Mechanical strength and permeation properties of high calcium fly ash-based geopolymer containing recycled brick powder
20. Alkali-activated materials and geopolymer: a review of common precursors and activators addressing circular economy10.1007/s43615-021-00029-w ↗
21. Mechanical and micro properties of concrete slurry waste geopolymer under various curing conditions10.1016/j.conbuildmat.2024.136818 ↗
22. The complete recycling of waste concrete to produce geopolymer concrete
23. Production of geopolymeric binder from blended waste concrete powder and fly ash10.1016/j.conbuildmat.2012.04.044 ↗
24. Pre-treatment of reclaimed concrete slurry waste for substituting cementitious materials: Effect of treatment approach and substitution content10.1016/j.jclepro.2022.134987 ↗
25. Study on the calcinations of recycled cement clinker using waste concrete and waste clay brick
26. Influence of elevated temperature on waste concrete powder and its application in alkali activated materials10.1016/j.jclepro.2023.140423 ↗
27. ASTM C618-19 · 2019
28. Effect of wet grinding concrete slurry waste on hydration and hardening properties of cement: micro-nano-scale modification10.3390/ma17123010 ↗
29. Exploitation of industrial solid wastes for preparing zeolite as a value-added product and its kinetics as adsorbent for heavy metal ions10.37190/ppmp/128744 ↗
30. FTIR investigation of the interfacial properties and mechanisms of CO2 sorption in porous ionic liquids10.1016/j.gce.2021.09.003 ↗
31. Role of graphene oxide aerogel support on the cuzno catalytic activity: enhancing methanol selectivity in the hydrogenation reaction of CO210.1002/cctc.202200607 ↗
32. Toniolo · 2019 · 200
33. I. Khan, K. Azizli, S. Sufian, A.A. Siyal, Z. Man, H. Ullah, Sodium silicate free geopolymer as coating material: adhesion to steel, The 1st International Electronic Conference on Materials session Functional Materials and Interfaces for Energy and Sustainable Development, Materials, 2014, http://dx.doi.org/10.3390/ecm-1-b016.10.3390/ecm-1-b016 ↗
34. Technical Feasibility of the Reuse of Dry Concrete Slurry Waste in Concrete Fabrication
35. Characterization, microstructure and properties of fly ash-based geopolymer
36. Fly-ash-based geopolymers: How the addition of recycled glass or red mud waste influences the structural and mechanical properties
37. Thermal and fire resistance of Class F fly ash based geopolymers – A review10.1016/j.conbuildmat.2022.126529 ↗
38. Effect of Si/Al ratio, calcination temperature and post-synthesis phosphorus modification on the textural, structural, acidic, and catalytic properties of amorphous silica-alumina prepared by deposition methods
39. The effect of type and concentration of activators on flowability and compressive strength of natural pozzolan and slag-based geopolymers10.1016/j.conbuildmat.2016.02.086 ↗
40. Influence of Si/Al molar ratio and ca content on the performance of fly ash-based geopolymer incorporating waste glass and GGBFS10.1016/j.conbuildmat.2023.134741 ↗
41. ASTM C642 · 2001
42. Mechanical strength, permeability, and micromechanics of municipal sludge modified with calcium-containing industrial solid waste and powdered construction waste10.3390/w15010091 ↗
43. The effect of natural zeolite on microstructure, mechanical and heavy metals adsorption properties of metakaolin based geopolymers10.1016/j.clay.2016.03.009 ↗
44. Do geopolymers actually contain nanocrystalline zeolites? a reexamination of existing results10.1021/cm050230i ↗
45. Eco-friendly bench-scale zeolitization of an Al-containing waste into gismondine-type zeolite under effluent recycling10.1016/j.jclepro.2017.05.201 ↗
46. Effect of initial curing conditions on the durability performance of low-calcium fly ash-based geopolymer mortars10.1016/j.bsecv.2023.10.006 ↗
47. Experiment and analysis of variance for stabilizing fine-grained soils with cement and sawdust ash as liner materials
48. Synthesis and characterization of red mud and rice husk ash-based geopolymer composites10.1016/j.cemconcomp.2012.11.010 ↗
49. The effect of sodium hydroxide molarity and other parameters on water absorption of geopolymer mortars10.17485/ijst/2016/v9i48/109629 ↗
50. Mechanical properties and durability of volcanic ash based geopolymer mortars10.1016/j.conbuildmat.2016.07.141 ↗
51. Effect of curing temperature on the development of hard structure of metakaolin-based geopolymer10.1016/j.conbuildmat.2009.12.023 ↗
52. Behaviour of fly ash geopolymer binders under exposure to alkaline media10.1007/s42107-019-00144-y ↗
53. Attenuated total reflectance fourier transform infrared analysis of fly ash geopolymer gel aging10.1021/la700713g ↗
54. Effect of synthesis parameters on the quality of construction and demolition wastes (CDW) geopolymers10.1016/j.apt.2014.11.012 ↗
55. Effect of synthesis parameters on the mechanical properties of fly ash-based geopolymers10.1016/j.colsurfa.2006.12.064 ↗
56. Valorization of construction and demolition (C&D) and industrial wastes through alkali activation10.1016/j.conbuildmat.2016.06.051 ↗
57. Mix composition and characterisation of one-part geopolymers with different activators10.1016/j.conbuildmat.2019.07.083 ↗
58. XRD and TG-DTA study of new alkali activated materials based on fly ash with sand and glass powder10.3390/ma13020343 ↗
59. Preparation, performance, and stability of alkali-activated-concrete waste-lead-bearing sludge composites10.1016/j.jclepro.2020.120924 ↗
60. Mechanical performance and phase analysis of an eco-friendly alkali-activated binder made with sludge waste and blast-furnace slag10.1016/j.jclepro.2022.134024 ↗
61. Durability and microstructure of waste slurry based geopolymer concrete10.1016/j.jmrt.2024.12.145 ↗
62. Sustainable application of waste eggshell as fillers in alkali-activated solid waste-based materials: varying treated methods and particle sizes10.1016/j.conbuildmat.2024.136040 ↗