PVA fiber-reinforced seawater sea-sand concrete under seawater freezethaw cycles: Constitutive model and enhancement mechanism
Source abstract
Abstract
Seawater sea-sand concrete (SSC), recognized for its cost-effectiveness and environmental benefits, has attracted growing attention in recent years. Previous studies have indicated that normal-strength SSC undergoes severe surface salt scaling and internal damage under seawater freeze thaw cycles (FTCs). Against this backdrop, the present study investigates the effectiveness of polyvinyl alcohol (PVA) fibers in improving the seawater freeze thaw resistance of normal-strength SSC through a series of physical, mechanical, and microstructural tests. Results demonstrate that the addition of PVA fibers alleviates the degradation in axial compressive strength and modulus of elasticity of SSC subjected to seawater FTCs. This enhancement is ascribed to the capacity of fibers to bear crystallization pressure from growing ice crystals, thereby inhibiting the expansion of capillary pore sizes from 5 to 550 nm to 550–5000 nm. Moreover, fiber incorporation markedly reduced surface salt scaling, which can be attributed to their ability to resist the glue-spall stress imposed on the surface cement paste by cracking sea ice. Based on these results, a PVA fiber content of 0.12 vol% is recommended for optimizing the seawater freeze–thaw resistance of normal-strength SSC. Constitutive models are further developed to support structural design and numerical simulation.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Innovative concrete reinforcement materials · Smart Materials for Construction · Mechanical Behavior of Composites
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (74)
Show source-provided references
1. Use of sea-sand and seawater in concrete construction: current status and future opportunities10.1016/j.conbuildmat.2017.08.130 ↗
2. Porosity, pore size and compressive strength of self compacting concrete using sea water10.1016/j.proeng.2015.11.045 ↗
3. Retrospect and discussion of surveys for construction sand in China offshore area
4. Freeze/thaw durability of concrete with recycled demolition aggregate compared to virgin aggregate concrete10.1016/j.jclepro.2010.09.014 ↗
5. Investigation on early-age hydration, mechanical properties and microstructure of seawater sea sand cement mortar
6. A review on seawater sea-sand concrete: Mixture proportion, hydration, microstructure and properties10.1016/j.conbuildmat.2021.123602 ↗
7. Carbonation of concrete made with dredged marine sand and its effect on chloride binding10.1016/j.conbuildmat.2016.05.011 ↗
8. Effect of metakaolin addition and seawater mixing on the properties and hydration of concrete10.1016/j.clay.2015.06.043 ↗
9. Electrochemical impedance spectroscopy on the hydration behavior of the mortar with marine sand
10. Cyclic compressive behavior of seawater sea-sand concrete after seawater freeze–thaw cycles: Experimental investigation and analytical model10.1016/j.conbuildmat.2022.128227 ↗
11. T.C. Powers, Void spacing as a basis for producing air-entrained concrete, J. Am. Concr. Inst
12. Mechanical properties, chloride resistance and microstructure of Portland fly ash cement concrete containing high volume bagasse ash
13. Correlating frost durability and liquid transport properties of concrete with a modified penetration depth model: Effect of aggregate, water/cementitious ratio, and supplementary cementitious materials
14. Sustainable ultra-high performance concrete with incorporating mineral admixtures: Workability, mechanical property and durability under freeze-thaw cycles
15. Experimental exploration of the waterproofing mechanism of inorganic sodium silicate-based concrete sealers10.1016/j.conbuildmat.2015.12.069 ↗
16. Room temperature conversion of polysilazane to inorganic silicon oxide coating with hydrophobicity for concrete protection10.1016/j.conbuildmat.2025.142406 ↗
17. Effect of hydrophobic surface treatment on freeze-thaw durability of concrete10.1016/j.cemconcomp.2016.03.001 ↗
18. Damage characteristics of hybrid fiber reinforced concrete under the freeze-thaw cycles and compound-salt attack
19. Freeze/thaw durability of concrete with synthetic fibre additions10.1016/j.coldregions.2012.06.006 ↗
20. Study on the mechanism of anti sulfate freeze-thaw, dry wet cycle of polypropylene fiber foam concrete10.1016/j.conbuildmat.2025.140144 ↗
21. Influence of fiber hydrophilic to improve the frost resistance of concrete
22. Behavior of polyvinyl alcohol fiber reinforced geopolymer composites under the coupled attack of sulfate and freeze-thaw in a marine environment10.1016/j.oceaneng.2021.109734 ↗
23. Mechanical and seepage characteristics of polyvinyl alcohol fiber concrete under stress-seepage coupling
24. Frost resistance of polyvinyl alcohol fiber and polypropylene fiber reinforced cementitious composites under freeze thaw cycling10.1016/j.compositesb.2015.12.009 ↗
25. The influence of fiber type and length on the cracking resistance, durability and pore structure of face slab concrete10.1016/j.conbuildmat.2021.122706 ↗
26. Carbon nanofibers and PVA fiber hybrid concrete: Abrasion and impact resistance
27. Degradation mechanism and compressive strength prediction of polyvinyl alcohol fiber-engineered cementitious composites under coupled salt corrosion and freeze-thaw cycles10.1016/j.conbuildmat.2025.143879 ↗
28. Mechanical properties of Nano-Silica and PVA fibers on high-toughness concrete under combined freeze–thaw and sulfate attack: change mechanism of the microstructure10.1007/s41939-025-01022-8 ↗
29. Experimental study on dynamic and static mechanical properties of polyvinyl alcohol fiber cement soil under salt freezing cycle10.1016/j.coldregions.2024.104224 ↗
30. Inspection and Quarantine of the People's Republic of China, Pebble and crushed stone for construction, GB/T 14685-2011, Standards press of China, Beijing, 2011.
31. Salt frost resistance and micro characteristics of polynary blended concrete using in frost areas10.1016/j.coldregions.2021.103374 ↗
32. Comparative study on the effect of synthetic fiber on the preparation and durability of airport pavement concrete10.1016/j.conbuildmat.2018.06.223 ↗
33. Performance Degradation of Fiber-Reinforced Concrete under Freeze–Thaw Cycles and Its Resistance to Chloride Ion Penetration10.1061/(ASCE)MT.1943-5533.0004314 ↗
34. Cyclic Stress-Strain Model for Air-Entrained Recycled Aggregate Concrete after Freezing-and-Thawing Cycles
35. ASTM. 2015. Standard test method for resistance of concrete to rapid freezing and thawing. ASTM C666. West Conshohocken, PA: ASTM.
36. Ministry of Housing and Urban-Rural Development of the People's Republic of China, Standard for test methods of concrete phsical and mechanical properties, GB/T 50081-2019, China Architecture & Building Press, Beijing, 2019.
37. Ministry of Housing and Urban-Rural Development of the People’s Republic of China, Standard for test methods of long-term performance and durability of ordinay concrete, GB/T 50082-2024, China Architecture & Building Press, Beijing, 2024.
38. Bond Durability of GFRP and BFRP Bars embedded in PVA Fiber–Reinforced Seawater and Sea-Sand Concrete under Seawater Freeze–Thaw Cycles10.1061/JCCOF2.CCENG-4591 ↗
39. The occurrence of thaumasite as a product of seawater attack10.1016/S0958-9465(03)00128-8 ↗
40. Thaumasite––direct, woodfordite and other possible formation routes10.1016/S0958-9465(03)00115-X ↗
41. Electromagnetic wave absorption of multifunctional cementitious composites incorporating polyvinyl alcohol (PVA) fibers and fly ash: Effects of microstructure and hydration10.1016/j.cemconres.2021.106389 ↗
42. Stability and reactivity of thaumasite at different pH levels10.1016/S0008-8846(02)00971-7 ↗
43. Long term durability of Portland-limestone cement mortars exposed to magnesium sulfate attack10.1016/S0958-9465(03)00160-4 ↗
44. The formation and role of ettringite in Iowa highway concrete deterioration10.1016/j.cemconres.2004.05.029 ↗
45. Influence of Ca/Si ratio of concrete pore solution on thaumasite formation10.1016/j.conbuildmat.2017.07.104 ↗
46. Chloride-binding capacity of cement-GGBFS-nanosilica composites under seawater chloride-rich environment10.1016/j.conbuildmat.2022.127890 ↗
47. Petrographic characterization of Portlandite crystal sizes in cement pastes affected by different hydration environments10.1016/j.conbuildmat.2018.06.142 ↗
48. Investigation on chloride binding capacity and stability of Friedel's salt in graphene oxide reinforced cement paste10.1016/j.cemconcomp.2022.104603 ↗
49. Effects of accelerated carbonation on the microstructure of Portland cement pastes containing reactive MgO10.1016/j.cemconres.2012.02.017 ↗
50. Nanoscale characterization of engineered cementitious composites (ECC)10.1016/j.cemconres.2010.11.001 ↗
51. Numerical simulation of the freeze–thaw behavior of mortar containing deicing salt solution10.1617/s11527-016-0964-8 ↗
52. Mesoscopic damage model of concrete subjected to freeze-thaw cycles using mercury intrusion porosimetry and differential scanning calorimetry (MIP-DSC)10.1016/j.conbuildmat.2017.04.136 ↗
53. Effects of freeze-thaw damage on the bond behavior of concrete and enhancing measures10.1016/j.conbuildmat.2018.11.041 ↗
54. Characterization of air entraining admixtures in concrete using surface tension measurements10.1016/j.cemconcomp.2017.03.023 ↗
55. Air entraining admixtures: Mechanisms, evaluations, and interactions10.1016/j.cemconres.2021.106557 ↗
56. Sub-distributions of pore size: A new approach to correlate pore structure with permeability10.1016/0008-8846(95)00067-M ↗
57. Investigation on the effect of entrained air on pore structure in hardened concrete using MIP10.1016/j.conbuildmat.2021.123441 ↗
58. New methodology for calculating damage variables evolution in Plastic Damage Model for RC structures10.1016/j.engstruct.2016.11.022 ↗
59. Freezing–thawing durability of fly ash concrete composites containing silica fume and polypropylene fiber
60. Mechanical properties and prediction of fracture parameters of geopolymer/alkali-activated mortar modified with PVA fiber and nano-SiO210.1016/j.ceramint.2020.05.074 ↗
61. Fracture Toughness and Impact Resistance of Fiber-Reinforced Seawater Sea-Sand Concrete10.1061/(ASCE)MT.1943-5533.0004179 ↗
62. D.A. Hordijk, Tensile and tensile fatigue behaviour of concrete: Experiments, modelling and analyses, 1992.
63. F.I.B. FRP reinforcement in RC structures, Technical Report. Bulletin 40. Switzerland, 2007.
64. A · 1990
65. M.R. Jerome, Tensile Strength of Concrete, ACI Journal Proceedings 81(2).
66. Softening of concrete in compression-Localization and size effects10.1016/0008-8846(95)00059-L ↗
67. The composition of standard seawater and the definition of the reference-Composition Salinity Scale10.1016/j.dsr.2007.10.001 ↗
68. A review of salt scaling: I. Phenomenology10.1016/j.cemconres.2007.03.005 ↗
69. Ministry of Housing and Urban-Rural Development of the People's Republic of China, Standard for deisgn of concrete structure durability, GB/T50476-2019, China Architecture & Building Press, Beijing, 2019.
70. ACI. 2019. Building code requirements for structural concrete and commentary. ACI 318-19. Farmington Hills, Michigan.
71. A review of salt scaling: II. Mechanisms10.1016/j.cemconres.2007.03.003 ↗
72. Freezing of air-entrained cement-based materials and specific actions of air-entraining agents10.1016/S0958-9465(02)00099-9 ↗
73. Mechanism for Salt Scaling10.1111/j.1551-2916.2006.00913.x ↗
74. Sea ice: A cast technique to examine and analyze brine pockets and channel structure10.4319/lo.1992.37.1.0179 ↗