Rust inhibition mechanism of reinforced concrete by alcohol-amine corrosion inhibitor under the coupling of composite salt erosion, freeze-thaw cycle and dry-wet cycle
Source abstract
Abstract
The purpose of this study is to propose an efficient and convenient alcohol-amine corrosion inhibitor (ACI) to enhance the durability of reinforced concrete in hostile environments. In this study, reinforced concrete without ACI and with 0.5%, 1.0%, and 1.5% ACI, respectively, were placed into a 10% composite salt solution for coupling test of freeze-thaw cycle and dry-wet cycle. The rust resistance and CSE-FDC resistance of ACI were studied by macroscopic tests (electrochemical impedance spectroscopy (EIS) and dynamic electrode potential curve (DPP), mechanical properties and mass loss), and the influence of ACI on the pore structure of reinforced concrete and the micro-morphology of steel surface was studied by microscopic tests (pore spacing parameters, electron microscope scanning (SEM) and X-ray energy spectrum (EDS)).The findings revealed that the CSE-FDC resistance of reinforced concrete with 0.5%, 1.0% and 1.5% ACI increased by 51.62%, 66.73% and 32.82%, respectively, and the porosity decreased by 50.10%, 69.10%, and 23.57%, respectively, compared with reference specimens. ACI can significantly delay the depassivation of steel by harmful ions and improve the electrochemical properties of steel. When ACI was doped at 1.0%, the R p of the steel reached a peak value of 1034.00 Ω·cm 2 , which was in a low corrosion state, and the rust inhibition efficiency reached a maximum value of 98.05%. ACI was mainly adsorbed on the steel surface by the physicochemical interaction of N atoms and -OH to increase the passivation film resistance, thus increasing the chloride ion threshold and passivation film stability to enhance the corrosion resistance of steel. The application of this research not only offers a new method for inhibiting the corrosion of steel in concrete but also offers theoretical knowledge and technical support for further study on the corrosion resistance of steel under a harsh environment. • ACI inhibitor alleviated deterioration of reinforced concrete. • Composite salt erosion and freeze-thaw-dry-wet cycle coupling are considered. • Electrochemical tests to study the rust inhibition effect. • The pore structure and microstructure of concrete were investigated. • The relation between the rust inhibition effect and dosage of ACI was studied. • Fractal dimension was used to characterize the pore structure change.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Concrete Corrosion and Durability · Corrosion Behavior and Inhibition · Concrete and Cement Materials Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (70)
Show source-provided references
1. The stability of bound chlorides in cement paste with sulfate attack10.1016/j.cemconres.2014.11.010 ↗
2. Properties of concrete incorporating fine recycled aggregates from crushed concrete wastes10.1016/j.conbuildmat.2016.02.154 ↗
3. Corrosion damage of concrete under compound salt immersion-freeze-thaw-dry-wet multifactor
4. Corrosion layer analysis of chloride-induced corrosion of steel reinforcement in concrete
5. Corrosion behavior of steel reinforcing bars under different surface conditions
6. Chemical composition of corrosion products of rebar caused by carbonation and chloride10.1155/2018/7479383 ↗
7. Synthesis and corrosion inhibitory effect of a novel β-amino alcohol com-pound
8. Frontiers in organic corrosion inhibitors for chloride and acidic media: a review10.1007/s40735-022-00638-4 ↗
9. Challenges and opportunities in corrosion of steel in concrete10.1617/s11527-017-1131-6 ↗
10. Recent advances in the use of inhibitors to prevent chlorideinduced corrosion in reinforced concrete10.1016/j.cemconres.2022.106719 ↗
11. Effect of barnacle on the cathodic protection of high-strength steel and its potential risk related to hydrogen permeation10.1016/j.corsci.2024.112178 ↗
12. Recent advances in the use of inhibitors to prevent chloride-induced corrosion in reinforced concrete
13. The stability of bound chlorides in cement paste with sulfate attack10.1016/j.cemconres.2014.11.010 ↗
14. Properties of concrete incorporating fine recycled aggregates from crushed concrete wastes10.1016/j.conbuildmat.2016.02.154 ↗
15. Case study of a driven pile foundation in diatomaceous soil. I: site characterization and engineering properties10.1016/j.jrmge.2020.10.006 ↗
16. Parametric study of hybrid monopile foundation for offshore wind turbines in cohesionless soil10.1016/j.oceaneng.2020.108172 ↗
17. Interactions of N, N′ dimethylaminoethanol with steel surfaces in alkaline and chlorine containing solutions10.1016/S0169-4332(97)00216-X ↗
18. Ramachandran · 1996
19. Aminoalcohol based mixed corrosion inhibitors10.1016/S0958-9465(03)00040-4 ↗
20. Corrosion inhibitors in reinforced concrete structures, part 1: preventative technique10.1179/147842204X2871 ↗
21. Influence of organic corrosion inhibitors on steel corrosion in concrete under the coupled action of freeze–thaw cycles and chloride attack10.1016/j.conbuildmat.2023.130385 ↗
22. Corrosion inhibition efficiency of triethanolammonium dodecylbenzene sulfonate on Q235 carbon steel in simulated concrete pore solution10.1016/j.corsci.2019.108097 ↗
23. GB/T 50082-2024, Standard for test methods of long-term performance and durability of concrete, 2024.
24. GB/T 50081-2019, Standard for test methods of concrete physical and mechanical properties, 2019.
25. Prediction method of permeability of textile-reinforced concrete based on fractal dimension theory10.1016/j.conbuildmat.2022.126868 ↗
26. Mechanisms of whisker-toughened hybrid fiber concrete based on fractal dimension and radar model10.1016/j.conbuildmat.2024.134877 ↗
27. Steel reinforcement corrosion in concrete under combined actions: the role of freeze thaw cycles, chloride ingress, and surface impregnation10.1016/j.conbuildmat.2017.05.078 ↗
28. Influence of freeze-thaw cycles on capillary absorption and chloride penetration into concrete10.1016/j.cemconres.2017.05.018 ↗
29. Using modified nano-silica to prevent bubble Ostwald ripening under low atmospheric pressure: From liquid foam to air-entrained cement mortar10.1016/j.cemconcomp.2022.104627 ↗
30. Poroelastic model for concrete exposed to freezing temperatures10.1016/j.cemconres.2007.06.006 ↗
31. Mechanisms of corrosion control by inhibitors
32. Performance and mechanism of triethanolamine-triisopropanolamine corrosion inhibitor to deterioration of reinforced concrete under the coupling effect of freeze-thaw cycles and chloride attack
33. Fabrication of environmentally friendly Losartan potassium film for corrosion inhibition of mild steel in HCl medium10.1016/j.cej.2020.126863 ↗
34. The effect of simulated concrete pore solution composition and chlorides on the electronic properties of passive films on carbon steel rebar10.1016/j.corsci.2016.01.027 ↗
35. Investigation on the initial atmospheric corrosion of mild steel in a simulated environment of industrial coastland by thin electrical resistance and electrochemical sensors10.1016/j.corsci.2022.110389 ↗
36. Preparation of Mg-Al layered double hydroxides intercalated with nitrite ions and corrosion protection of steel bars in simulated carbonated concrete pore solution,Corrosion
37. Reduction of concrete deterioration by ettringite using crystal growth inhibition techniques
38. Rebar corrosion in coral aggregate concrete: determination of chloride threshold by LPR10.1016/j.corsci.2019.108238 ↗
39. Experimental and theoretical investigation of inhibition behavior of 2-(4-(dimethylamino)benzylidene) amino)benzenethiol for carbon steel in HCl solution10.1016/j.corsci.2021.109376 ↗
40. Performance and deterioration mechanism of concrete incorporated with corrosion-inhibiting admixtures under the coupling effect of composite salt and freeze-thaw cycles
41. Estimation of ice formation in mortar saturated with sodium chloride solutions10.1016/j.conbuildmat.2017.03.073 ↗
42. Experimental study on multi-component corrosion inhibitor for steel bar in chloride environment10.1016/j.conbuildmat.2021.125533 ↗
43. Influence of alkyl chain length of 1, 3-bis dialkylamino-2-propanol on the adsorption and corrosion behavior of steel Q235 in simulated concrete pore solution10.1016/S1452-3981(23)16911-2 ↗
44. A study of organic substances as inhibitors for chloride-induced corrosion in concrete10.1016/j.corsci.2009.08.018 ↗
45. Corrosion behavior of low alloy steel bars containing Cr and Al in coral concrete for ocean construction10.1016/j.conbuildmat.2020.119564 ↗
46. Corrosion monitoring using polarisation resistance measurements: I. Techniques and correlations10.1179/000705976798319937 ↗
47. Coupled effects of sustained compressive loading and freeze-thaw cycles on water penetration into concrete10.1002/suco.201900200 ↗
48. M. Zhang, Y. Long, Inhibition of triethanolamine for magnetic refrigeration material La Fe 11.0 Co 0.7 Si 1.3 in distilled water, in: The 7th National Conference on Functional Materials and Applications. Changsha, China, 2010, p. 1706.
49. Interaction of silicate and aluminate reaction in a synthetic cement system: Implications for the process of alite hydration10.1016/j.cemconres.2016.12.006 ↗
50. Research on cement hydration and hardening with different alkanolamines10.1016/j.conbuildmat.2017.03.010 ↗
51. NMR-based analysis of fractal characteristics of the pore structure of fully aeolian sand concrete under carbonation-dry-wet cycles
52. A micro freeze-thaw damage model of concrete with fractal dimension10.1016/j.conbuildmat.2020.119434 ↗
53. Study of the effect of calcium nitrate, calcium formate, triethanolamine, and triisopropanolamine on compressive strength of Portland-pozzolana cement
54. The effects of organic corrosion inhibitor on concrete properties and frost resistance
55. J. Cai, C.C. Chen, J.Z. Liu, et al., Influence of organic inhibitor on corrosion resistance of steel in simulated concrete pore solution, [C]//4th International Conference on the Durability of Concrete Structures, West Lafayette. USA, (2014) 83-86.10.5703/1288284315386 ↗
56. Influence of freeze-thaw cycles on capillary absorption and chloride penetration into concrete10.1016/j.cemconres.2017.05.018 ↗
57. Synergistic corrosion inhibition of environment-friendly inhibitors on the corrosion of carbon steel in soft water10.1016/j.corsci.2014.11.035 ↗
58. A review on recent patents in corrosion inhibitors10.2174/1877610801002010006 ↗
59. Interaction between sulfate and chloride solution attack of concretes with and without fly ash10.1016/j.cemconres.2007.02.016 ↗
60. Evaluation of interaction effect of sulfate and chloride ions on reinforcements in simulated marine environment using electrochemical methods10.20964/2016.08.51 ↗
61. Effect of temperature on the durability of class C fly ash belite cement in simulated radioactive liquid waste: synergy of chloride and sulphate ions10.1016/j.jhazmat.2008.10.073 ↗
62. Influence of sulfate on the chloride diffusion mechanism in mortar10.1016/j.conbuildmat.2018.11.238 ↗
63. Key inhibitory mechanism of external chloride ions on concrete sulfate attack10.1016/j.conbuildmat.2019.07.263 ↗
64. Effect of sodium monofluorophosphate and phosphates on mechanical properties and water resistance of magnesium oxychloride cement10.1016/j.cemconcomp.2022.104472 ↗
65. A review of inhibitors for the corrosion of transition metals in aqueous acids10.1016/j.molliq.2018.06.014 ↗
66. Electrochemical behaviour of amino alcohol-based inhibitors used to control corrosion of reinforcing steel10.1016/j.electacta.2004.01.041 ↗
67. Organic corrosion inhibitor of triethylenetetramine into chloride contamination concrete by eletro-injection method10.1016/j.conbuildmat.2016.04.076 ↗
68. Corrosion protection of steel with DMEA based organic inhibitor10.1016/j.conbuildmat.2013.03.030 ↗
69. Influence of inhibitors on reinforced bar corrosion coral aggregate seawater concrete
70. Experimental and theoretical studies for corrosion inhibition of carbon steel by imidazoline derivative in 5% NaCl saturated Ca (OH)2 solution10.1016/j.electacta.2011.09.063 ↗