journal article·2021-12Open access

Experimental response of cold-formed steel stud shear wall with hardboard sheathing under seismic loading

Yasser E. Ibrahim, Asif Hameed, Asad Ullah Qazi, Ali Murtaza Rasool, Muhammad Farhan Latif, Mohsin Usman Qureshi

Abstract

In the design of cold-formed steel (CFS) buildings, sheathings are used to provide lateral resistance to seismic or wind load. Many researchers have thoroughly studied the basic behavior of different sheathing (including walls sheathed with plywood, oriented strand board, gypsum wallboard, gypsum sheathing board, steel sheet sheathing, and fiberboard) with different thicknesses. However, despite many studies, the examination of existing experimental studies demonstrates that the lateral bracing and stiffness provided by the sheathing are generally ignored, and sheathing is provided as a non-structural component. This study aims at that neglected aspect. In this study, cold-formed steel shear wall (CFSSW) response has been investigated with varied thickness of hardboard sheathing used as a structural element. The main aim was to determine the contribution of sheathing in resisting lateral forces. For this purpose, three full-scale specimens (i) frame without sheathing, (ii) frame sheathed with 4 mm thick hardboard, (iii) frame sheathed with 10 mm thick hardboard were tested using a uni-directional shake table. The sheathing was screw-fastened to the cold-formed studs and tracked for the development of shear stiffness and strength in the wall system. The test results revealed that in addition to increasing the lateral stiffness of the structure, the hardboard sheathing also acts as an efficient bracing system. However, some minor but recoverable damages were also noticed. In addition, stud local buckling failure mode was observed, and it could be caused by the low anchor stiffness of using cleats instead of hold-downs. It is also important to mention that the number of tests performed in the current study was limited, and further similar research needs to be carried out before generalizing the results.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Structural Load-Bearing Analysis · Structural Engineering and Vibration Analysis · Structural Behavior of Reinforced Concrete

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (36)

Show source-provided references
1. Analysis of building damage during the 8 October 2005 earthquake in Pakistan10.1785/gssrl.79.2.163 ↗
2. AISI S240 · 2020
3. AISI S400 · 2015
4. Yu · 2007 · 1
5. Yu · 2009
6. Rogers · 2011
7. Steel sheathed cold-formed steel framed shear walls subjected to lateral and gravity loading10.1016/j.tws.2013.10.006 ↗
8. Sheathed cold-formed steel studs under axial and lateral load10.1061/(ASCE)ST.1943-541X.0000966 ↗
9. Hysteretic characterization of cold-formed steel stud-to-sheathing connections10.1016/j.jcsr.2014.05.019 ↗
10. Seismic response and engineering of cold-formed steel framed buildings10.1016/j.istruc.2016.05.009 ↗
11. Shear resistance of cold-formed steel framed shear walls with 0.686 mm, 0.762 mm, and 0.838 mm steel sheet sheathing10.1016/j.engstruct.2010.01.029 ↗
12. Cold-formed steel framed gypsum shear walls: in-plane response10.1061/(ASCE)ST.1943-541X.0000521 ↗
13. Velchev · 2010 · Vol. 48 · 846
14. Seismic capacity-based design of narrow strap-braced cold-formed steel walls10.1016/j.jcsr.2015.08.023 ↗
15. Experiments on seismic behaviour of steel sheathed cold-formed steel shear walls cladded by gypsum and fiber cement boards10.1016/j.tws.2016.03.015 ↗
16. Response of CFS Sheathed Shear Walls10.1016/j.istruc.2016.06.009 ↗
17. Seismic response of CFS shear walls sheathed with nailed gypsum panels: experimental tests10.1016/j.tws.2017.08.022 ↗
18. Experimental investigation of seismic behaviour of low dissipative CFS strap-braced stud walls10.1016/j.jcsr.2016.07.027 ↗
19. Seismic design and performance of low energy dissipative CFS strap-braced stud walls10.1007/s10518-018-0465-y ↗
20. Cyclic performance of cold-formed steel shear walls sheathed with double-layer wallboards on both sides10.1016/j.tws.2015.03.005 ↗
21. Reversed cyclic performance of cold-formed steel shear walls with reinforced end studs10.1016/j.jcsr.2015.05.012 ↗
22. Seismic behavior of steel sheathed cold-formed steel shear wall: experimental investigation and numerical modeling10.1016/j.tws.2015.08.024 ↗
23. Performance of light-gauge cold-formed steel strap-braced stud walls subjected to cyclic loading10.1016/j.engstruct.2008.07.016 ↗
24. Dynamic and cyclic response of a full-scale 2-storey cold-formed steel structure with and without infill materials10.1007/s10518-016-0042-1 ↗
25. Seismic response of cold formed steel frames sheathed by Fiber cement boards10.1007/s40999-018-0307-y ↗
26. Earthquake response of cold-formed steel-based building systems: an overview of the current state of the art
27. Bhatta · 2020
28. Sheathing braced design of cold-formed steel structural members subjected to torsional buckling10.1016/j.istruc.2019.04.015 ↗
29. Reliability of cold-formed steel framed shear walls as impacted by variability in fastener response10.1016/j.engstruct.2017.03.072 ↗
30. 2019
31. Development of Chinese light steel construction residential buildings10.5539/jsd.v2n3p134 ↗
32. A653 A · 2020
33. ASCE 7 · 2017
34. Martínez · 2006 · Vol. 140 · 401
35. A simple model for calculating the fundamental period of vibration in steel structures10.1016/j.apcbee.2014.01.060 ↗
36. Computation of fundamental periods for moment frames using a hand-calculated approach10.56748/ejse.9114 ↗