Performance degradation of CO2 cured cement-coal gangue pastes with low-temperature sulfate solution immersion
Source abstract
Abstract
The effect of CO2 curing and coal gangue on sulfate attack of cement paste at low temperature was investigated in this paper. The strength change, mass change and volume deformation were analyzed. In addition, pore structure, phase composition and microscopic morphology were tested by using MIP (mercury intrusion porosimeter), TG-DTA (thermogravimetry differential thermal analysis), QXRD/Rietveld (X-ray diffraction), SEM (scanning electron microscope) measurements to analyze the microscopic mechanism. Results showed that CO2 curing could reduce the compressive strength reduction caused by low-temperature sulfate attack. Compared with the control specimens added with 0%, 10% coal gangue before low-temperature sulfate immersion, the 6 months immersion compressive strength of the corresponding carbonated specimens were still 8.02%, 4.69% higher. The compressive strength of carbonated samples after 6 months of low-temperature sulfate immersion decreased by 7.43~33.16%, which was much lower than that (11.62%~45.17%) of the uncarbonated specimens. In addition, CO2 curing inhibited the volume expansion of specimens during the low-temperature sulfate immersion because of the decrease of porosity and the improvement of pore structure. No typical thaumasite was observed in the CO2 curing specimens after low-temperature sulfate immersion. The strength reduction and the total porosity of specimens after low-temperature sulfate immersion were all lower than those after room temperature sulfate immersion, indicating that sulfate erosion of cement at low-temperature was less serious than that at room temperature. Thus, the combination of CO2 curing and coal gangue recycling offers potential for the production of cementitious materials with better long-term durability and environmental sustainability.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Concrete and Cement Materials Research · Concrete Properties and Behavior · Innovative concrete reinforcement materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (54)
Show source-provided references
1. Ionic liquids can enable the recycling of fluorinated greenhouse gases10.1021/acssuschemeng.9b04214 ↗
2. Cements in the 21st century: challenges, perspectives, and opportunities10.1111/jace.14948 ↗
3. Carbonation curing of cement mortars incorporating carbonated fly ash for performance improvement and CO2 sequestration10.1016/j.jcou.2021.101633 ↗
4. Global CO2 emissions from cement production
5. Carbon dioxide emissions from the global cement industry10.1146/annurev.energy.26.1.303 ↗
6. Performance of concrete with low CO2 emission10.3390/en13174328 ↗
7. Designing climate change mitigation plans that add up10.1021/es400399h ↗
8. New sights in early carbonation of calcium silicates: Performance, mechanism and nanostructure10.1016/j.conbuildmat.2021.125622 ↗
9. Carbon dioxide reduction potential in the global cement industry by 2050
10. Accelerated carbonation curing of cement mortars containing cement kiln dust: An effective way of CO2 sequestration and carbon footprint reduction10.1016/j.jclepro.2018.05.027 ↗
11. Improvement on pozzolanic reactivity of coal gangue by integrated thermal and chemical activation10.1016/j.fuel.2013.03.010 ↗
12. Study on the release characteristics of chlorine in coal gangue under leaching conditions of different pH values10.1016/j.fuel.2017.12.123 ↗
13. Research on cementitious behavior and mechanism of pozzolanic cement with coal gangue10.1016/j.cemconres.2004.11.004 ↗
14. Properties of coal gangue-Portland cement mixture with carbonation10.1016/j.fuel.2019.02.067 ↗
15. Upcycling carbon dioxide to improve mechanical strength of Portland cement10.1016/j.jclepro.2018.06.120 ↗
16. Optimal pre-hydration age for CO2 sequestration through portland cement carbonation
17. Use of carbonation curing to improve mechanical strength and durability of pervious concrete10.1021/acssuschemeng.9b07348 ↗
18. Effect of extended carbonation curing on the properties of γ-C2S compacts and its implications on the multi-step reaction mechanism10.1021/acssuschemeng.1c00200 ↗
19. Accelerated carbonation of reactive magnesium oxide cement (RMC)-based composite with supercritical carbon dioxide (scCO2)10.1016/j.jclepro.2019.119282 ↗
20. Development of a new generation of eco-friendly concrete blocks by accelerated mineral carbonation10.1016/j.jclepro.2016.06.062 ↗
21. Application of neutron imaging to investigate fundamental aspects of durability of cement-based materials: a review10.1016/j.cemconres.2018.03.003 ↗
22. Experimental and theoretical investigation of chloride ingress into concrete exposed to real marine environment10.1016/j.cemconcomp.2022.104511 ↗
23. Application of Ag/AgCl sensor for chloride monitoring of mortar under dry-wet cycles10.3390/s20051394 ↗
24. Deterioration process of high belite cement paste exposed to sulfate attack, calcium leaching and the dual actions10.1016/j.jmrt.2021.09.125 ↗
25. Effect of carbonation curing on sulfate resistance of cement-coal gangue paste10.1016/j.jclepro.2020.123897 ↗
26. Long-term thaumasite sulfate attack on portland-limestone cement concrete: a multi-technique analytical approach for assessing phase assemblage10.1016/j.cemconres.2020.105995 ↗
27. Thaumasite-background and nature in deterioration mortars and concretes10.1016/S0958-9465(97)00076-0 ↗
28. Resistance to thaumasite sulfate attack in BaCO3-bearing cement pastes and mortars10.1016/j.cemconres.2020.106052 ↗
29. Sulfate resistance of limestone cement concrete exposed to combined chloride and sulfate environment at low-temperature10.1016/j.cemconcomp.2012.05.006 ↗
30. Use of mineral admixtures to improve the resistance of limestone cement concrete against thaumasite form of sulfate attack10.1016/j.cemconcomp.2013.01.007 ↗
31. Resistance of concrete containing ggbs to the thaumasite form of sulfate attack10.1016/S0958-9465(03)00149-5 ↗
32. The effects of the thaumasite form of sulfate attack on skin friction at the concrete/clay interface10.1016/j.cemconres.2011.11.009 ↗
33. Sulfate attack on cementitious materials containing limestone filler-A review10.1016/j.cemconres.2008.11.007 ↗
34. Review on carbonation curing of cement-based materials10.1016/j.jcou.2017.07.003 ↗
35. Rietveld quantitative phase analysis of Yeelimite-containing cements10.1016/j.cemconres.2012.03.018 ↗
36. Hydration of Portland cement with additions of calcium sulfoaluminates10.1016/j.cemconres.2012.10.011 ↗
37. Influence of the calcium sulphate source on the hydration mechanism of Portland cement-calcium sulphoaluminate clinker-calcium sulphate binders10.1016/j.cemconcomp.2011.03.005 ↗
38. Effect of temperature curing on properties and hydration of wollastonite blended magnesium potassium phosphate cements10.1016/j.cemconres.2021.106370 ↗
39. Experimental and numerical study of the effects of solution concentration and temperature on concrete under external sulfate attack10.1016/j.cemconres.2020.106284 ↗
40. Thaumasite-ettringite solid solutions in degraded mortars10.1016/j.cemconres.2003.09.016 ↗
41. Utilization of the black tea powder as multifunctional admixture for the hemihydrate gypsum10.1016/j.jclepro.2018.10.304 ↗
42. Does gypsum formation during sulfate attack on concrete lead to expansion?10.1016/S0008-8846(99)00211-2 ↗
43. Effects of gypsum formation on the performance of cement mortars during external sulfate attack10.1016/S0008-8846(02)00955-9 ↗
44. Pore size analyses of cement paste exposed to external sulfate attack and delayed ettringite formation
45. Microstructural changes induced in Portland cement-based materials due to natural and supercritical carbonation10.1007/s10853-008-2521-5 ↗
46. Accelerated carbonation of Portland limestone cement10.1061/(ASCE)MT.1943-5533.0000773 ↗
47. Effects of limestone powder on CaCO3 precipitation in CO2 cured cement pastes10.1016/j.cemconcomp.2016.05.019 ↗
48. Comparison study on the sulfate attack resistivity of cement-based materials modified with nanoSiO2 and conventional SCMs: Mechanical strength and volume stability10.1016/j.conbuildmat.2019.03.235 ↗
49. Microstructural changes in alkali-activated slag mortars induced by accelerated carbonation10.1016/j.cemconres.2017.07.008 ↗
50. Effect of aluminum sulfate alkali-free liquid accelerator with compound alkanol lamine on the hydration processes of Portland cement10.1016/j.conbuildmat.2021.125101 ↗
51. Mechanical performance and microstructure of the calcium carbonate binders produced by carbonating steel slag paste under CO2 curing10.1016/j.cemconres.2016.05.013 ↗
52. Effect of sodium carbonate and sodium phosphate on hydration of cement paste
53. The effects of carbonation and hydration on the mineralogy and microstructure of basic oxygen furnace slag products10.1016/j.jcou.2019.06.001 ↗
54. Comparison on accelerated carbonation of β-C2S, Ca(OH)2, and C4AF: Reaction degree, multi-properties, and products10.1016/j.conbuildmat.2019.07.056 ↗