journal article·2022-06Open access

Mechanical behavior of the asphalt wearing surface on an orthotropic steel bridge deck under cyclic loading

Viet Hai Hoang, Quang Tuan Nguyen, Anh Tuan Tran, Thi Cam Ha Tran, Tu Anh Do

Abstract

Orthotropic steel decks are prone to fatigue problems and to delamination of the wearing surface. In addition, the mechanical behavior of the asphalt wearing surface on an orthotropic steel bridge deck is viscous and affected by the amplitude and frequency of moving loads. This paper presents an experimental investigation on the strain distribution and evolution in an orthotropic deck under cyclic loading. A five-point bending (5PB) test was used in this study. The tested orthotropic deck was composed of a 14-mm-thick steel plate, an epoxy bonding layer, and a 7-cm-thick epoxy asphalt mixture layer. Two types of tests performed at a fixed temperature were: i) cyclic loading with a small number of cycles at different frequencies and loading amplitudes, and ii) fatigue test. The strain was measured at different positions in the steel plate and in the asphalt wearing course. The results obtained from the first type of tests show the strain distribution in the orthotropic deck and the effect of frequency and loading amplitude on this distribution. When the loading amplitude varied from 20 kN to 40 kN, the behavior of the deck structure was observed to be quasi-linear except for several points in the asphalt wearing course where the strain amplitude was higher than 1000 µm/m. The viscoelastic property of the epoxy asphalt concrete was shown to have a significant influence on the deformation of the deck structure. During the fatigue test, the effect of the cyclic loading on the strain evolution in the orthotropic deck was analyzed. The results show that the accumulated strain in the steel plate was small and reversible while that in the asphalt wearing course was important and irreversible, which caused the cracks and damage in the specimen. Fatigue cracking at the top of the asphalt concrete layer and the debonding of the asphalt concrete layer from the steel plate at the support positions were also observed during the fatigue test.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Geotechnical Engineering and Underground Structures

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (32)

Show source-provided references
1. Alternate uses of epoxy asphalt on bridge decks and roadways
2. Experimental study on service performance of epoxy asphalt steel deck pavement of cable stayed bridge
3. Use of epoxy asphalt as surfacing and tack coat material for roadway pavements10.1016/j.conbuildmat.2020.118936 ↗
4. R. Huurman T.O. Medani A. Scarpas C. Kasbergen, The development of a 3D-FEM for the Design of Bridge Surfacings. In 82nd Annual Meeting Transport Research Bord 2003. Washington DC: The National Academies (2003).
5. Effect of pavement design parameters on the behaviour of orthotropic steel bridge deck pavements under traffic loading10.1080/10298436.2013.839790 ↗
6. Modelling of five-point bending beam test for asphalt surfacing system on orthotropic steel deck bridges
7. Characterisation of surfacing materials for orthotropic steel deck bridges. Part 1: experimental work10.1080/10298430902943033 ↗
8. M.S.G. Cullimore I.D. Flett J.W. Smith, Flexure of Steel Bridge Deck Plate with Asphalt Surfacing. IABSE Periodical 1/1983, University of Bristol, pp. 58–83, 1983.
9. Comportement à la Fatigue en Flexion sous Moment Négatif
10. C.T. Metcalf, Flexural Tests of paving Materials for Orthotropic Steel Plate Bridges. Highway Research Record No. 155, Washington, D.C (1967).
11. Simulation of the five-point bending properties for steel bridge deck plate with asphalt surfacing
12. Effect of tack coat failure on the modelling of five-point bending test for orthotropic steel bridge deck and its asphalt surfacing
13. Modeling of viscous bituminous wearing course materials on orthotropic steel deck10.1617/s11527-011-9820-z ↗
14. A five point bending test for asphalt cracking on steel plates
15. From the behavior of constituent materials to the calculation and design of orthotropic bridge structures10.1080/14680629.2010.9690329 ↗
16. S. Teixeira de Freitas, Steel plate reinforcement of orthotropic bridge decks. PhD Dissertation. Delft University of Technology, Delft, 2012.
17. Linear and nonlinear viscoelastic behaviour of bituminous mixtures10.1617/s11527-014-0316-5 ↗
18. 3Dim experimental investigation of linear viscoelastic properties of bituminous mixtures10.1617/s11527-016-0827-3 ↗
19. Effect of fatigue cyclic loading on the linear viscoelastic properties of bituminous mixtures10.1061/(ASCE)MT.1943-5533.0000996 ↗
20. Nonlinearity of bituminous materials for small amplitude cyclic loadings10.1080/14680629.2018.1465452 ↗
21. AASHTO, AASHTO LRFD Bridge Construction Specifications, 6th Edition, 2013 Interim Revisions, 2013.
22. ASTM A709 / A709M – 18, Standard Specification for Structural Steel for Bridges, ASTM International, West Conshohocken, PA, 2018.
23. ASTM D638 – 14, Standard Test Method for Tensile Properties of Plastics, ASTM International, West Conshohocken, PA, 2014.
24. Experimental investigation of fatigue behavior for polymer modified asphalt and epoxy asphalt mixtures
25. AASHTO T 245, Standard Method of Test for Resistance to Plastic Flow of Asphalt Mixtures Using Marshall Apparatus, 2015.
26. AASHTO T 324–19, Method of Test for Hamburg Wheel-track Testing of Compacted Asphalt Mixtures, 2016.
27. ASTM D7460–10, Standard Test Method for Determining Fatigue Failure of Compacted Asphalt Concrete Subjected to Repeated Flexural Bending (Withdrawn 2019), ASTM International, West Conshohocken, PA, 2010.
28. AASHTO TP 62, Standard Method of Test for Determining Dynamic Modulus of Hot Mix Asphalt (HMA), 2011.
29. Mechanical testing of interlayer bonding in asphalt pavements
30. Influence of transient effects for analysis of complex modulus tests on bituminous mixtures10.1080/14680629.2015.1067246 ↗
31. Nonlinearity, heating, fatigue and thixotropy during cyclic loading of asphalt mixtures10.1080/14680629.2011.9690356 ↗
32. 3D complex modulus tests on bituminous mixture with sinusoidal loadings in tension and/or compression10.1617/s11527-016-0970-x ↗