Deleterious tissue reaction to an alkylene bis(dilactoyl)-methacrylate bone adhesive in long-term follow up after screw augmentation in an ovine model
Source abstract
Abstract
Biomaterials are designed to support orthopedic surgeons and once implanted they will help the body to heal itself. In this way one of the most attractive substances are biomaterials that allow gluing of bone fragments and implant fixation. Although no bone adhesive is established for practical use in clinical practice yet, there is evidence in vitro and in vivo that a new class of bone adhesives based on alkylene bis(dilactoyl)-methacrylates may meet the requirements to bridge the gap between bench and bedside. The purpose of this experimental study was to investigate the long-term biocompatibility as well as the integration in the remodeling process of a new polymer of this group of substances that was used for both fragment adaptation and implant fixation in a large-scale animal model. In 24 sheep the lateral tibial condyle was osteotomized and refixed by three cortical screws. In 12 of them overdrilling the bone thread of one screw was performed to simulate the poor mechanical properties of osteoporotic bone and the polymer was used in this setting for screw augmentation, furthermore the osteotomy surface was covered with polymer before osteosynthesis to analyze the influence of the material on bone healing. In the other 12 sheep that served as controls osteosynthesis was performed without a polymer. All animals were permitted to walk immediately after surgery under full weight bearing conditions. Six animals of the polymer group and six animals of the control group were analyzed after 6 weeks and 6 months, respectively. Bone healing and implant integration was evaluated by contact X-rays, histology and histomorphometric quantification. After 6 weeks integrity of the healing bone in the polymer group was preserved as compared to the controls, albeit signs of prolonged aseptic inflammation were observed in the polymer group, which is in line with previous reports. In sharp contrast after 6 months, extensive tissue destruction was observed in all animals of the polymer group that was attributed to a massive foreign body reaction at the histological level. These long-term results suggest that (i) short-term observation not always allow valid conclusions regarding the biocompatibility of biomaterials, (ii) that biocompatibility might vary between species, and (iii) that the polymer used in this setting, although previously attributed to be a good candidate for clinical use in patients, does not meet the necessary criteria and tremendously interferes with the physiology of skeletal repair.
Source: europepmc · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Orthopaedic implants and arthroplasty · Total Knee Arthroplasty Outcomes · Bone fractures and treatments
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. Population demographics and socioeconomic impact of osteoporotic fractures in Canada10.1097/00042192-200310030-00010 ↗
2. Screening for osteoporosis10.7326/0003-4819-112-7-516 ↗
3. Bonding of fractures by plastic adhesives. Preliminary report10.1302/0301-620X.40B4.804 ↗
4. Bioresorbable adhesives in trauma and orthopedic surgery
5. Adhesives in orthopaedic surgery; a review of the literature and in vitro bonding strengths of bone-bonding agents10.1097/00003086-198412000-00034 ↗
6. Tissue and bone adhesives—historical aspects10.1016/S0142-9612(98)00059-3 ↗
7. Introduction to adhesives
8. A modified hip screw incorporating injected cement for the fixation of osteoporotic trochanteric fractures10.1097/00005131-200205000-00004 ↗
9. The use of a resorbable augmentation device to secure plating of osteoporotic bones. An in vitro study10.1007/s002640050154 ↗
10. Extended kyphoplasty indications for stabilization of osteoporotic vertebral compression fractures10.1007/s00113-002-0495-3 ↗
11. Temperature elevation caused by bone cement polymerization during vertebroplasty10.1016/S8756-3282(99)00127-1 ↗
12. Review of the biological response to a novel bone cement containing poly(ethyl methacrylate) and n-butyl methacrylate10.1016/S0142-9612(97)00118-X ↗
13. Noninvasive bone replacement with a new injectable calcium phosphate biomaterial10.1002/jbm.a.10506 ↗
14. Calcium phosphate bone cements: a comprehensive review10.1615/JLongTermEffMedImplants.v13.i1.50 ↗
15. In vivo bone response to porous calcium phosphate cement10.1002/jbm.a.10432 ↗
16. Tibiakopfplateaufrakturen—Erste Erfahrungen mit einem resorbierbaren Knochenzement zur Augmentation10.1007/s00113-002-0463-y ↗
17. Biomechanical behavior of hydroxyapatite as bone substitute material in a loaded implant model. On the surface strain measurement and the maximum compression strength determination of material crash
18. Ceramics in orthopedic surgery
19. Augmentation of femoral neck fracture fixation with an injectable calcium-phosphate bone mineral cement10.1002/jor.1100140516 ↗
20. Pokinskyj · 1999
21. First results with a bioresorbable bone screw
22. Ritter W. Eur pat appl 0086 401 1989 1989. US patent no. 46263101086.
23. A new bioresorbable polymer for screw augmentation in the osteosynthesis of osteoporotic cancellous bone: a biomechanical evaluation10.1002/1097-4636(2001)58:3<254::AID-JBM1014>3.0.CO;2-A ↗
24. Screw fixation in cancellous osteoporotic bone10.1007/s00068-001-1122-7 ↗
25. The tissue response to an alkylene bis(dilactoyl)-methacrylate bone adhesive10.1016/j.biomaterials.2004.04.048 ↗
26. Rescue of the skeletal phenotype of vitamin D receptor-ablated mice in the setting of normal mineral ion homeostasis: formal histomorphometric and biomechanical analyses10.1210/endo.140.11.7110 ↗
27. Thermal aspects of the use of polymethylmethacrylate in large metaphyseal defects in bone. A clinical review and laboratory study
28. Properties of acrylic bone cement: state of the art review10.1002/(SICI)1097-4636(199722)38:2<155::AID-JBM10>3.0.CO;2-C ↗
29. Skeletal repair by in situ formation of the mineral phase of bone10.1126/science.7892603 ↗
30. Tissue adhesives inhibit experimental new bone formation10.1007/BF00186872 ↗
31. Late degradation tissue response to poly(l-lactide) bone plates and screws10.1016/0142-9612(95)91092-D ↗
32. Polymeric debris from absorbable polyglycolide screws and pins. Intraosseous migration studied in rabbits10.3109/17453679209154737 ↗
33. Osteolytic changes accompanying degradation of absorbable fracture fixation implants10.1302/0301-620X.73B4.1649195 ↗
34. Osteoarthritis of the ankle after foreign-body reaction to absorbable pins and screws: a three- to nine-year follow-up study10.1302/0301-620X.80B2.0800333 ↗
35. Biocompatibility and functionality of the degradable polymer alkylene bis(dilactoyl)-methacrylate for screw augmentation in vivo10.1002/jbm.b.30274 ↗